1997 RENAULT KANGOO Sheet Metal Work Workshop Manual

LOWER STRUCTURE
Front side member, rear section
41F
12893R3
CAT13321R4
D1
2
CAA11538R5
E
3 2
F
8
CAF11547-2R2
12
3
41-23

LOWER STRUCTURE
Front side member, rear section
41F
12904R1
CAT13329-1R8
G6
5
CAE11546-2R8
H
6
4
8
13020R
CAA11538R5
I
8 2
CAA11538-2aR8
J
8
4 4
8
41-24

LOWER STRUCTURE
Front side member, rear section
41F
12897R
CAF11547-2R23
K7 2
3
CAA11538R5
L
3 2
41-25

LOWER STRUCTURE
Front mounting of sub-frame
41G
PRB4127
INTRODUCTION
The replacement of this part is a basic operation
for a sub-frame impact .
In the operation described below, there are only
descriptions of the joints specific to the part
concerned.
Information concerning the other parts will be
dealt with in the respective sections.
The repair bench must be used.
COMPOSITION OF THE PART FROM THE PARTS
DEPARTMENT
Part assembled with sub-frame front mounting
reinforcement.
JOINTS WITH:
Front side member, front section
Front side member closure panel
Bonnet hinge mounting
PARTS CONCERNED (thickness in mm):
1Front side member, front section 1.5
2Front mounting of front sub-frame 1.2
3Side member closure panel 1.2
4Front mounting reinforcement of
front sub-frame 1
5Bonnet hinge mounting 1.5
41-26

LOWER STRUCTURE
Front mounting of sub-frame
41G
12901R
CAR11700R4
A
5
2
CAA11536R5
B
1
2
CAA11538R6
C
1
4
1
21
2
CAT13322-1R4
D
31
4
41-27

LOWER STRUCTURE
Front mounting of sub-frame
41G
12903R4
CAU13323-3R3
E
3
2
CAB11539R1
F
43
4
41-28

LOWER STRUCTURE
Sill panel closure panel
41H
PRB4128
INTRODUCTION
The replacement of this part is an operation for a
side impact and is complementary to:
1 - For a frontal side impact :
the front pillar
Replace part section along cut A (see follo-
wing diagram)
2 - For a rear side impact :
the side panel lining
the centre pillar reinforcement
the sill panel
Replace part section along cut A (see follo-
wing diagram)
In the operation described below, there are only
descriptions of the joints specific to the part
concerned.
Information concerning the other parts will be
dealt with in the respective sections.
The sill panel reinforcement must be ordered as
an extra .
COMPOSITION OF THE PART FROM THE PARTS
DEPARTMENT
1 - Sill panel closure panel
2 - Sill panel reinforcement
JOINTS WITH:
Front pillar lining
Side floor
Seat cross member
Rear side member
Rear floor, rear section
PARTS CONCERNED (thickness in mm):
1Sill panel closure panel 1.2
2Cowl side panel pillar lining 1
3Side floor 0.8
4Front seat cross member 1
5Sill panel closure panel , rear section 1.5
6Front side cross member 1
7Sill panel 0.8
or
41-29

LOWER STRUCTURE
Sill panel closure panel
41H
12898R
CAT13326R2
A
67
13015R1
CAA11537-1R3
B
1 2 1
41-30