1999 TOYOTA AVENSIS Supplement

SS038–05
– SERVICE SPECIFICATIONSAIR CONDITIONING
SS–19
AIR CONDITIONING
SERVICE DATA
Refrigerant volume450
50 g (15.87


Drive belt deflection (apply load of 9.8N)–
1CD–FTV New belt11.0 – 13.0 mm (0.43 – 0.51 in.)
Used belt15.0 –18.0 mm (0.59 – 0.71 in.)
Drive belt tension–
1CD–FTV New belt520 – 755 N (53 – 77 kgf)
Used belt196 – 392 N (20 – 40 kgf)

SS050–04
SS–20
– SERVICE SPECIFICATIONSAIR CONDITIONING
TORQUE SPECIFICATION
Part tightenedN·mkgf·cmft·lbf
Compressor x Compressor bracket2525018
Idle pulley lock nut3940029
Compressor x Discharge hose101007
Compressor x Suction hose101007
Pressure plate x Compressor13.21359

DIAGNOSTICS
SUPPLEMENTAL RESTRAINT SYSTEM DI–1. . .
PRE–CHECK DI–1. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DIAGNOSTIC TROUBLE CODE CHART DI–4. . . . . .
PARTS LOCATION DI–5. . . . . . . . . . . . . . . . . . . . . . . . .
TERMINALS OF ECU DI–6. . . . . . . . . . . . . . . . . . . . . .
CIRCUIT INSPECTION DI–8. . . . . . . . . . . . . . . . . . . . .
REFER TO AVENSIS/CORONA REPAIR MANUAL FOR
CHASSIS AND BODY (Pub. No. RM599E)
NOTE: The above pages contain only the points which differ
from the above listed manual.

DI693–01
– DIAGNOSTICSSUPPLEMENTAL RESTRAINT SYSTEM
DI–1
SUPPLEMENTAL RESTRAINT SYSTEM
PRE–CHECK
RELEASE METHOD OF AIRBAG ACTIVATION PREVENTION MECHANISM
An airbag activation prevention mechanism is built into the connector for the squib circuit of the SRS.
When release of the airbag activation prevention mechanism is directed in the troubleshooting procedure,
as shown in the illustration on the following pages, insert paper which has the same thickness as the male
terminal, between the terminal and short spring.
CAUTION:
Never release the airbag activation prevention mechanism on the steering wheel pad connector.
NOTICE:

Do not release the airbag activation prevention mechanism unless specifically directed by the
troubleshooting procedure.

If the inserted paper is too thick the terminal and short spring may be damaged, so always use
paper with the same thickness as the male terminal.

H11822
Airbag Sensor
AssemblySide Airbag Assembly (RH)
(Squib)
Pretensioner (RH)
(Squib)
Side and Curtain Shied
Airbag Sensor (RH)1
2
3
4
5
6
7
89
10
11
12
1314
15Front Airbag Sensor
(RH)
Front Passenger Airbag
Assembly (Squib)
Spiral Cable
Steering Wheel
Pad (Squib)
No.1 J/B
Pretensioner (LH)
(Squib) Front Airbag Sensor
(LH)
Side Airbag Assembly (LH)
(Squib)
16
19
18
17
2021Curtain Shied Airbag
Assembly (RH) (Squib)
Curtain Shied Airbag
Assembly (LH) (Squib)
Side and Curtain Shied
Airbag Sensor (LH) DI–2
– DIAGNOSTICSSUPPLEMENTAL RESTRAINT SYSTEM


 


  


H01358
Airbag Sensor Assembly Connector
Short SpringShort SpringShort Spring
Before ReleaseAfter Release
Connector
Connector
Short SpringShort Spring
Before Release
Paper
After Release
Paper
5821
Connector
Paper
12
3
1019
Short Spring
– DIAGNOSTICSSUPPLEMENTAL RESTRAINT SYSTEM
DI–3

DI694–01
DI–4
– DIAGNOSTICSSUPPLEMENTAL RESTRAINT SYSTEM
DIAGNOSTIC TROUBLE CODE CHART
If a malfunction code is displayed during the DTC check, check the circuit listed for that code in the table
below (Proceed to the page given for that circuit.).
DTC No.
(See Page)Detection ItemTrouble AreaSRS
Warning Light
81
(DI–8)Short in curtain shield airbag (RH) cir-
cuit (to ground)
Curtain shield airbag (RH) (squib)

Airbag sensor assembly

Wire harness
Blink
82
(DI–12)Short in curtain shield airbag (RH) cir-
cuit circuit (to B+)
Curtain shield airbag (RH) (squib)

Airbag sensor assembly

Wire harness
Blink
83
(DI–15)Short in curtain shield airbag (RH) squib
circuit
Curtain shield airbag (RH) (squib)

Airbag sensor assembly

Wire harness
Blink
84
(DI–18)Open in curtain shield airbag (RH) squib
circuit
Curtain shield airbag (RH) (squib)

Airbag sensor assembly

Wire harness
Blink
85
(DI–21)Short in curtain shield airbag (LH) circuit
(to ground)
Curtain shield airbag (LH) (squib)

Airbag sensor assembly

Wire harness
Blink
86
(DI–25)Short in curtain shield airbag (LH) circuit
circuit (to B+)
Curtain shield airbag (LH) (squib)

Airbag sensor assembly

Wire harness
Blink
87
(DI–28)Short in curtain shield airbag (LH) squib
circuit
Curtain shield airbag (LH) (squib)

Airbag sensor assembly

Wire harness
Blink
88
(DI–31)Open in curtain shield airbag (LH) squib
circuit
Curtain shield airbag (LH) (squib)

Airbag sensor assembly

Wire harness
Blink
HINT:

When the SRS warning light remains lit up and the DTC is the normal code, this means a voltage source
drops.
This malfunction is not stored in memory by the airbag sensor assembly and if the power source volt-
age returns to normal, the SRS warning light will automatically go out.

When 2 or more codes are indicated, the codes will be displayed in numeral order starting from the
lowest numbered code.

If a code not listed on the chart is displayed, the airbag sensor assembly is faulty.