2009 Peugeot 407 Owner's Manual

5
77
Automatic windscreen wipers
Activation REAR WIPER CONTROL(407 SW)
Disarming
Do not cover the rain sensor
located on the windscreen be-
hind the interior mirror.
When using an automatic car
wash to wash your vehicle, switch off
the ignition or check that the wiper
stalk is not in the automatic position.
In winter, it is advisable to wait for the
windscreen to completely clear of ice
before operating the automatic wipe. Automatic rear wiper
If the windscreen wipers control is acti-
vated and you engage reverse gear,
the rear wiper operates in intermittent
mode.

Note: if a bicycle carrier is used,
deactivate this function by
going to the "personalisation-
confi guration" menu on the
multifunction display or install a
special bicycle carrier approved by
PEUGEOT .
Turn the ring to the fi rst notch for inter-
mittent wiping.

The control must be reactivated if
the ignition has been switched off.
To do this, move the control to any
position then return it to the required
position.
Move the control to position
0 then re-
turn it to the AUTO position.
An indicator light comes on on the
instrument panel display, accompanied
by a message on the multifunction
display.
In the AUTO position, the windscreen
wipers operate automatically and
adapt their speed to the intensity of
the rainfall.
Control with automatic wiping only
In the event of malfunction , the
windscreen wipers will operate in in-
termittent mode.
Contact a PEUGEOT dealer to have
the system checked.
Control with Intermittent and automatic wiping
Manual operation of the wiper stalk in-
terrupts the AUTO position, the deac-
tivation indicator light comes on on the
instrument panel display, accompa-
nied by a message on the multifunc-
tion display. Manual operation of the wiper stalk by
moving the lever
A up and returning
it to position "0" interrupts the AUTO
position, the deactivation indicator light
comes on on the instrument panel dis-
play, accompanied by a message on
the multifunction display.

5
77
Automatic windscreen wipers
Activation REAR WIPER CONTROL(407 SW)
Disarming
Do not cover the rain sensor
located on the windscreen be-
hind the interior mirror.
When using an automatic car
wash to wash your vehicle, switch off
the ignition or check that the wiper
stalk is not in the automatic position.
In winter, it is advisable to wait for the
windscreen to completely clear of ice
before operating the automatic wipe. Automatic rear wiper
If the windscreen wipers control is acti-
vated and you engage reverse gear,
the rear wiper operates in intermittent
mode.

Note: if a bicycle carrier is used,
deactivate this function by
going to the "personalisation-
confi guration" menu on the
multifunction display or install a
special bicycle carrier approved by
PEUGEOT .
Turn the ring to the fi rst notch for inter-
mittent wiping.

The control must be reactivated if
the ignition has been switched off.
To do this, move the control to any
position then return it to the required
position.
Move the control to position
0 then re-
turn it to the AUTO position.
An indicator light comes on on the
instrument panel display, accompanied
by a message on the multifunction
display.
In the AUTO position, the windscreen
wipers operate automatically and
adapt their speed to the intensity of
the rainfall.
Control with automatic wiping only
In the event of malfunction , the
windscreen wipers will operate in in-
termittent mode.
Contact a PEUGEOT dealer to have
the system checked.
Control with Intermittent and automatic wiping
Manual operation of the wiper stalk in-
terrupts the AUTO position, the deac-
tivation indicator light comes on on the
instrument panel display, accompa-
nied by a message on the multifunc-
tion display. Manual operation of the wiper stalk by
moving the lever
A up and returning
it to position "0" interrupts the AUTO
position, the deactivation indicator light
comes on on the instrument panel dis-
play, accompanied by a message on
the multifunction display.

5
78
Windscreen and headlamp wash
Pull the windscreen wiper stalk towards
you. The windscreen wash then the
windscreen wipers operate for a fi xed
period.
The headlamp wash is also activated,

if the headlamps are on .
When the minimum level of
the reservoir is reached, this
warning light comes on, ac-
companied by an audible
signal and a message on the
multi-function display.
Next time you stop, fi ll the screenwash/
headlamp wash reservoir.
The warning light comes on each time
the stalk is operated, until the reservoir
is fi lled. FRONT COURTESY LIGHT
The courtesy light can be deactivated
by pressing switch 1 with the door open.
The map reading lights are not affected
by this and may be switched on.

 To re-activate the lights, press the
switch, with the door open.
Screenwash/headlamp wash low

1. Courtesy light

2. Map reading lights
With the key in the ignition on or starting
position, operate the relevant switch.
The front courtesy light comes on
when the ignition key is removed, on
unlocking the vehicle or on opening
one of the doors.
It gradually goes off after the ignition
has been switched on or when the
vehicle is locked.

 Pressing switch 1 turns on the front
courtesy light.
Rear wash-wipe

Note: the rear wiper and rear
wash-wipe functions are de-
activated automatically when
the rear screen is opened.
Turn the ring beyond the fi rst notch,
the wash-wipe then the wiper operate
for a set period of time.

5
78
Windscreen and headlamp wash
Pull the windscreen wiper stalk towards
you. The windscreen wash then the
windscreen wipers operate for a fi xed
period.
The headlamp wash is also activated,

if the headlamps are on .
When the minimum level of
the reservoir is reached, this
warning light comes on, ac-
companied by an audible
signal and a message on the
multi-function display.
Next time you stop, fi ll the screenwash/
headlamp wash reservoir.
The warning light comes on each time
the stalk is operated, until the reservoir
is fi lled. FRONT COURTESY LIGHT
The courtesy light can be deactivated
by pressing switch 1 with the door open.
The map reading lights are not affected
by this and may be switched on.

 To re-activate the lights, press the
switch, with the door open.
Screenwash/headlamp wash low

1. Courtesy light

2. Map reading lights
With the key in the ignition on or starting
position, operate the relevant switch.
The front courtesy light comes on
when the ignition key is removed, on
unlocking the vehicle or on opening
one of the doors.
It gradually goes off after the ignition
has been switched on or when the
vehicle is locked.

 Pressing switch 1 turns on the front
courtesy light.
Rear wash-wipe

Note: the rear wiper and rear
wash-wipe functions are de-
activated automatically when
the rear screen is opened.
Turn the ring beyond the fi rst notch,
the wash-wipe then the wiper operate
for a set period of time.

5
79
REAR COURTESY LIGHT (SALOON) REAR READING LIGHTS (407 SW) Sill illumination
The sill lighting is at the bottom of each
door panel.
The lamps come on automatically
when a door is opened and switch off
automatically when all of the doors are
closed.
Boot light
The boot light is located in the right-
hand boot trim.
It comes on automatically when the
boot is opened and switches off auto-
matically when the boot is closed.

1. Courtesy light

2. Map reading lights
With the key in the ignition on or starting
position, operate the relevant switch.
The rear courtesy light comes on when the
ignition key is removed, on unlocking the
vehicle or on opening one of the doors.
It gradually goes off after the ignition
has been switched on or the vehicle
is locked.

 Pressing switch 1 turns on the rear
courtesy light.
The courtesy light can be deactivated
by pressing switch 1 with the door open.
The map reading lights are not affected
by this and may be switched on.

 To re-activate the lights, press the
switch, with the door open. With the key in the ignition on or starting
position, press the corresponding
switch.
The rear reading lights come on when
the key is removed from the ignition
and when the vehicle is unlocked.
They switch off gradually when the
ignition is switched on or when the
vehicle is locked.

 Pressing switch 1 switches on the
rear reading light concerned for
ten minutes.

6LAYOUT
80
INTERIOR LAYOUT
This is fi tted with a lock.
To open the glove box, lift the handle.
The glove box lights when the lid is
opened.
It is fi tted with three sockets for con-
necting video equipment (vehicle fi tted
with a 16/9 colour screen), a ventilation
nozzle that can be closed by means
of a dial, distributing conditioned air at
the same temperature as the vents of
the passenger compartment.
In cold weather, it is advisable to close
this nozzle to conserve the ambient air
inside the passenger compartment.
The glove box permits access to the
fascia fuse box. To open the compartment, lift the
cover or operate the lever on the left
(according to version).
The storage compartment permits
access to the USB socket and the
storing of CDs and coins.
Rear storage container
Closed storage compartment, driver's side
Door tray
This permits the storing of maps, tour-
ist guides or a bottle of water.
Front ashtray (100 W max)
This is fi tted with a lighter socket or
12 volt socket.
Press the cover to open the ashtray.
To empty the ashtray, after opening,
grip the receptacle and remove it.
Retractable cup/can holder
This is located in front of the front
armnsrest.
Press the cover to open the cup/can
holder.
12 volt accessories socket
(100 W max)
This is a lighter type socket, fi tted with
a cap. It is supplied with current from
the ignition on position.
This permits the storing of small ob-
jects such as keys, a parking badge or
a mobile telephone.
Air conditioned glove box Front armrest
This is located at the back of the front
armrest.
To empty it, open it fully, press the
upper tab then pull to remove it.

6LAYOUT
81
Rear armrest Fitting/removing the mat
Storage compartments
There are two storage compartments
located in the boot side trim.
To gain access to a compartment:

 turn the two screws to the right and
remove the panel.
Access to the ski flap
To prevent the mat from becoming
caught under the pedals:
- only use mats suited to the
fi xings already present in
the vehicle. It is imperative
that these fi xings are used.
- never fi t one mat on top of another.
The rear armrest consists of two com-
partments with a hinged cover.
Storage compartment
1 :

 Lift the cover. Pull the handle down then towards you
to open the fl ap.
When removing the mat on the driver's
side, push the seat as far back as pos-
sible and remove the fi xings.
When refi tting, position the mat
correctly on the pin and clip the
fi xings. Check that the mat is secured
correctly.
Cup holder 2 :

 Fold the second cover forwards.

6LAYOUT
82
BOOT LAYOUT (407 SW)
3. Load space cover
To remove:

 Unclip the front ends and remove
the load space cover.
To install:

 Position the front ends of the load
space cover on its support and
press lightly to put it in place.
1. 12 V accessories socket
(100 W max) and boot light
This is a lighter type 12 volt socket. It
is installed on the rear left trim and is
supplied from the ignition on position.
The boot light is controlled by opening
the tailgate or rear screen.
4. Stowing rings
There are four stowing rings on the boot
fl oor to which the luggage retaining net
can be attached.
2. Storage boxes
There are two side storage boxes
which can contain:
- on the left: a can of oil, a fi rst aid
kit, a puncture repair aerosol,
- on the right (except when a JBL Hi-Fi system is fi tted): a box of
bulbs, a warning triangle (support
provided for this purpose), the lug-
gage retaining net.