2002.5 PEUGEOT 807 Owners Manual

Handbrake,low brake fluid level and electronic brake force distri bution warning light
This is linked to the central STOPwarning light.
It comes on each time the ignition is switched on.
This warning light is accompanied by an audible signal and a message on the multifunction display indicating the
cause of the warning:
– "Handbrake on" , if the handbrake is on or not released correctly while driving ,
– "Brake fluid low" in the event of an excessive drop in the brake fluid level (if the warning light remains lit even with the
handbrake released),
– "Braking fault" , displayed at the same time as the ABS warning light, indicat ing an electronic brake force distribution
system fault.
Stop immediately.
Contact a PEUGEOT dealer.
INSTRUMENTS AND CONTROLS 29
Dynamic stability control warning light (ESP/ASR)
This comes on each time the ignition is switched on.
If it remains on or comes on with the engine running and th e vehicle moving, it is accompanied by an audible
signal and the message "ESP/ASR not operational" on the multifunction display.
Contact a PEUGEOT dealer.
It flashes when the system is activated and is lit continuously when the system is switched off.
Antilock braking system (ABS) warning light
This comes on each time the ignition is switched on.
If it remains on or comes on above 8 mph (12 km/h), it indicates a
malfunction of the ABS.
However, the vehicle retains conventional servoassisted braking.
Illumination of this warning light is accompanied by an aud ible signal and the message "ABS fault" on the multifunction
display.
Contact a PEUGEOT dealer.
18-11-2002

INSTRUMENTS AND CONTROLS
30
Cruise control indicator light
This indicator light comes on when the function is activated.
Battery charge warning light
This comes on each time the ignition is switched on.
If it comes on with the engine running, it is accompanied b y an audible signal and the message "Low battery
charge" on the multifunction display.
It indicates faulty operation of the charging circuit (loose b attery terminals, a cut or slack alternator belt, an alternator f ault).
Contact a PEUGEOT dealer.
Engine diagnostics warning light
This comes on each time the ignition is switched on.
If it comes on with the engine running, accompanied by an a udible signal and the message "Emission control
system problem" on the multifunction display, it indicates a malfunction in the emission control sy stem.
If it flashes with the engine running, accompanied by an a udible signal and the message "Catalytic converter faulty"on
the multifunction display, it indicates a malfunction in th e injection or ignition sy stem. There is a risk of damage to t he
catalytic converter (petrol engines only).
Contact a PEUGEOT dealer without delay.
Note: following prolonged operation of the vehicle at very low sp eed or at idle, you may, in exceptional circumstances, notice
emissions of water vapour at the exhaust on acceleration. This d oes not have any effect on the vehicle's performance or on
the environment.
Diesel preheat indicator light
This comes on each time the ignition is switched on.
In cold weather, wait until it goes out before trying th e starter.
18-11-2002

INSTRUMENTS AND CONTROLS31
Passenger air bag disarming indicator light
This comes on for a few seconds each time the ignition is switch ed on.
Illumination of this indicator light is accompanied by an au dible signal and the message"Passenger air bag
disarmed" on the multifunction display.
If the passenger air bag is disarmed, the indicator light comes on when the ignition is switched on and remains on.
In all cases, if the indicator light flashes, contact a PEUGEOT dealer.
Front, side and curtain air bags warning light
This warning light comes on when the ignition is switched o n.
Illumination of this warning light, with the engine run ning, is accompanied by an audible signal and the message
"Air bag fault" on the multifunction display, indicating a front, side or cu rtain air bag fault.
Contact a PEUGEOT dealer.
Driver's seat belt warning light
With the engine running, this indicator light comes on, acco mpanied by an audible signal at a speed above 6 mph
(10 km/h) and the message "Seat belt not fastened" on the multifunction display, if the driver's seat belt is no t
fastened.
Low fuel level warning light
This light comes on each time the ignition is switched on.
When the warning light comes on, accompanied by the message "Fuel level low"on the multifunction display,
there is enough fuel remaining to drive approximately 30 miles (50 km). The tank capacity is approximately 80 litres.
This light flashes to indicate a malfunction of the fuel gauge or cuttingoff of the fuel supply, if it is accompanie d by the
message "Fuel circuit neutralised" on the multifunction display.
Restore the supply (refer to the "Practical Information § Fuel Su pply CutOff" section) or contact a PEUGEOT dealer,
depending on the circumstances.
Note: some functions can be configured by your PEUGEOT dealer.
18-11-2002

INSTRUMENTS AND CONTROLS
32
In zoneA,the temperature is correct.
In zone B, the temperature is too high. The central STOPwarning light and the
maximum coolant temperature warning light 1come on, accompanied by an
audible signal and the message "Coolant temp. too high"on the multifunction
display.
You must stop immediately.
Warning : wait for the engine to cool before topping up the le vel.
The cooling system is pressurised.
In the event of a breakdown and in order to avoid any risk of scalding, unscrew
the cap two turns to allow the pressure to drop.
When the pressure has dropped, remove the cap and top up the level.
Contact a PEUGEOT dealer.
Instrument panel with
monochrome screen
Instrument panel with colour
screen
Coolant temperature indicator light
18-11-2002

INSTRUMENTS AND CONTROLS33
"SNOW" indicator light
This comes on when the automatic gearbox "SNOW"operating programme is selected.
"Park"
"Reverse"
"Neutral"
"Drive"
"Manual" mode:
1st gear engaged
2nd gear engaged
3rd gear engaged
4th gear engaged
Automatic gearbox indicator
Automatic gearbox lever positions:
Automatic gearbox indicator light:
18-11-2002

Maximum
Minimum
Check the level with
the dipstick and top it
up.
The figure shown is
only correct if the vehicle has been
on stable, level ground, with the
engine stopped, for 10 minutes.
No oil
The message "Top
up the oil" appears
on the multifunction
display, accompa
nied by an audible signal.
It is essential to top up the oil to the
correct level, otherwise the engine
may be damaged.
Oil gauge fault
Flashing of the seg
ments indicates a
fault.
Check the level
using the dipstick.
Consult a PEUGEOT dealer. Control module display
After switching on the ignition, three
functions are shown in succession:
– service indicator (see correspond ing section),
– engine oil level indicator,
– total distance recorder (total and trip distances).
Note: the total and trip distances are
displayed for thirty seconds, when
the ignition is switched off, on open
ing the driver's door as well as on
locking and unlocking the vehicle.
It also displays the automatic gear
box positions and programmes
selected (see corresponding sec
tion).
Engine oil level
When the ignition is switched on, the
engine oil level is indicated for
approximately 10 seconds, after the
service information. Lighting rheostat
With the lights on,
press the button to
vary the intensity of
the lighting of the
control module, the
instrument panel, the
air conditioning dis
play and the multi–function display.
When the lighting reaches the mini
mum (or maximum) setting, release
it then press again to increase (or
reduce) the brightness.
As soon as the lighting is of the
brightness required, release the
button.
Trip recorder
zero reset
With the ignition on,
press the button.
INSTRUMENTS AND CONTROLS
34
18-11-2002

Monochrome screen CT
General menu
Press the "MENU" button to access
the general menu and select one of
the following applications :
• navigation guidance (see section "Satellite navigation system"),
• trip computer (see corresponding section),
• directory (see "RT3 audio/tele phone" section),
• telematics (see "RT3 audio/tele phone" section),
• configuration (see corresponding section).
MULTI–FUNCTION
SCREENS
Presentation
Monochrome screen B
This enables the following informa
tion to be displayed:
– the time,
– the date,
– the outside temperature (the °C
symbol flashes when there is a risk
of ice),
– the radio displays,
– the status of the openings (doors, bonnet...),
– the warning (e.g. "Battery charge fault") or information (e.g. "Passen
ger air bag disarmed") messages
displayed temporarily can be
cleared by pressing button 1or 2,
– the trip computer (see correspond ing section).
YOUR 807 IN DETAIL 35
Monochrome screen CT
and colour screen DT
These two systems are controlled by
the
RT3 audio/telephone keypad
and/or by a remote control keypad.
They enable the following informa
tion to be displayed:
– the time,
– the date,
– the outside temperature (a mes sage warns you when there is a
risk of ice),
– the audio source displays (radio, CD, ...),
– the telematic system displays (telephone, services, ...),
– the status of the openings (doors, bonnet, ...),
– the warning messages (e.g. "Fuel level low") and vehicle functions
status messages (e.g. "Passenger
air bag disarmed"), displayed tem
porarily,
– the trip computer display (see cor responding section),
– the satellite navigation system dis plays (see corresponding section).
Note: to enable you to use all of your
system's functions, you have two CD
ROMs: one, "Configuration", con
tains the software and the various
display and spoken information
languages, the other, "Navigation",
contains the satellite navigation
system map data.
18-11-2002

YOUR 807 IN DETAIL
36
configuration (see corresponding
section).
map (see section "Satellite naviga tion system")
A few definitions
Superimposed display:
a window appears over the current
application for a short while, to
announce a change of status of
another application.
Permanent application:
main application currently in use,
displayed in the main screen win
dow.
Contextual menu:
limited menu associated with the
main application currently in use,
displayed in the main screen win
dow.
Colour screen DT
General menu
Press the
"MENU" button to access
the general menu and select one of
the following applications:
navigation guidance (see section "Satellite navigation system"),
trip computer (see corresponding section),
directory (see "RT3 audio/tele phone" section),
telematics (see "RT3 audio/tele phone" section),Parameter configuration
Monochrome screen B
Press button 1for two seconds to
gain access to the settings .
Then, each press of this button permits
scrolling of the various parameters.
– language of the information dis played,
– unit of speed (km or miles),
– unit of temperature (degrees Cel cius or Fahrenheit),
– time format (12 or 24 hours),
– hour,
– minute,
– year,
– month,
– day.
Pressing button 2enables you to
change the parameter selected.
Continue pressing the button for
rapid scrolling.
After ten seconds without action, the
screen returns to the usual display,
the modified data are recorded.
18-11-2002