1989 MITSUBISHI GALANT engine coolant

13-176FUEL SYSTEM - ::i$%%-ti=pection Of MF’
1
@ Harnesssrde connector
7FUOSO5
Measure the impressed voltage./\1A
l Power steering pressure switch
connector: Disconnected
l Engine control module connec-
tor: Connected
l Ignition switch: ON
Voltage
04
1 modul
e
J
AIR CONDITIONING SWITCH AND A/C COMPRESSOR CLUTCH RELAY
hl13YRABl
ii++----- ,L’AI:
Air conditionino1 switch -
‘A //A\‘A /,,--.l, ,+q‘\
\\Wj i EYAJ26FUO645
Air conditioning
compresso
r
clutch
relav
~-1 6FUO612
Engine control module connector
Sub fusible link
TSB Revision Air conditioning
1
@ m i”“:F$
1
Engine control module ,
I7FUO653
-
,4,
g:2
[
22
Auto compressorcontrol unit
6
2 Dual pressure
I switch 3N
3N
1
1
Air conditioningOFFengine COOlant,^N temperature
2switch
11

5
6FU145.7
OPERATION
TROUBLESHOOTING HINTS INSPECTION
Using Scan Tool Refer
to P.13-83.

13-180FUEL SYSTEM - :::;:%?pection Of MF’
@ Harness sideconnectorCheck for continuity of the ground
Repair the
harness
(@lzl - El)
IlFUOS97 1I
L
G-lI’ ‘Ila
r rI L/I
IJ
lFUO598J
SENSOR INSPECTION
(I) Warm the engine and check to be sure that the engine
coolant temperature is
85-95°C (185-203°F).
(2) Disconnect the oxygen sensor connector and connect a
digital voltmeter.
Caution
When disconnecting the oxygen sensor connector, do
not pull the connector or lead wire too strongly.
(3)Race the engine repeatedly and measure the oxygen sensor
output voltage.
Engine Sensor output
voltage
Remark
When When the a/r/fuel
mixture
racing
the 0.6
- 1 .O Vratio is enriched by racing the
engine repeatedly, a normal
engine oxygen sensor will output a
voltage of 0.6
- 1 .OV.
(4) If the sensor is defective, replace the oxygen sensor.
NOTE
For removal and installation of the oxygen sensor, refer to
GROUP 15
- Exhaust Manifold.
TSB Revision

13-182FUEL SYSTEM - ~~~;~~~t~pection Of MF’
INSPECTION
Using Scan Tool
Function1 Item
No. ’Data display 1Check conditionI Coolant temperature Standard value
IData reading / 41Drive trme
*’ 1Engine: Cranking0°C (32°F) *2Approx. 20 ms
j: 20°C (68°F)Approx. 40 ms 80°C
(176°F)/ Approx. 9.8 ms
Data reading
NOTE Item
No.
41 i
Data display 1
Check condition
IEngine state 1Standard value
Drive time
*3l Engine coolant temperature: 85 to
95°C (185 to 203°F)
l Lights, electric cooling fan, accesso-ries: OFF
l Transaxle: Neutral
(P range for AIT) Idle
speed
1 2.2-3.4 ms
*‘:The injector drive time refers to when the supply voltage is 11 V and the cranking speed is less than 250 rpm.
*2:When engine coolant temperature is lower than 0°C (32°F). injection is made by four cylinders simultaneously.
*3:When the vehicle is new [within initial operation of about 500 km (300 miles)], the injector drive time may be about
10% longer
Function Item No
.
Drive content Check condition Normal state
Actuator test
01No. 1 injector shut off Engine: Idling afterI Idle state to change further
0
2
No. 2 injector shut off
- warm-up
(becoming less stable or
(Shut off the injectors in stalling)
03li No. 3 injector shut off sequence during after-engine warm-up, check1
I04No. 4 injector shut off
the idling condition)
-k
Imp
4 AL A: Inje,t,r--m--m-Normal waveformdrive time03*0209
(1) Run the engine at idle speed.
(2) Connect the probe to the oscilloscope pick-up point as
shown in the circuit diagram, and check the waveform at
the drive side of each injector.
1
TSB Revision 1
Using Oscilloscope

FUEL SYSTEM - i%$-%~pection Of MF’13-193
TerminaNo.
19
52
-rII
i
t
c
65
L
63
64t
I:
I
Check Item :Check Condition (Engrne Condrtron)
Volume air flowj Engine: Idle speedsensor reset signal
1
Engine rpm: 3,000 rpm
Intake air tempera-1Ignition switch: ON When Intake atr temperature IS 0°C (32°F)ture sensor
When intake air temperature IS 20°C (68°F)
i When intake air temperature is 40°C (104°F)
When intake air temperature is 80°C (176°F)
lgnltlon switch: ON’ When altitude is 0 m
When altitude is 1,200 m (3,937 ft.)
Ignition switch: ON
i When engine coolant temperature IS 0°C (32°F)
When engine coolant temperature is 20°C (68°F)
When engine coolant temperature is 40°C (104°F)
Barometnc pressuresensor
Engine coolant
temperature sensor
Throttle positionsensor
67
68
69
51
115
1
1
Ic22
Closed throttle
position switch
Camshaft position
sensor
Crankshaft position
sensor
Ignition switch-ST
Park/neutral position
switch
Vehicle speed sensor
Power steering
pressure switch
Air conditioning
switch
-I
I When engine coolant temperature is 80°C (176°F)
‘I
) 0.3-0.9v
Ignition switch: ON Set throttle valve to idle position.
0.3-0.6V
iFully open throttle valve.1 4.5-5.5v
Ignition switch: ON
Set throttle valve to idle position.o-1v
’ Slightly open throttle valve4V or more
Engine: Cranking0.2-3.OV
Engine: Idle speed
Engine: Cranking0.2-3.OV
Engine: Idle speed
Engine: Cranking8V or more
Ignition switch: ON
( SetselectorlevertoPorN.o-3v
i Set selector lever to D. 2, L or R.8-14V
Ignition switch: ONi 04d5v
Move the vehicle slowly forward.(Changesrepeatedly)
Engine. Idling after warmrng upSteering wheel idle stateB+
During steering wheel operationo-3v
Engine: Idle speed
’ Turn the air conditioning switch OFFo-3vI
’ Turn the air conditioning switch ON.1 B+(Air conditioning compressor is operating)!
Engine: Idle speed1 B+or
Air conditioning switch: OFF-ONI temporarily
Turn the conditioning switch ON. (Air conditioning compressor is operat\
ing) 1
6V or morej 1
1 o-3v
/ Standard
value
/ o-1v
1 6-9V
1 3.2-3.8V
: 2.3-2.9v
1.5-2.1V
i 0.4-I .ov
j 3.7-4.3v
/ 3.2-3.8V
, 3.2-3.8V
1, 2.3-2.9v
1.3-l .9vI
Air conditioningcompressor clutchrelay
TSB Revision1

13-196FUEL SYSTEM - General Information
FUEL SYSTEM
GENERAL INFORMATION
MFI SYSTEM DIAGRAMMl
3BA-A

*1 Injector*2 Ignition coil
(Low-
voltage power-drs-
tribution type)
*3 Idle air control motork4 Evaporative emis-
sion purge solenoid l Fuel pump control (Multiport
fuel injec-
tion relay)
l Air conditioning
corm- pressor clutch relay
* Ignition timing control) On-board diagnostic
output
) Check engine/mal-
function indicator
lamp
Engine coolant tem-
perature sensor
l Ignition swatch STl Power supplyl Vehicle-speed sen-sor
. Arr conditioning
switch
l Power steering
pressure
swatch
‘I Heated oxygen sensor ‘10*2
Volume air flow sensor *3

Intake air temperaturesensor‘4 Throttle position sensor *5
Closed throttle position
swrtch *6
Camshaft position sen-
sor “7
Crankshaft position sen-
sor“8 Barometrrc pressure
sensor
‘9 Engine coolant temper-ature switch (for cooler
cut-off)
Evaporatrveemrssion canister
Evaporatrveemlsslo”Idle airThronlecontrol motorl 3 Fast idle air valveI (Wax tvoe)position\Volume air/sensor3flow sensorf \//n,r\l 2 '8
- lnnhnn toll III1 II
II-“,--?% 11 11 EGR,/alveI.l”lll)i
Fuel injectorII
II
Vacuum hose color
G: Green
L: Light blue
I?: RedY: Yellow5: Black
Heated oxygen sensor Thermal
vacuu
a uCatalytrc converter
HMO163PCV: Positive CrankcaseVentilation
TSB Revision

‘1 Heated oxygen sensor‘2 Volume air flow sensor
“3 intake air temperature
sensor‘4 Throttle position sensor‘5 Closed throttle position
switch
‘6 Camshaft Dosltion sen-
so
r
*7 Crankshaft position sen-sor‘8
Barometnc
pressure
sensor
‘9 Engine coolant temper-
ature switch (for cooler
cut-off)
‘I 0 Knock sensor ‘11
Engien coolant tem-
perature sensor
l Ignition switch STl Power supplyl Vehicle-speed sen-
sor
l Air conditioningswitchl Power steeringpressure switch
Volume airflow sensor \
Idle air
FUEL SYSTEM - General Information13-197
* 1 Injector*2 Ignition coil (Low-
voltage power-dis-
tribution type)
*3 Idle air control motel*4 Evaporative emis-sion purge solenoid
l Fuel pump control (Multiport
fuel injec-
tion relay)
l Air conditioning com-pressor clutch relay
l Ignition timing control
l On-board diagnosticoutputl Check engine/mal-
function indicator
lamp
Evaporativeemissioncanister
Q
ThrottlepOSltlOnSt?“SW
\
control motor
r
Fast Idle air valveWax tape)
TSB Revision
e , lylllll”rl
COll
Fuel- wmpEGR valve
'1 A
Heated oxygen sensor /$$y/.\‘“I
w ‘11 Englen coolant temp. sensorF ‘9 Engine coolant temp. switch
Thermal vacuum valve
Crankshaft
position
sensor
‘7 positlon ICrankshaft
sensor
I
Camshaft‘6 positionsensor
Vacuum hose color G: Green
L: Light blueR: RedY: YellowB: Black
Catalytic convener
PCV: Posmve CrankcaseVentllatlon6EMO362

13-198FUEL SYSTEM - General information

*I Heated oxygen sensor *IO
EGR temperature sen-*2 Volume air flow sensor
sor‘3 Intake air temperature
*I 1Engien coolant tem-sensor
perature sensor‘4 Throttle position sensor . Ignition switch ST*5 Closed throttle position
l Power supply
switch l Vehicle-speed sen-
‘6 Camshaft
posltion
sen- sor
sor l Air conditioning“7 Crankshaft positron sen-
switch
SOT0 Power steering‘8 Barometric pressure pressure switch
sensor
‘9 Engine coolant
temper-
ature switch (for cooler
cut-off)
*l Injector*2 Ignition coil (Low-
voltage
power-dis-
tribution type)
*3 idle air control mot01*4 Evaporative emis- sion purge solenoid
*5 EGR solenoid
) Fuel pump control
(Multiport
fuel injec-
tion relay)
I Air conditioning com- pressor clutch relay I Ignition timing control
) On-board diagnostic
output
) Check enginejmal-
function indicator
lamp
Evaporativeemissioncanister
Volume air
flow sensorA..\
II
oressure db,Fun, taw”l”‘“‘~
Heated 0~““~” le
ax valve
e”SOrgme coolant temp.
Vacuum hose color
G: Green
L: Light blueR: RedY: YellowR. Rlnrk
Catalytic converter 6FU1596
PCV:
Positive Crankcase
Ventilation
TSB Revision

FUEL SYSTEM - General Information

*1 Heated oxygen sensor *2 Volume air flow sensor
‘3 Intake air temperature
sensor *4
Throttle position sensor
‘5 Closed throttle position
switch *6 Camshaft position sen-
sor
‘7 Crankshaft position sen- sor
‘8 Barometric pressure
sensor
‘9 Engine coolant temper-ature switch (for cooler
cut-off)
Volume air
‘10 Knock sensor
‘11 EGR temperature sen
sor‘12 Engien coolant tem- perature sensor
l Ignition switch STl Power supplyl Vehicle-speed sen-sorl Air conditioningswitchl Power steeringpressure switch
3
Throttleposition
sensor
IIntake air.‘3Fueltemp. sensorpressure *2-regulatorA-
-
.
cd
’
*l Injectorl Fuel pump control*2 Ignition coil (Low- (Multiport
fuel injec-voltage power-dis-
tion relay)
tribution type)
*3 Idle air control motorl Air conditioning com-
l 4 Evaporative emis- pressor clutch relaysion purge solenoidl Ignition timing control
t5 EGR solenoidl On-board diagnosticoutputl Check engine/mal-function indicatorlamp
Idle
aircontrol motorI Wax

wei
I
I
TSB Revision
Evaporativeemission
canister
Heared oxygen
It=
‘12 Engine coolant temp.sensor-‘I u
‘9 Engine coolant temp switch\
l 10 Knock sensor
EGR temperature
Crankshaftposltlon
EGR‘solenoid Vacuum hose colorG: GreenL: Light blue
R: RedY: Yellow
B: Black
Catalfllc converter
PCV: Positive Crankcase Ventilation