2005 NISSAN NAVARA transmission

AT-264
DISASSEMBLY
5. Remove O-ring from input clutch assembly.
6. Remove tightening bolts for oil pump assembly and transmis-
sion case.
7. Attach the sliding hammers to oil pump assembly and extract it
evenly from transmission case.
CAUTION:
lFully tighten the sliding hammer screws.
lMake sure that bearing race is installed to oil pump
assembly edge surface.
8. Remove O-ring from oil pump assembly.
SCIA5011E
SCIA2300E
SCIA4608E
SCIA5172E

AT-266
DISASSEMBLY
14. Loosen lock nut and remove band servo anchor end pin from
transmission case.
15. Remove brake band from transmission case.
lTo prevent brake linings from cracking or peeling, do not
stretch the flexible band unnecessarily. When removing
brake band, always secure it with a clip as shown in the
figure at right.
Leave the clip in position after removing the brake band.
lCheck brake band facing for damage, cracks, wear or
burns.
16. Remove mid carrier assembly and rear carrier assembly as a
unit.
17. Remove mid carrier assembly from rear carrier assembly.
SCIA6512E
SCIA2580E
SAT655
SCIA5017E
SCIA5174E

AT-270
DISASSEMBLY
33. Disconnect revolution sensor connector.
CAUTION:
Be careful not to damage connector.
34. Straighten terminal clips to free revolution sensor harness.
35. Remove bolts A, B and C from control valve with TCM.
36. Remove control valve with TCM from transmission case.
CAUTION:
When removing, be careful with manual valve notch and
manual plate height. Remove it vertically.
37. Remove A/T fluid temperature sensor 2 with bracket from con-
trol valve with TCM.
SCIA5024E
SCIA7023E
Bolt symbol Length [mm (in)] Number of bolts
A 42 (1.65) 5
B 55 (2.17) 6
C 40 (1.57) 1
SCIA5025E
SCIA5260E
SCIA5301E

AT-272
DISASSEMBLY
43. Remove rear extension assembly (2WD models) or adapter case assembly (4WD models) according to
the following procedures.
a.2WD models
i. Remove tightening bolts for rear extension assembly and trans-
mission case.
lSelf-sealing bolt (1)
:Bolt(10)
ii. Tap rear extension assembly with soft hammer.
iii. Remove rear extension assembly from transmission case. (With
needle bearing.)
SCIA7176J
SCIA5028E
SCIA5029E

DISASSEMBLY
AT-273
D
E
F
G
H
I
J
K
L
MA
B
AT
b.4WD models
i. Remove tightening bolts for adapter case assembly and trans-
mission case.
ii. Tap adapter case assembly using a soft hammer.
iii. Remove adapter case assembly from transmission case. (With
needle bearing)
iv. Remove gasket from transmission case.
SCIA6842E
SCIA5204E
SCIA5205E
SCIA5231E

AT-274
DISASSEMBLY
44. Remove bearing race from output shaft.
45. Remove output shaft from transmission case by rotating left/
right.
46. Remove parking gear from output shaft.
47. Remove seal rings from output shaft.
48. Remove needle bearing from transmission case.
SCIA5245E
SCIA5030E
SCIA5247E
SCIA5209E
SCIA5031E

DISASSEMBLY
AT-275
D
E
F
G
H
I
J
K
L
MA
B
AT
49. Remove revolution sensor from transmission case.
CAUTION:
lDo not subject it to impact by dropping or hitting it.
lDo not disassemble.
lDo not allow metal filings, etc. to get on sensor's front
edge magnetic area.
lDo not place in an area affected by magnetism.
50. Remove reverse brake snap ring (fixing plate) using 2 flat-
bladed screwdrivers.
NOTE:
Press out snap ring from transmission case oil pan side
gap using a flat-bladed screwdriver, and remove it using a
another screwdriver.
51. Remove reverse brake retaining plate from transmission case.
lCheck facing for burns, cracks or damage. If necessary,
replace the plate.
52. Remove N-spring from transmission case.
53. Remove reverse brake drive plates, driven plates and dish plate
from transmission case.
lCheck facing for burns, cracks or damage. If necessary,
replace the plate.
SCIA2320E
SCIA5032E
SCIA5214E
SCIA2322E

AT-276
DISASSEMBLY
54. Set SST on spring retainer and remove snap ring (fixing spring
retainer) from transmission case while compressing return
spring.
55. Remove spring retainer and return spring from transmission
case.
56. Remove seal rings from drum support.
57. Remove needle bearing from drum support edge surface.
SCIA6843E
SCIA2324E
SCIA3333E
SCIA2796E