1994 JEEP CHEROKEE Service Repair Manual

Fig. 1 Power Windows 4-DoorÐXJ
8S - 2 POWER WINDOWSJ

Fig. 2 Power Windows 2-DoorÐXJ LEFT HAND DRIVE
JPOWER WINDOWS 8S - 3

Fig. 3 Power Windows 2-DoorÐXJ RIGHT HAND DRIVE
8S - 4 POWER WINDOWSJ

SWITCH TESTING
DRIVERS DOOR POWER WINDOW SWITCHÐ4-DOOR
JPOWER WINDOWS 8S - 5

DRIVERS DOOR POWER WINDOW SWITCHÐ2-DOOR LEFT HAND DRIVE
8S - 6 POWER WINDOWSJ

DRIVERS DOOR POWER WINDOW SWITCHÐ2-DOOR RIGHT HAND DRIVE
JPOWER WINDOWS 8S - 7

PASSENGER DOOR WINDOW SWITCH
8S - 8 POWER WINDOWSJ

WINDOW REGULATOR REPLACEMENT
REMOVAL
(1) Remove the interior door latch release assem-
bly and control panel retaining screws (Fig. 4).
(2) Disconnect the control linkage and the wire
harness connector.
(3) Remove the latch release and control panel as-
sembly.
(4) Remove the armrest lower retaining screws.
(5) Swing the armrest downward to a vertical po-
sition. This is necessary to disconnect the armrest
from the upper retainer clip (Fig. 5).
(6) Pull the armrest straight out from the trim
panel.To aid in removal of the trim panel, start at
the bottom of the panel.
(7) Remove the trim panel with a wide flat blade
tool (Fig. 6).
(8) Remove the plastic water dam sheet.
(9) Grind the heads off 2 rivets holding reinforce-
ment to door (Fig. 8). Knock rivets out with a ham-
mer and punch.
(10) Adjust window to allow access to Torx head
screw (Fig. 7).
(11) Remove 2 screws holding bottom of regulator
to door.
(12) Remove door glass attaching Torx head screw
(Fig. 7).
(13) Pull glass to the full up position and tape
glass to door.
Fig. 4 Power Window Control Panel Removal/
Installation
Fig. 5 Armrest Retainer Clip
Fig. 6 Trim Panel Removal
Fig. 7 Remove/Install Glass Attaching Screw
JPOWER WINDOWS 8S - 9