1997 TOYOTA SUPRA engine

Z16797
PS Solenoid Valve Connector
Ground Strap
MAF Meter
Connector
Generator
WireStarter Wire
Solenoid Connector
Noise Filter Connector
Igniter Connector
Connector
(from engine room main wire)
A/C Compressor
ConnectorGround Strap
Scuff PlateTRAC ECU Connector Connector
(from connector cassette)
ECM
ConnectorFloor Carpet ECM
ECM ProtectorConnector
(from instrument
panel wire)
- ENGINE MECHANICAL (2JZ-GTE)ENGINE UNIT
EM-55
1160 Author
: Date
:
1997 SUPRA (RM502U)

S00926
Upper Console Panel
Shift & Select Lever BootShift Lever
Shift Lever Knob
Shift Control Rod
Fuel Return Hose
Fuel Inlet Hose A/T
PS Vane Pump
A/C CompressorGround Strap
PS Pump Bracket M/T
Clutch Release Cylinder (M/T)Rear Support Member
Exhaust Pipe AssemblyPropeller Shaft
PS Pressure Feed Hose
No.2 Front Exhaust Pipe
Pipe Support BracketHeated Oxygen SensorHeat InsulatorCenter Floor
Crossmember Brace Ring
Ring
Gasket

Gasket

Gasket



Non-reusable partSport Roof
EM-56
- ENGINE MECHANICAL (2JZ-GTE)ENGINE UNIT
1161 Author
: Date
:
1997 SUPRA (RM502U)

A02167
Starter ConnectorServise Hole Cover
Oil Cooler Pige
Hole Plugx 6

O-Ring Oil Dipstick and Guide
(for Transmission) Wire BracketEngine Wire Service Hole CoverTransmission Wire Bracket
Starter
Throttle Cable
Starter
Starter Connector
Transmissionx5 M/T
A/T

Non-reusable part
x6
x5
Engine Wire
- ENGINE MECHANICAL (2JZ-GTE)ENGINE UNIT
EM-57
1162 Author
: Date
:
1997 SUPRA (RM502U)

EM0AV-02
P11544
(2)(3)
(1) EM-58
- ENGINE MECHANICAL (2JZ-GTE)ENGINE UNIT
1163 Author
: Date
:
1997 SUPRA (RM502U)
REMOVAL
1. REMOVE HOOD
2. REMOVE RADIATOR ASSEMBLY
(See page CO-22)
3. DRAIN ENGINE OIL
4. DRAIN FUEL FROM FUEL TANK
5. REMOVE NO.1 AIR HOSE
6. DISCONNECT CONTROL CABLES FROM
THROTTLE BODY
Disconnect these cables:

Accelerator cable

Cruise control actuator cable
7. REMOVE AIR CLEANER AND MAF METER
ASSEMBLY
(a) Remove the 3 bolts.
(b) Loosen the hose clamp, disconnect the air hose from the
intake air connector.
(c) Disconnect the MAF meter wire from the clamp on the air
cleaner case.
(d) Disconnect the MAF meter connector, and remove the air
cleaner and MAF meter assembly.
8. M/T:
REMOVE DRIVE BELT TENSIONER DAMPER
(See page EM-15)
9. REMOVE DRIVE BELT, FAN, FLUID COUPLING
ASSEMBLY AND WATER PUMP PULLEY
(See page CO-7)
10. REMOVE CHARCOAL CANISTER
11. DISCONNECT HEATER WATER HOSES
12. DISCONNECT BRAKE BOOSTER VACUUM HOSE
13. DISCONNECT EVAP HOSE
14. DISCONNECT WIRES AND CONNECTORS
(a) Disconnect these connectors:
(1) Solenoid resistor connector
(2) Noise filter connector
(3) Igniter connectors
(b) Disconnect the engine wire from the PS oil reservoir pro-
tector
.

P11919
P11910
Starter
WireDisconnect
P11643
Fuel Inlet Hose
P12534Fuel Return Hose
P11642
(2)
(1)
- ENGINE MECHANICAL (2JZ-GTE)ENGINE UNIT
EM-59
1164 Author
: Date
:
1997 SUPRA (RM502U)
(c) Disconnect the connector from the engine room main
wire.
(d) Disconnect the engine wire from the 2 wire clamps.
(e) Remove the rubber cap and nut, and disconnect the gen-
erator wire.
(f) Disconnect the wire clamp and PS solenoid valve con-
nector.
(g) Remove the bolt and disconnect the ground strap from
the cylinder block.
(h) Disconnect the starter wire from the LH engine mounting
bracket.
(i) Remove the rubber cap and nut, and disconnect the start-
er wire.
15. DISCONNECT FUEL HOSES
(a) Remove the union bolt and 2 gaskets, and disconnect the
fuel inlet hose.
HINT:

Put a suitable container or shop rag under the fuel pipe
support.

Slowly loosen the union bolt.
(b) Suspend the hose union end upward.
(c) Disconnect the fuel return hose from the clamp of the dip-
stick guide.
(d) Disconnect the fuel return hose from the fuel return pipe.
Plug the hose end.
16. DISCONNECT PS PUMP WITHOUT
DISCONNECTING HOSES
(a) Disconnect these hoses:
(1) PS air hose from throttle body
(2) PS air hose from air intake chamber
(b) Remove the 2 bolts, and disconnect the vane pump from
the pump bracket.
HINT:
Put aside the vane pump, and suspend it securely.
(c) Remove the 3 bolts and pump bracket.

P11534
P11524
P11540
P11763
P11761
EM-60
- ENGINE MECHANICAL (2JZ-GTE)ENGINE UNIT
1165 Author
: Date
:
1997 SUPRA (RM502U)
17. DISCONNECT PS PRESSURE FEED HOSE FROM
ENGINE
Remove the 2 clamp bolts and disconnect the pressure feed
hose.
18. DISCONNECT A/C COMPRESSOR WITHOUT
DISCONNECTING HOSES
(a) Remove the 2 bolts.
(b) Disconnect the compressor connector.
(c) Remove the bolt and nut.
(d) Using a torx socket (E10), remove the stud bolt, and dis-
connect the compressor from the engine.
HINT:
Put aside the compressor, and suspend it securely.
19. DISCONNECT ENGINE WIRE FROM COWL PANEL
(a) Remove the bolt, and disconnect the ground strap.
(b) Remove the 2 bolts, and disconnect the engine wire pro-
tector.
(c) Remove the 2 bolts holding the engine wire retainer to the
cowl panel.

P11984
P11768
Z16718
M/T
Z16719
M/T
Z16720
M/T
Ground Strap
- ENGINE MECHANICAL (2JZ-GTE)ENGINE UNIT
EM-61
1166 Author
: Date
:
1997 SUPRA (RM502U)
20. DISCONNECT ENGINE WIRE FROM CABIN
(a) Remove the scuff plate.
(b) Take out the front side of the floor carpet.
(c) Remove the 2 nuts and ECM protector.
(d) Remove the nut, and disconnect the ECM from the floor
panel.
(e) Disconnect the 2 connectors from the ECM.
(f) Disconnect the connector from the TRAC ECU.
(g) Disconnect the connector from the instrument panel wire.
(h) Disconnect the 2 connectors from the connector cas-
sette.
(i) Pull out the engine wire from the cabin.
21. M/T:
REMOVE UPPER CONSOLE PANEL, SHIFT LEVER
BOOTS AND HOLDING BOLTS
(a) Remove the shift lever knob.
(b) Using a screwdriver, pry out the upper console panel.
(c) Remove the 4 bolts holding the lever boot to the transmis-
sion cover.
(d) Remove the shift & select lever boots.
(e) Remove the 4 bolts holding the shift lever to the shift lever
retainer.
22. M/T:
DISCONNECT CLUTCH RELEASE CYLINDER AND
GROUND STRAP FROM TRANSMISSION
(a) Remove the 2 bolts, and disconnect clutch release cylin-
der.
(b) Remove the bolt, and disconnect the clutch line tube.
(c) Remove the bolt, and disconnect ground strap.

P12054
P11554
P11796
Z09426
Normal Roof
Sport Roof EM-62
- ENGINE MECHANICAL (2JZ-GTE)ENGINE UNIT
1167 Author
: Date
:
1997 SUPRA (RM502U)
23. PDISCONNECT HEATED OXYGEN SENSOR FROM
FRONT EXHAUST PIPE
Remove the 2 nuts, and disconnect oxygen sensor and gasket.
24. REMOVE EXHAUST PIPE ASSEMBLY
(a) Remove the 2 bolts and nuts holding the front exhaust
pipe to the No.2 front exhaust pipe.
(b) Remove the 2 bolts and pipe support bracket.
(c) Remove the gasket, and disconnect the front exhaust
pipe.
(d) Disconnect the hook of the tailpipe from the 2 rings.
(e) Disconnect the 2 rings on the exhaust pipe from the ex-
haust pipe brackets, and remove the exhaust pipe as-
sembly.
25. REMOVE NO.2 FRONT EXHAUST PIPE
Remove the 3 nuts, front exhaust pipe and gasket.
26. REMOVE EXHAUST PIPE HEAT INSULATOR
Remove the 4 nuts and heat insulator.
27. REMOVE REAR CENTER FLOOR CROSSMEMBER
BRACE
Remove the 4 bolts (Normal roof) or 6 bolts (Sport roof) and
crossmember brace.
28. REMOVE PROPELLER SHAFT
(See page PR-4)