1997 Mercury Villager Owner's Manuals

284
[MC16500(ALL)01/96]6.
Carefully pull the dipstick out again. If the oil level is below
the ªLº line, add engine oil as necessary. If the oil level is
beyond the letter ªH,º engine damage or high oil
consumption may occur and some oil must be removed from
the engine.
*
[MC16600(ALL)01/96]7.
Put the dipstick back in and make sure it is fully seated.
%*
[MC16650(ALL)01/96
]
Adding engine oil
*
[MC16700(ALL)01/96]
It may be necessary to add some oil between oil changes. Make
sure you use a CERTIFIED engine oil of the preferred viscosity.
Your vehicle's warranty coverage may not apply if engine
damage is caused by the use of improper engine oil.
*
[MC16800(ALL)01/96]
Add engine oil through the oil filler cap highlighted in yellow.
To add oil, remove the filler cap and use a funnel to pour oil
into the opening. Be careful not to overfill the engine. Recheck
the oil level after you finish adding oil.
%*
[MC16900(ALL)01/96
]
Changing the Engine Oil and the Oil Filter
*
[MC17200(ALL)05/96]
Refer to theMaintenance Schedulebooklet for additional
information.
[MC17300(ALL)04/96]
Follow these directions to change the engine oil and oil filter:
[MC17400(ALL)04/96]1.
Turn the engine off after it has warmed up.
[MC17500(ALL)04/96]2.
Protect yourself from engine heat and the engine oil being
drained.
[MC17600(ALL)04/96]3.
Remove the oil pan drain plug(s)andoil filter.
[MC17700(ALL)04/96]4.
Drain the oil into a container until flow from the drain plug
hole(s) and the filter mounting area slows to a drip.
[MC17800(ALL)04/96]5.
Install the drain plug(s) and a new engine oil filter according
to directions on the package.
File:11vxmcn.ex
Update:Mon Jun 10 15:17:05 1996

Maintenance and Care
285
*
[MC17900(ALL)03/96]
NOTE: SeeRefill Capacities, Motorcraft Parts and Lubrication
Specificationsin theCapacities and Specificationschapter
for the appropriate oil filter and engine oil refill
quantity.
[MC18000(ALL)04/96]6.
Remove the engine oil dipstick (highlighted in yellow) to
prevent oil contamination of the engine ventilating system
while refilling.
[MC18100(ALL)04/96]7.
Refill the engine with a CERTIFIED engine oil of the
preferred viscosity. Start the engine and check for leaks.
Follow directions inChecking and adding engine oilto be sure
the engine is filled to the proper level.
*
[MC18150(ALL)01/96]
RWARNING
Continuous contact with USED motor oil has caused
cancer in laboratory mice.
*
[MC18200(ALL)01/96]
Protect your skin by washing with soap and water.
%*
[MC18220(ALL)05/96]
Brake Fluid
*
[MC18240(ALL)01/96]
Your vehicle is equipped with a brake fluid level indicator in
the master cylinder which lights the BRAKE warning light on
the instrument panel when the brake fluid level is low.
*
[MC18260(ALL)01/96]
Under normal circumstances, your vehicle should not use up
brake fluid rapidly. However, expect the level of the brake fluid
to slowly fall as you put more mileage on your vehicle and the
brake pads wear.
*
[MC18280(ALL)01/96]
Check the brake fluid at least once a year. You can do this by
looking at the fluid level in the plastic brake fluid reservoir on
the master cylinder. The fluid level should be at or near the
MAX mark.
*
[MC18300(ALL)01/96]
RWARNING
Brake fluid is toxic.
File:11vxmcn.ex
Update:Mon Jun 10 15:17:05 1996

286
*
[MC18320(ALL)01/96]
If brake fluid contacts eyes, flush eyes with running water for
15 minutes. Get medical attention if irritation persists. If taken
internally, drink water and induce vomiting. Get medical
attention immediately.
%*
[MC18340(ALL)03/96
]
If the fluid is low, carefully clean and remove the filler cap
from the reservoir. Fill the reservoir to the MAX line with Ford
High Performance DOT 3 Brake Fluid C6AZ-19542-AB or DOT 3
equivalent fluid meeting Ford specification ESA-M6C25-A.
*
[MC18360(ALL)01/96]
RWARNING
If you use a brake fluid that is not DOT 3, you will
cause permanent damage to your brakes.
*
[MC18380(ALL)01/96]
Do not fill the reservoir above the MAX line.
*
[MC18400(ALL)01/96]
If you find that the fluid level is excessively low Ð below the
seam or ridge on the outside of the plastic reservoir Ð have the
brake system inspected.
*
[MC18420(ALL)01/96]
RWARNING
Do not let the reservoir for the master cylinder run dry.
This may cause the brakes to fail.
File:11vxmcn.ex
Update:Mon Jun 10 15:17:05 1996

Maintenance and Care
287
[MC18423(ALL)01/96]
13-1/2 pica
art:0040205-C
Brake fluid master cylinder reservoir
%*
[MC18425(ALL)02/96]
Windshield Washer Fluid
[MC18435(ALL)01/96]
Check the level of the windshield washer fluid every time you
stop for fuel, or when the warning light indicates low washer
fluid. The reservoir for washer fluid is located in the engine
compartment. This reservoir contains the fluid for both the
windshield and liftgate washers.
*
[MC18440(ALL)01/96]
RWARNING
Do not put windshield washer fluid in the container for
the engine coolant.
*
[MC18445(ALL)05/96]
If sprayed to clean the glass, engine coolant or antifreeze could
make it difficult to see through the windshield.
File:11vxmcn.ex
Update:Mon Jun 10 15:17:05 1996

288
[MC18450(ALL)01/96]
17-1/2 pica
art:0040198-B
Windshield washer fluid reservoir
%*
[MC18452(ALL)02/96
]
Use specially formulated windshield washer fluid rather than
plain water, because specially formulated washer fluids contain
additives that dissolve road grime. For safety reasons, washer
fluids containing an appropriate antifreeze such as methanol
should be used in freezing weather (temperatures below32ÊF
[0ÊC]). State or local regulations on Volatile Organic Compounds
(VOCs) may restrict use of the most common antifreeze,
methanol. Washer fluids containing non-methanol antifreeze
agents should be used only if they provide cold weather
protection without damaging the vehicle's paint finish, wiper
blades, and windshield washer system.
File:11vxmcn.ex
Update:Mon Jun 10 15:17:05 1996

Maintenance and Care
289
%*
[MC18475(ALL)01/96]
Engine Coolant
%*
[MC18500(ALL)01/96
]
Checking the Engine Coolant
*
[MC18550(ALL)05/96]
NOTE: Be sure to read and understandPrecautions When
Servicing Your Vehicleat the beginning of this chapter.
[MC18600(ALL)03/96]
Your vehicle's engine coolant protects the engine from
overheating in the summer and from freezing in the winter.
Check the level of the engine coolant at least once a month, but
preferably each time you stop for fuel. Simply check the coolant
reservoir, located in the engine compartment. The coolant
should stay between the MIN and MAX marks. It will be closer
to MAX when the engine is warm and closer to MIN when the
engine is cold. To locate the coolant reservoir, see the diagram
of your vehicle's engine underEngine Compartmentin the
Capacities and Specificationschapter.
File:11vxmcn.ex
Update:Mon Jun 10 15:17:05 1996

290
*
[MC18700(ALL)05/96]
Adding Engine Coolant
[MC18800(ALL)01/96]
17-1/2 pica
art:0040197-C
Engine coolant recovery reservoir
*
[MC18900(ALL)05/96]
RWARNING
Do not put engine coolant in the container for the
windshield washer fluid.
*
[MC19000(ALL)05/96]
When the engine is cool, add a 50/50 mixture of engine coolant
and water to the engine coolant recovery reservoir Ð DO NOT
ADD DIRECTLY TO THE RADIATOR. Add straight water only
in an emergency, but you should replace it with a 50/50
mixture of coolant and distilled water as soon as possible.
*
[MC19025(ALL)05/96]
Check the coolant level in the coolant recovery reservoir the
next few times you drive the vehicle. If necessary, add enough
of a 50/50 mixture of coolant and water to bring the liquid
level to the fill line on the reservoir.
File:11vxmcn.ex
Update:Mon Jun 10 15:17:05 1996

Maintenance and Care
291
*
[MC19100(ALL)05/96]
RWARNING
Never remove the coolant recovery cap while the engine
is running or hot.
*
[MC19200(ALL)05/96]
If you must remove the coolant recovery cap, follow these steps
to avoid personal injury caused by escaping steam or engine
coolant:
*
[MC19225(ALL)05/96]1.
Before you remove the cap, turn the engine off and let it
cool.
*
[MC19250(ALL)05/96]2.
When the engine is cool, wrap a thick cloth around the cap.
Slowly turn cap counterclockwise to the first stop.
*
[MC19275(ALL)05/96]3.
Step back while the pressure releases.
*
[MC19280(ALL)05/96]4.
When you are sure that all the pressure has been released,
use the cloth to press the cap down, turn it counterclockwise,
and remove it.
[MC19300(ALL)05/96]
Use Ford Premium Engine Coolant E2FZ-19549-AA (in Canada,
Motorcraft CXC-8-B) or an equivalent premium engine coolant
that meets Ford Specification ESE-M97B44-A. Ford Premium
Engine Coolant is an optimized formula that will protect all
metals and rubber elastomers used in Ford cooling systems for 4
years or 50,000 miles (80,000 km).
*
[MC19400(ALL)05/96]
Do not use alcohol or methanol antifreeze or any engine
coolants mixed with alcohol or methanol antifreeze. Do not use
supplemental coolant additives in your vehicle. These additives
may harm your engine cooling system.The use of an improper
coolant may void the warranty of your vehicle's engine cooling
system.
File:11vxmcn.ex
Update:Mon Jun 10 15:17:05 1996