2002.5 PEUGEOT 807 Owners Manual

Opening / Closing using the
remote control:
press button C for more than two
seconds to open or close the rear
right door.
press button D for more than two
seconds to open or close the rear
left door.
Note: the electric sliding side doors
are fitted with an obstacle detection
system.
If an obstacle appears while the door
is closing, the door reopens.
If an obstacle appears while the door
is opening, the door stops.
In both cases, complete the required
action manually using the handle. Child lock
Electric
This disarms all of the electrical
controls in the rear.
 electric windows,
 sliding side doors,
 sunroofs.
With the ignition on, press button A.
The message "Child lock activat
ed" appears on the multifunction
display, accompanied by an audible
signal.
Always remove the key from the igni
tion on leaving the vehicle, even for
a short time.
YOUR 807 IN DETAIL
108
The force with which the
door moves may cause
injury.
When opening or closing
the door, ensure that
nothing prevents the required
manoeuvre.
Do not leave children or animals
near the door controls without
supervision. If necessary, disarm
the controls, then remove the key
from the ignition, even for a short
time.
Before setting off, check that the
door is correctly closed and
locked (see "door open" warning).
18-11-2002

Opening / Closing using the
remote control:
press button C for more than two
seconds to open or close the rear
right door.
press button D for more than two
seconds to open or close the rear
left door.
Note: the electric sliding side doors
are fitted with an obstacle detection
system.
If an obstacle appears while the door
is closing, the door reopens.
If an obstacle appears while the door
is opening, the door stops.
In both cases, complete the required
action manually using the handle. Child lock
Electric
This disarms all of the electrical
controls in the rear.
 electric windows,
 sliding side doors,
 sunroofs.
With the ignition on, press button A.
The message "Child lock activat
ed" appears on the multifunction
display, accompanied by an audible
signal.
Always remove the key from the igni
tion on leaving the vehicle, even for
a short time.
YOUR 807 IN DETAIL
108
The force with which the
door moves may cause
injury.
When opening or closing
the door, ensure that
nothing prevents the required
manoeuvre.
Do not leave children or animals
near the door controls without
supervision. If necessary, disarm
the controls, then remove the key
from the ignition, even for a short
time.
Before setting off, check that the
door is correctly closed and
locked (see "door open" warning).
18-11-2002

YOUR 807 IN DETAIL109
T
ailgate release
This enables the tailgate to be
unlocked in the event of a central
locking fault.  Fold back a 2 nd
row rear seat,
 Fold back a 3 rd
row rear seat or
the bench seat to gain access to
the lock from inside the boot,
 Insert a small screwdriver into
hole Ain the lock and push it
towards the left to unlock the
tailgate .
TAILGATE
Simultaneous locking or unlock
ing of the tailgate and the doors
The tailgate is locked or unlocked by
the remote control or the driver's
door or passenger door lock.
To open, operate the handle
Aand
lift the tailgate.
Note: The tailgate locks automatical
ly when the vehicle is being driven at
more than 6 mph (10 km/h) and
unlocks when one of the doors is
opened.
"Tailgate open" warning
When the engine is running or the
vehicle is being driven, you are
warned if the tailgate is not closed
correctly by a diagram on the
multi–function display, accompanied
by an audible signal. Partially opening rear
windows
To partially open the rear windows,
tilt the lever
Aand push it fully to
lock the windows in the open posi
tion.
18-11-2002

YOUR 807 IN DETAIL
110
SUNROOFS You have three sunroofs each with
an independent control.
However, the front passengers' con
trol can also operate the two rear
sunroofs simultaneously.
•partially open the roof: press and
hold part Aof the switch.
•to open the roof completely:
press part Aof the switch briefly.
•to close it completely: press part
B of the switch briefly, then keep it
pressed.
•safety autoreverse
When the sunroof is sliding closed
and meets an obstacle, it stops then
opens again.
Note: in the presence of ice, if the
sunroof does not close, press the
control until the roof is fully open,
then close the roof. Note:
following reconnection of the
battery, if the sunroof does not close,
release the control and press it sev
eral times until the roof is fully
closed. Continue to press the control
for approximately five seconds after
closing.
Disarming of the 2 nd
and 3 rd
row
controls:
– press the rear electrical functions disarming switch.
Note: the sunroof shutter is manual.
To open it, lift the handle and slide it
rearwards.
To close it, slide it forwards until the
handle locks. OPENING THE BONNET
From inside:
– lift the cover at the left foot of the
passenger seat.
– pull the control upwards.
From outside: lift the catch and
raise the bonnet.
Bonnet strut
Secure the strut to hold the bonnet open.Before closing the bonnet, replace
the strut in its housing.
To close
Lower the bonnet and release it at
the end of its travel. Check that the
bonnet is properly locked.
"Bonnet open" warning
This warning is linked to the alarm
option only.
With the engine running or the
vehicle moving, a diagram on the
multifunction display, accompanied
by an audible signal, warns you that
the bonnet is not properly closed.
18-11-2002

YOUR 807 IN DETAIL111
FILLING
THE
FUEL TANK
Low fuel level
When the tank's minimum
level is reached, this warn
ing light comes on, accom
panied by the message
"Fuel level low" on the
multi–function display.
You have enough fuel left to cover
approximately 30 miles (50 km).
If the warning light flashes, this
indicates a fuel gauge malfunction.
Contact a PEUGEOT dealer.
If the warning light flashes, accom
panied by the message "Fuel circuit
disarmed" , this indicates that the
fuel supply has been cut off.
Restore the supply (refer to the
corresponding section). The tank must be filled with fuel with
the engine off
.
 Open the fuel filler flap.
 Insert the key then turn it to the
left.
 Remove the cap and attach it to
the clip located on the inside of
the flap.
A label on the inside of the flap indi
cates which type of fuel to use.
If you fill your tank, do not continue
after the third cutoff of the pump
nozzle. This could result in vehicle
malfunctions.
The capacity of the tank is approx
imately 18 gallons (80 litres).  After filling the tank, lock the cap
and close the flap.
When the fuel filler flap isopen, a system limits theopening of the rear left
sliding side door. The keycannot be removed from
the capÕs lock until the cap is refit-ted on the tank.
18-11-2002

Direction indicators
(flashers)Left:downwards.
Right: upwards.
YOUR 807 IN DETAIL
112
LIGHTING CONTROL
Front and rear lights
Selection is by turning ring
A.
Lights off
Side lights on Dipped beam/Main
beam
Automatic switching
on of lights Dipped beam/main beam change
Pull the stalk fully towards you.
Lightson buzzer
When the ignition is switched off,
when the driver's door or front pas
senger door is opened, a buzzer
sounds, accompanied by the mes
sage
"Side lights on" on the
multi–function display if you have left
your lights on.
Front and rear fog lights
Rotate ring Bforwards to switch on
and rearwards to switch off. The sta
tus is confirmed by the light on the
instrument panel.
Front fog lights (1 st
rotation
of the ring forwards)
These operate with the side lights
and the dipped beam headlamps. Front and rear fog
lights (2nd
rotation of
the ring forwards) These operate with the side lights
and the dipped beam headlamps.
Note:
to switch off the front and rear
fog lights, turn the ring rearwards
twice in succession.
In clear weather or in
rain, both day and night,
rear fog lights dazzle and
are prohibited.
Do not forget to switch
them off when they are no longer
needed.
Automatic switching on of the
lights switches off the rear fog
lamps, but the front fog lamps
remain on.
18-11-2002

AUTOMATIC SWITCHING ON
OF LIGHTS
Side lights and dipped beam head
lamps switch on automatically if the
light is poor, or during continuous
operation of the windscreen wipers.
They switch off when the light
becomes bright enough or the wind
screen wipers stop.
Note: In foggy weather, the bright
ness sensor can detect sufficient
light. As a consequence, the lights
will not come on automatically.
This function is active when the
vehicle is supplied to the customer.
To disarm or activate the function :  Start with the key in the acces
sories position (1st notch),
 Place the lights stalk in position 0,
 Press the end of the stalk for more
than two seconds.
Note: after the ignition is switched off
and depending on the brightness,
the lights remain on for approximate
ly 45 seconds or until the vehicle is
locked.
Do not cover the brightness sen
sor located in the centre of the
fascia. It is used for automatic
switching on of the lights. Operating check
Activation
Activation of this function is accom
panied by an audible signal and the
message
"Automatic lighting
active" on the multi–function dis
play .
Disarming
Disarming of the function is accom
panied by an audible signal.
Note: the function is disarmed
temporarily when the driver uses the
manual lighting controls.
YOUR 807 IN DETAIL 113
18-11-2002

YOUR 807 IN DETAIL
114
WINDSCREEN WIPER STALK
Front windscreen wiper stalk with
intermittent wipe
2 Fast wipe
(heavy rain).
1 Normal wipe
(moderate rain).
l Intermittent wipe.
0 Off.
Single wipe
(press downwards). Front windscreen wiper stalk with
automatic wipe
2 Fast wipe
(heavy rain).
1 Normal wipe
(moderate rain).
AUTO Automatic wipe.
0 Off.
Single wipe
(press downwards). Operation
In position
1or 2, when the vehicle
stops, the windscreen wiper
changes to a lower wiping speed,
then resumes its initial speed when
the vehicle starts again.
In the Intermittent position, the wip
ing speed is proportional to the
speed of the vehicle.
In the AUTOposition, the wiping
speed is proportional to the heavi
ness of the rain.
When the ignition has been
switched off for more than one
minute with the stalk in the wipe
position, it is necesary to reacti
vate this function. To do this, move
the stalk to any position, then move
it back to the required position.
Windscreen and headlamp wash
Pull the windscreen wiper stalk
towards you.
The windscreen wash then the wind
screen wipers operate for a fixed
period.
The windscreen wash and headlamp
wash operate simultaneously for a
few seconds, only if the dipped
beam or main beam headlamps
are on.
18-11-2002