UPPER FRONT STRUCTURE
Cowl side panel (pillar lining), part section
42C
PRB4210
INTRODUCTION
The replacement of this part is a complementary
operation for a frontal impact to a headlight car-
rier panel.
It will be partially replaced according to the cut on
the diagram and the method below.
The replacement of this part also requires the re-
placement of the cowl side panel upper reinforce-
ments.
In the operation described below there are only
descriptions of joints specific to the part concer-
ned.
COMPOSITION OF THE PART FROM THE PARTS
DEPARTMENT
1 - Cowl side panel , part assembled with :
- front wing mounting,
- impact retainer reinforcement (bonnet),
- dashboard mounting support,
- shock absorber cup height adjuster reinforce-
ment .
2 - Cowl side panel upper reinforcement, front
section.
3 - Cowl side panel upper reinforcement, rear
section.
JOINTS WITH :
Engine support plate
Shock absorber cup
Plenum chamber
PARTS CONCERNED (thickness in mm):
1Cowl side panel (pillar lining) 1.5
2Engine support plate 2
3Shock absorber cup 2
4Plenum chamber 1
5 Shock absorber cup height adjuster 1or
42-5
UPPER SIDE STRUCTURE
Front pillar lining / Cowl side panel
43C
PRB4313
INTRODUCTION
The replacement of this part is a complementary
operation to the front pillar with reinforcement
of cowl side panel for a front side impact.
The cowl side panel reinforcement must be orde-
red separately.
In the operation described below there are only
descriptions of the joints specific to the part
concerned.
Information concerning other parts will be dealt
with in the respective section.
COMPOSITION OF THE PART FROM THE PARTS
DEPARTMENT
Part assembled with dashboard mounting reinfor-
cement.
JOINTS WITH:
Windscreen wiper mounting
Bulkhead
Sill panel closure panel
Plenum chamber
Windscreen wiper connecting bracket
PARTS CONCERNED (thickness in mm) :
1Cowl side panel / front pillar lining
2Windscreen wiper mounting
3Bulkhead
4Sill panel closure panel
5Plenum chamber
or
43-9
