Page 537 of 632

Emergency Situations
8-26
 Information
The pressure gauge may show higher than 
actual reading when the compressor is 
running. To get an accurate tire pressure, 
the compressor needs to be turned off.
 CAUTION
If the inflation pressure is not 
maintained, drive the vehicle a second 
time, refer to Distributing the sealant. 
Then repeat steps 1 to 4.
Use of the TMK may be ineffectual for 
tire damage larger than approximately 
0.16 in. (4 mm).
Contact an authorized retailer of 
Genesis Branded products if the tire 
cannot be made roadworthy with the 
Tire Mobility Kit.
 WARNING
The tire inflation pressure must be 
inflated to the proper pressure (Refer to 
“Tire and Wheels” section in chapter 2). 
If it is not, do not continue driving.
Call for road side service or towing.
 CAUTION
Tire pressure sensor
The sealant on the tire pressure sensor 
and wheel should be removed when 
you replace the tire with a new one and 
inspect the tire pressure sensors at an 
authorized retailer of Genesis Branded 
products.
 Information
When reinstalling the repaired or replaced 
tire and wheel on the vehicle, tighten the 
wheel bolt to 101~116 lbf·ft (14~16 kgf·m).    
         
        
        
     
        
        Page 538 of 632
![GENESIS GV80 2021  Owners Manual 08
8-27
TOWING
Towing Service
OJX1089016OJX1089016[A] : Dollies
If emergency towing is necessary, 
we recommend having it done by an 
authorized retailer of Genesis Branded 
products or a commercial t GENESIS GV80 2021  Owners Manual 08
8-27
TOWING
Towing Service
OJX1089016OJX1089016[A] : Dollies
If emergency towing is necessary, 
we recommend having it done by an 
authorized retailer of Genesis Branded 
products or a commercial t](/manual-img/46/35616/w960_35616-537.png)
08
8-27
TOWING
Towing Service
OJX1089016OJX1089016[A] : Dollies
If emergency towing is necessary, 
we recommend having it done by an 
authorized retailer of Genesis Branded 
products or a commercial tow-truck 
service.
Proper lifting and towing procedures 
are necessary to prevent damage to 
the vehicle. The use of wheel dollies or 
flatbed is recommended.
For 2WD vehicles, it is acceptable to tow 
the vehicle with the front wheels on the 
ground (without dollies) and the rear 
wheels off the ground.
If any of the loaded wheels or suspension 
components are damaged or the vehicle 
is being towed with the rear wheels on 
the ground, use a towing dolly under the 
rear wheels.
When being towed by a commercial tow 
truck and wheel dollies are not used, 
the rear of the vehicle should always be 
lifted, not the front.
For AWD vehicles, it must be towed 
with a wheel lift and dollies or flatbed 
equipment with all the wheels off the 
ground.
NOTICE
• Do not lift the vehicle by the tow 
fitting or body and chassis parts. 
Otherwise the vehicle may be 
damaged.
• An AWD vehicle should never be 
towed with the wheels on the 
ground. This can cause serious 
damage to the transmission or the 
AWD system.
 CAUTION
• Do not tow the vehicle with the rear 
wheels on the ground as this may 
cause damage to the vehicle.
OJX1089019OJX1089019
• Do not tow with sling-type 
equipment. Use wheel lift or flatbed 
equipment.
OJX1089018OJX1089018   
         
        
        
     
        
        Page 539 of 632
Emergency Situations
8-28
When towing your vehicle in an 
emergency without wheel dollies:
1. Release EPB before turning off the 
engine.
2. Press the Engine Start/Stop button to 
the OFF position.
3. Change the gear to N (Neutral) by 
pressing the P release button (need to 
remove cap-cover) while pressing the 
brake pedal. For more details, refer to 
“Automatic Transmission” section in 
chapter 6.
4. Press the Engine Start/Stop button to 
the ACC position.
 CAUTION
Failure to shift the gear to N (Neutral) 
may cause internal damage to the 
transmission.
Removable Towing Hook
1. Open the liftgate, and remove the 
towing hook from the tool case.
		 
         
        
        
     
        
        Page 540 of 632