2009 Peugeot 407 Owner's Manual

4ACCESS
65

Driving with the doors locked
may make access to the pas-
senger compartment by the
emergency services more
diffi cult in an emergency.

As a safety precaution (with chil-
dren on board), remove the ignition
key when you leave the vehicle,
even for a short time.

Do not repeatedly press the button
of your remote control out of range
and out of sight of your vehicle.
You run the risk of stopping it from
working and the remote control
would have to be reprogrammed.

When purchasing a second-hand ve-
hicle, have the key codes memorised
by a PEUGEOT dealer to ensure that
the keys in your possession are the
only ones which can start the vehicle.

Do not make any modifi cations to
the electronic engine immobiliser
system.
CHILD LOCK
This prevents opening of both of the
rear doors from the inside.
With the ignition on, press the button.
A message appears on the multi-
function display.
This system is independent and does
not, in any circumstances, take the
place of the central locking control.
Electric mode
Always remove the ignition
key when leaving the vehicle,
even for a short time.
It is advisable to check that
the child lock is active each time the
ignition is switched on.
In the event of a serious impact, the
electric child lock is deactivated auto-
matically to permit the exit of the rear
passengers.

4ACCESS
66
ALARM When the alarm is triggered, the siren
sounds and the direction indicator lights
fl ash for approximately thirty seconds.
After triggering, the alarm remains set,
ten times in succession.
On the eleventh time it will become
inactive again, until the next cycle of
disarming then setting of the alarm.

Warning: if button A indicator light
fl ashes rapidly, the alarm has been
triggered while you were away from
your vehicle.

Note: if the alarm has been triggered
in your absence, this fl ashing stops
when the ignition is switched on. Remote control failure,
alarm set

 Unlock the doors with the key and
open the door. The alarm is trig-
gered.

 Switch on the ignition. The alarm is
disarmed.
* According to country.
Setting the alarm

 Switch off the ignition and get out
of the vehicle.

 Set the alarm, by locking or dead-
locking using the remote control
(button A indicator light fl ashes
once per second).
If you wish to lock or deadlock your
vehicle without setting the alarm, lock
it (one turn of the key) or deadlock it
(a second turn within fi ve seconds
maximum) using the lock. Disarming
Unlock the vehicle with the remote
control key.
The alarm is disarmed, indicator light
A
goes out when the ignition is switched on
(unless the alarm has been triggered).
To set the alarm with exterior
protection only
If, while you are away from the vehicle,
you wish to leave a window partially
open or a pet inside the vehicle, you
should choose exterior protection only.

 Switch off the ignition,

 In the next ten seconds, press but-
ton A until the indicator light is on
continuously,

 Get out of the vehicle,

 Set the alarm by locking or dead-
locking using the remote control
(button A indicator light fl ashes
once a second). Incorrect operation
When the ignition is switched on, if
button
A lights for ten seconds, there
is a fault in the siren connection.
Contact a PEUGEOT dealer to have
the system checked.
Automatic activation *
The alarm is activated automatically
two minutes after the last closure of a
door or the boot.
In order to avoid accidental triggering
of the alarm when a door or the boot
is opened, it is essential to press the
unlocking button on the remote control
again.
When the alarm is set, if a door,
the tailgate or the bonnet is
not closed correctly, the siren
is triggered briefl y. If the vehi-
cle is closed correctly within the next
45 seconds, the alarm is set. In all cases,
the alarm is set after 45 seconds.
This provides two types of surveillance:
-
exterior protection: it sounds if
a door, the boot or the bonnet is
opened. - interior protection: it sounds if the
volume inside the passenger compart-
ment changes (breaking of a window
or a movement inside the vehicle).

4ACCESS
67
ELECTRIC WINDOWS
Automatic operation:
To open or close the window, press
or pull switch fully: the window opens
or closes completely when the switch
is released. Pressing the switch again
stops the movement of the window.
The electric window switches remain
operational for approximately one
minute after the key has been removed
from the ignition.
Once this time has elapsed, the electric
windows will not operate. To reactivate
them, switch the ignition on again.
Always remove the key from
the ignition when leaving the
vehicle, even for a short time.
In the event of contact during opera-
tion of the windows, you must reverse
the movement of the window. To do
this, press the switch concerned.
When the driver operates the passen-
ger electric window switches, he must
ensure that no one is preventing cor-
rect closing of the windows.
The driver must ensure that the passen-
gers use the electric windows correctly.
Be aware of children when operating
the windows. REINITIALISATION OFTHE WINDOWS
Following reconnection of the bat-
tery, the safety auto-reverse function
must be reinitialised: the safety auto-
reverse function is not active during
these operations.
- lower the window completely, then raise it, it will rise in steps of a few
centimetres each time the switch is
pressed. Repeat the operation un-
til the window closes completely,
- continue to press the switch for at least one second after reaching
this position, window closed.
Safety auto-reverse
When the window rises and meets an
obstacle, it stops and immediately par-
tially lowers again.
In the event of unwanted opening of the
window on closing, press the switch un-
til the window opens completely, then
pull the switch immediately until the
window closes. Continue to hold the
switch for approximately one second
after the window has closed.
The safety auto-reverse function is not
active during this operation.
Disarming the rear window
controls
For the safety of your children, press
switch 5 to prevent operation of the rear
windows irrespective of their position.
When the button is pressed down, the
switches are disarmed. When the but-
ton is raised, the switches are active.

Manual operation:
To open or close the window, press or
pull the switch gently. The window stops
as soon as the switch is released.

1. Driver's electric window
switch.

2. Passenger's electric window
switch.

3. Rear right electric window
switch.

4. Rear left electric window
switch.

5. Disarming of the rear electric
window switches (child lock).

4ACCESS
68
BOOT (SALOON) TAILGATE AND REAR SCREEN (407 SW) Partial opening of the rear screen
Opening the tailgate and rear
screen

The tailgate and rear screen cannot
be opened at the same time.
With the rear screen closed, to open
the tailgate , operate the handle A ,
then lift the tailgate.
With the tailgate closed, to open the

rear screen , operate the handle B ,
then lift the rear screen.
The lighting is controlled by opening
the tailgate or the rear screen.
If the permanent locking of the
boot is activated, opening is
only possible by pressing the
remote control button.

Notes: the tailgate and rear
screen lock automatically when
driving at 6 mph (10 km/h) and
unlock when one of the doors
is opened.
When the rear wiper is in a wiping
position, the rear screen cannot be
opened until the end of the cycle.
Close the rear screen using the wiper
arm or by pressing the centre of the
glass.
To open the boot, press the push but-
ton and raise the tailgate.
The locking or unlocking of the tailgate
and rear screen is simultaneous with
that of the doors. With the tailgate closed, to partially
open the
rear screen , press and hold
the unlocking button C on the remote
control.

4ACCESS
68
BOOT (SALOON) TAILGATE AND REAR SCREEN (407 SW) Partial opening of the rear screen
Opening the tailgate and rear
screen

The tailgate and rear screen cannot
be opened at the same time.
With the rear screen closed, to open
the tailgate , operate the handle A ,
then lift the tailgate.
With the tailgate closed, to open the

rear screen , operate the handle B ,
then lift the rear screen.
The lighting is controlled by opening
the tailgate or the rear screen.
If the permanent locking of the
boot is activated, opening is
only possible by pressing the
remote control button.

Notes: the tailgate and rear
screen lock automatically when
driving at 6 mph (10 km/h) and
unlock when one of the doors
is opened.
When the rear wiper is in a wiping
position, the rear screen cannot be
opened until the end of the cycle.
Close the rear screen using the wiper
arm or by pressing the centre of the
glass.
To open the boot, press the push but-
ton and raise the tailgate.
The locking or unlocking of the tailgate
and rear screen is simultaneous with
that of the doors. With the tailgate closed, to partially
open the
rear screen , press and hold
the unlocking button C on the remote
control.

4ACCESS
69
"Rear screen open" warning

When the engine is running, if the
rear screen is not fully closed, you are
warned by a message on the multi-
function display.

When the vehicle is moving (speed
greater than 6 mph (10 km/h)), if the
rear screen is not fully closed, you are
warned by an audible signal, a mes-
sage on the multifunction display and
lighting of the service warning light. Tailgate release
This enables the tailgate to be un-
locked in the event of a central locking
fault.
- Fold back the rear seats to gain
access to the lock from inside the
boot,
- Insert a small screwdriver into hole A
of the lock to unlock the tailgate.

4ACCESS
70
Notes:
After reconnecting the battery, you must
reinitialise the safety auto-reverse:
- place the control in the maximum partial opening position (3rd notch
to the right),
- wait until the roof is in the maxi- mum partially open position,
- press the control for at least one second.
In the event of unwanted opening of
the roof on closing (for example, in the
presence of ice), and immediately after
the roof stops:
- move the control to the "O" position and press the control immediately,
- continue to press the control until the roof is fully closed. SUNROOF (SALOON) Always remove the key from
the ignition when leaving the
vehicle, even for a short time.
In the event of contact during
operation of the roof, you must reverse
the movement of the roof. To do this,
press the switch concerned.
When the driver operates the roof
switch, he must ensure that no one is
preventing correct closing of the roof.
The driver must ensure that the pas-
sengers use the sunroof correctly.
Be aware of children when operating
the roof.
- To partially open the roof: Turn the switch to the right (three possible
settings).
- To open the roof completely: Turn the switch to the left (six possible
settings).
- To close it completely: Turn the switch back to position "O".
- Safety auto-reverse: When the sunroof is closing and meets an
obstacle, it stops then partially
opens again.
The sunroof shutter is manual.

4ACCESS
71
Safety auto-reverse
If the shutter encounters an obstacle
during closing, it stops and partially
opens again.
You must reinitialise the safety auto-
reverse within a maximum of fi ve se-
conds after the concealing shutter has
stopped:
- press part A of the control until the
shutter is completely closed (closing
in stages of a few centimetres). PANORAMIC ROOF (407 SW) In the event of contact during
operation of the shutter, you
must reverse its movement.
To do this, press the control
concerned.
When the driver operates the shutter
control, he must ensure that no one
is preventing the shutter from closing
correctly.
The driver must ensure that the pas-
sengers use the concealing shutter
correctly.
Pay attention to children during opera-
tion of the shutter.

Notes
:
Following reconnection of the battery,
in the event of a shutter malfunction
while it is moving or immediately after
it has stopped, you must reinitialise
the safety auto-reverse:
- place the control in the fully open position (position "0"),
- wait until the shutter is in the fully open position,
- press section A of the control for at
least three seconds.
In the event of unwanted opening of
the shutter on closing, and immediately
after the shutter has stopped:
- move the control to the fully closed position (9th setting to the left) then
press part A of the control straight
away,
- continue to press the control until the shutter is fully closed.

The safety auto-reverse function is
not active during these operations.
Your vehicle is fi tted with a tinted glass
panoramic roof which increases the
light and visibility in the passenger com-
partment. Its electric concealing shutter
improves temperature conditions.

The concealing shutter is controlled
electrically by a dial with nine opening
positions.

To close: turn the dial to the left (nine
possible settings).

To open: return the dial to the initial
position "0" .