1995 LAND ROVER DISCOVERY Workshop Manual

76CHASSIS AND BODY
38
REPAIR SUNROOF ASSEMBLY - ELECTRICAL, FRONT
AND REAR
Service repair no - 76.82.59
Remove
Refer to sunroof components illustration J5483
1.Ensure sunroof is in normally closed position.
2.Disconnect battery negative lead.
3.Remove headlining.
See headlining.
4.Disconnect electric motor wiring plug.See
sunroof electric motors.
5.Remove screws and detach electric motor from
clamping frame.
6.Disconnect drain tubes from each side of
clamping frame.
7.Remove 13 fixings and remove clamping frame
from upper frame.
8.Remove upper frame assembly.
Refit
9.Position upper frame assembly into roof
aperture.
10.Locate clamping frame and reconnect drain
tubes.
11.Loosely fit screws, centralise upper frame and
clamping frame assemblies and then tighten
screws.
12.Reverse removal procedure.

CHASSIS AND BODY
39
REPAIR SUNROOF ELECTRIC MOTORS
Service repair no - 76.82.84/85
FRONT MOTOR
Remove
1.Disconnect battery negative lead.
2.Ensure sunroof is in normally closed position
NOTE: If the electric motor has failed the
sunroof can be closed manually using an
allen key to turn motor spindle A.
3.Remove switch panel from stowage pocket
panel
4.Remove interior lamp from stowage pocket
panel
5.Remove alarm ultrasonic unit.
6.Unscrew ten fixings and remove stowage pocket
from headlining.
7.Disconnect motor wiring multiplug.
8.Remove three screws and motor.
Refit
9.Reverse removal procedure.
CAUTION: Ensure the motor is aligned
with fixing holes and the sunroof is in the
normally closed position. DO NOT rotate
the motor drive spindle in the rack - this may
result in incorrect operation of the sunroof.REAR MOTOR
Remove
1.Disconnect battery negative lead.
2.Ensure sunroof is in normally closed position
NOTE: If the electric motor has failed the
sunroof can be closed manually using an
allen key to turn motor spindle.
3.Remove headlining.
See headlining.
4.Disconnect motor wiring multiplug.
5.Remove three screws and motor.
Refit
6.Reverse removal procedure.
CAUTION: Ensure the motor is aligned
with fixing holes and the sunroof is in the
normally closed position. DO NOT rotate
the motor drive spindle in the rack - this may
result in incorrect operation of the sunroof.

76CHASSIS AND BODY
40
REPAIR SUNROOF ELECTRIC CONTROL UNIT
Service repair no - 76.82.73
The control unit serves both front and rear sunroofs
and is sited above the front switches behind
headlining.
Remove
1.Disconnect battery negative lead.
2.Ensure sunroof is in normally closed position.
NOTE: If the electric motor has failed the
sunroof can be closed manually using an
allen key to turn motor spindle.
3.Remove switch panel from stowage pocket
panel
4.Remove interior lamp from stowage pocket
panel
5.Remove alarm ultrasonic unit.
6.Unscrew ten fixings and remove stowage pocket
from headlining.
7.Disconnect electric plugs from control unit.
8.Remove two retaining screws and control unit.
Refit
9.Reverse removal procedure.

CHASSIS AND BODY
41
REPAIR SUNROOF ASSEMBLY - MANUAL, FRONT AND
REAR
Service repair no - 76.83.01
Remove
1.Close sunroof.
2.Remove headlining.
See headlining.
3.Remove screws and manual regulator from
clamping frame.
See sunroof regulator
manual.
4.Disconnect drain tubes from each side of
clamping frame.
5.Remove 13 screws and clamping frame from
upper frame.
6.Remove upper frame assembly from roof
aperture.Refit
7.Position upper frame assembly into roof
aperture.
8.Locate clamping frame and reconnect drain
tubes.
9.Loosely fit screws, centralise upper frame and
clamping frame assemblies and then tighten
screws.
10.Reverse removal procedure.
Sunroof components
1. Glass panel
2. Capnut and washer
3. Screw
4. Upper frame assembly5. Clamping frame assembly
6. Screw
7. Edging trim
8. Drain tube

76CHASSIS AND BODY
42
REPAIR SUNROOF REGULATOR MANUAL
Service repair no - 76.83.03/04
FRONT
Remove
1.Ensure sunroof is in normally closed position.
2.Remove retaining screw and regulator handle.
3.Remove switch panel from stowage pocket
panel
4.Remove interior lamp from stowage pocket
panel
5.Remove alarm ultra sonic unit.
6.Unscrew ten fixings and remove stowage pocket
from headlining.
7.Remove two retaining screws and regulator from
clamping frame.
Refit
8.Reverse removal procedure.
CAUTION: Ensure the regulator is aligned
with fixing holes and the sunroof is in the
normally closed position. DO NOT rotate
the regulator spindle in the rack - this may result
in incorrect operation of the sunroof.REAR
Remove
1.Ensure sunroof is in normally closed position.
2.Remove retaining screw and regulator handle.
3.Remove headlining.
See headlining.
4.Remove two retaining screws and regulator from
clamping frame.
Refit
5.Reverse removal procedure.
CAUTION: Ensure the regulator is aligned
with fixing holes and the sunroof is in the
normally closed position. DO NOT rotate
the regulator spindle in the rack - this may result
in incorrect operation of the sunroof.

CHASSIS AND BODY
43
REPAIR SUN BLIND ASSEMBLY
Service repair no - 76.82.78
Remove
1.Open sunroof to the tilt position.
2.Remove the trim finisher from the sunroof
surround.
3.Release the headlining locally to access under
clamping frame of the sunroof.
4.Lever forward and upward the rear leg of 3
retaining clips to release sun blind roll assembly.
Refit
5.Ensure front leg of retaining clips are located.
6.Push in rear leg of retaining clip.
7.Reverse removal procedure.CENTRE CONSOLE
Service repair no - 76.52.02
Remove
1.Disconnect battery earth lead.
2.Release tranfer gear lever gaiter from console.
3.Remove transfer gear lever gaiter and knob
assembly.
4.Release gear selector lever gaiter from centre
console.
5.Remove gear selector lever gaiter and knob
assembly.
6.Remove centre console rubber mat.

76CHASSIS AND BODY
44
REPAIR
7.Remove centre console switch pack cover.
8.Remove 4 screws securing switch pack to
console.
9.Release switch pack from console and
disconnect 7 multiplugs.
NOTE: If the 'Cold Pack' option is not fitted
there will only be 5 switches in pack.
10.Remove switch pack.
Models fitted with electric front seats
11.Release electric front seat switches from centre
console.
12.Disconnect 2 multiplugs from each switch.
13.Remove switches.All models
14.Release hand brake lever gaiter from centre
console.
15.Remove clip and clevis pin securing cable to
hand brake lever.
16.Remove 4 screws securing centre console to
body.
17.Raise hand brake lever, pull centre console
rearwards to gain access to cigar lighter
multiplug and illumination bulb Lucar.
18.Disconnect cigar lighter multiplug and
illumination bulb Lucar.
19.Remove centre console assembly.

CHASSIS AND BODY
45
REPAIR Refit
20.Position centre console assembly, ensuring
harnesses and connectors are not trapped and
are routed to their correct locations.
21.Connect cigar lighter multiplug and illumination
bulb Lucar.
22.Align centre console to body fixings and fascia.
23.Fit and tighten screws securing centre console to
body.
24.Lubricate hand brake lever to cable clevis pin.
25.Align hand brake cable to lever, fit clevis pin and
secure with clip.
26.Secure hand brake lever gaiter to centre
console.
Models fitted with electric front seats
27.Position electric front seat switches,connect
multiplugs and secure to centre console.
All models
28.Position centre console switch pack and connect
multiplugs to switches.
29.Align switch pack to centre console and secure
with screws.
30.Fit centre console switch pack cover.
31.Fit centre console rubber mat.
32.Fit gear selector lever knob and secure gaiter.
33.Fit transfer gear lever knob and secure gaiter.
34.Reconnect battery earth lead.DRINKS TRAY
Service repair no - 76.46.41
Remove
1.Disconnect battery negative lead.
2.Remove ash tray.
See ash tray - dash panel
central louvre panel.
3.Remove switch pack.See switch pack - dash
panel central louvre panel.
4.Remove 6 screws securing drinks tray to dash
panel central louvre panel.
5.Remove drinks tray.
Refit
6.Position drinks tray to dash panel central louvre
panel and secure with screws.
7.Fit switch pack.
See switch pack - dash panel
central louvre panel.
8.Fit ash tray.See ash tray - dash panel central
louvre panel.
9.Connect battery negative lead.