2004 SUBARU FORESTER display

EN(H4SO)-180
ENGINE (DIAGNOSTIC)
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step Check Yes No
1 CHECK ANY OTHER DTC ON DISPLAY.Is any other DTC displayed? Inspect the DTC
P0462 or P0463
using “List of Diag-
nostic Trouble
Code (DTC)”.
EN(H4SO)-72, List
of Diagnostic Trou-
ble Code (DTC).>Go to step 2.
2 CHECK FUEL LEVEL SENSOR.
1) Remove the fuel pump assembly. FU(H4SO)-55, Fuel Pump.>
2) While moving the fuel level sensor float up
and down, make sure that the resistance
between fuel level sensor terminals changes
smoothly.
Te r m i n a l s
No. 3 — No. 5:Does the resistance change
slowly?Go to step 3.Replace the fuel
level sensor. to FU(H4SO)-57,
Fuel Level Sen-
sor.>
3 CHECK FUEL SUB LEVEL SENSOR.
1) Remove the fuel sub level sensor. FU(H4SO)-57, Fuel Level Sensor.>
2) While moving the fuel sub level sensor float
up and down, make sure that the resistance
between fuel level sensor terminals changes
smoothly.
Te r m i n a l s
No. 1 — No. 2:Does the resistance change
slowly?Repair poor con-
tact in ECM, com-
bination meter and
coupling connec-
tors.Replace the fuel
sub level sensor.
FU(H4SO)-58,
Fuel Sub Level
Sensor.>

EN(H4SO)-183
ENGINE (DIAGNOSTIC)
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step Check Yes No
1 CHECK ANY OTHER DTC ON DISPLAY.Is any other DTC displayed? Inspect the rele-
vant DTC using
“List of Diagnostic
Trouble Code
(DTC)”. EN(H4SO)-72, List
of Diagnostic Trou-
ble Code (DTC).>Check radiator fan
and fan motor, and
poor contact in
connectors. to CO(H4SO)-35,
Radiator Main Fan
and Fan Motor.>
CO(H4SO)-40,
Radiator Sub Fan
and Fan Motor.>

EN(H4SO)-186
ENGINE (DIAGNOSTIC)
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step Check Yes No
1 CHECK TRANSMISSION TYPE.Is the transmission type AT? Go to step 2.Go to step 3.
2 CHECK DTC P0720 ON DISPLAY.Does the Subaru Select Moni-
tor or OBD-II general scan tool
indicate DTC P0720?Check front vehi-
cle speed sensor
signal circuit.
4AT(H4SO)-45,
DTC 33 FRONT
VEHICLE SPEED
SENSOR, Diag-
nostic Procedure
with Diagnostic
Trouble Code
(DTC).>Go to step 3.
3 CHECK SPEEDOMETER OPERATION IN
COMBINATION METER.Does speedometer operate
normally?Go to step 4.Check speedome-
ter and vehicle
speed sensor.
Speedometer.>
Front Vehicle
Speed Sensor.>
Rear Vehicle
Speed Sensor.>
Torque Converter
Turbine Speed
Sensor.>
4 CHECK HARNESS BETWEEN ECM AND
COMBINATION METER CONNECTOR.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from the combi-
nation meter.
3) Measure the resistance between ECM and
combination meter connector.
Connector & terminal
(B137) No. 10 — (i10) No. 12:Is the resistance less than 10
Ω?Repair the poor
contact in ECM
connector.Repair harness
and connector.
NOTE:
In this case repair
the following:
 Open circuit in
harness between
ECM and combi-
nation meter con-
nector
 Poor contact in
ECM connector.
 Poor contact in
combination meter
connector
 Poor contact in
coupling connector

EN(H4SO)-188
ENGINE (DIAGNOSTIC)
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step Check Yes No
1 CHECK ANY OTHER DTC ON DISPLAY.Is any other DTC displayed? Inspect the DTC
using “List of Diag-
nostic Trouble
Code (DTC)”.
EN(H4SO)-72, List
of Diagnostic Trou-
ble Code (DTC).>
N
OTE:
In this case, it is not
necessary to in-
spect DTC P0506.Go to step 2.
2 CHECK AIR BY-PASS LINE.
1) Turn the ignition switch to OFF.
2) Remove the idle air control solenoid valve
from the throttle body. REMOVAL, Idle Air Control Solenoid Valve.>
3) Remove the throttle body to intake mani-
fold. tle Body.>
4) Using an air gun, force air into the idle air
control solenoid valve installation area. Con-
firm that forced air subsequently escapes from
throttle body.Does air flow out? Replace the idle
air control solenoid
valve. FU(H4SO)-33,
INSTALLATION,
Idle Air Control
Solenoid Valve.>Replace the throt-
tle body. FU(H4SO)-13,
INSTALLATION,
Throttle Body.>

EN(H4SO)-190
ENGINE (DIAGNOSTIC)
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step Check Yes No
1 CHECK ANY OTHER DTC ON DISPLAY.Is any other DTC displayed? Inspect the DTC
using “List of Diag-
nostic Trouble
Code (DTC)”.
EN(H4SO)-72, List
of Diagnostic Trou-
ble Code (DTC).>
N
OTE:
In this case, it is not
necessary to in-
spect DTC P0507.Go to step 2.
2 CHECK AIR INTAKE SYSTEM.
1) Turn the ignition switch to ON.
2) Start and idle the engine.
3) Check the following items:
 Loose installation of intake manifold, idle air
control solenoid valve and throttle body
 Cracks of intake manifold gasket, idle air
control solenoid valve gasket and throttle body
gasket
 Disconnections of vacuum hosesIs there any fault in air intake
system?Repair air suction
and leaks.Go to step 3.
3 CHECK THROTTLE CABLE.Is the free play of throttle cable
appropriate?Go to step 4.Adjust throttle
cable. SP(H4SO)-9,
INSTALLATION,
Accelerator Con-
trol Cable.>
4 CHECK AIR BY-PASS LINE.
1) Turn the ignition switch to OFF.
2) Remove the idle air control solenoid valve
from the throttle body. REMOVAL, Idle Air Control Solenoid Valve.>
3) Confirm that there are no foreign particles
in air by-pass line.Are foreign particles in air by-
pass line?Remove foreign
particles from air
by-pass line.Replace the idle
air control solenoid
valve. FU(H4SO)-33,
INSTALLATION,
Idle Air Control
Solenoid Valve.>

EN(H4SO)-195
ENGINE (DIAGNOSTIC)
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step Check Yes No
1 CHECK ANY OTHER DTC ON DISPLAY.Is any other DTC displayed? Inspect DTC using
“List of Diagnostic
Trouble Code
(DTC)”. EN(H4SO)-72, List
of Diagnostic Trou-
ble Code (DTC).>
N
OTE:
In this case, it is not
necessary to in-
spect DTC P0519.Go to step 2.
2 CHECK AIR INTAKE SYSTEM.
1) Turn the ignition switch to ON.
2) Start the engine, and idle it.
3) Check the following items:
 Loose installation of intake manifold, idle air
control solenoid valve and throttle body
 Cracks of intake manifold gasket, idle air
control solenoid valve gasket and throttle body
gasket
 Disconnections of vacuum hosesIs there any fault in air intake
system?Repair air suction
and leaks.Go to step 3.
3 CHECK THROTTLE CABLE.Is the free play of throttle cable
appropriate?Go to step 4.Adjust throttle
cable. SP(H4SO)-9,
INSTALLATION,
Accelerator Con-
trol Cable.>
4 CHECK AIR BY-PASS LINE.
1) Turn the ignition switch to OFF.
2) Remove the idle air control solenoid valve
from the throttle body. Idle Air Control Solenoid Valve.>
3) Confirm that there are no foreign particles
in air by-pass line.Are foreign particles in air by-
pass line?Remove foreign
particles from air
by-pass line.Replace the idle
air control solenoid
valve. FU(H4SO)-33, Idle
Air Control Sole-
noid Valve.>

EN(H4SO)-199
ENGINE (DIAGNOSTIC)
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step Check Yes No
1 CHECK ANY OTHER DTC ON DISPLAY.Is any other DTC displayed? Replace the ECM.
FU(H4SO)-44,
Engine Control
Module (ECM).>It is not necessary
to inspect DTC
P0601.

EN(H4SO)-209
ENGINE (DIAGNOSTIC)
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
BJ:DTC P0734 GEAR 4 INCORRECT RATIO
DTC DETECTING CONDITION:
Two consecutive driving cycles with fault
TROUBLE SYMPTOM:
 Shift point too high or too low.
 Engine brake not effected in 3rd range.
 Excessive shift shock.
 Excessive tight corner braking.
CAUTION:
After repair or replacement of faulty parts, conduct Clear Memory Mode ERATION, Clear Memory Mode.> and Inspection Mode tion Mode.>.
Step Check Yes No
1 CHECK ANY OTHER DTC ON DISPLAY.Is any other DTC displayed? Inspect the rele-
vant DTC using
“List of Diagnostic
Trouble Code
(DTC)”. EN(H4SO)-72, List
of Diagnostic Trou-
ble Code (DTC).>Go to step 2.
2 CHECK THROTTLE POSITION SENSOR
CIRCUIT.
Check the throttle position sensor circuit. to 4AT(H4SO)-41, DTC 31 THROTTLE POSI-
TION SENSOR, Diagnostic Procedure with
Diagnostic Trouble Code (DTC).>Is there any trouble in throttle
position sensor circuit?Repair or replace
the throttle posi-
tion sensor circuit.Go to step 3.
3 CHECK FRONT VEHICLE SPEED SENSOR
CIRCUIT.
Check front vehicle speed sensor circuit. to 4AT(H4SO)-45, DTC 33 FRONT VEHICLE
SPEED SENSOR, Diagnostic Procedure with
Diagnostic Trouble Code (DTC).>Is there any trouble in front
vehicle speed sensor circuit?Repair or replace
the front vehicle
speed sensor cir-
cuit.Go to step 4.
4 CHECK TORQUE CONVERTER TURBINE
SPEED SENSOR CIRCUIT.
Check torque converter turbine speed sensor
circuit. TORQUE CONVERTER TURBINE SPEED
SENSOR, Diagnostic Procedure with Diagnos-
tic Trouble Code (DTC).>Is there any trouble in torque
converter turbine speed sensor
circuit?Repair or replace
the torque con-
ver ter turbine
speed sensor cir-
cuit.Go to step 5.
5 CHECK POOR CONTACT.
Check poor contact in TCM connector.Is there poor contact in TCM
connector?Repair poor con-
tact in TCM con-
nector.Go to step 6.
6 CHECK MECHANICAL TROUBLE.
Check mechanical trouble in automatic trans-
mission.Is there any mechanical trou-
ble in automatic transmission?Repair or replace
the automatic
transmission.
INSPECTION,
Road Test.>Replace the TCM.
Transmission Con-
trol Module
(TCM).>