1994 CHEVROLET CAMARO Owners Manual

Downloaded from www.Manualslib.com manuals search engine 6. Connect the red positive (+) cable to
the positive
(+) terminal of the vehicle
with the dead battery. Use a remote
positive
(+) terminal if the vehicle
has one.
7. Don‘t let the other end touch metal.
Connect
it to the positive (+) terminal
of the good battery. Use a remote
positive
(+) terminal if the vehicle
has one. But don’t use the junction
block
on your Chevrolet.
a. Now connect the black negative (-)
cable to the good battery’s negative
(-) terminal.
Don’t let the other end touch anything
until the next step. The other end of
the negative cable doesn’t go to the
dead battery.
It goes to a heavy
unpainted metal part
on the engine of
the vehicle with the dead battery.
151 .,

Downloaded from www.Manualslib.com manuals search engine Problems on the Road
9.
0.
Attach the cable at least 18 inches
(45 cm) away from the dead battery,
but not near engine parts that move.
The electrical connection is just
as
good there, but the chance of sparks
getting back to the battery is much
less.
Now start the vehicle
with the good
battery and
run the engine for a
while.
-. 152
1.
2.
Try to start the vehicle with the dead
battery.
If it won't start after a few tries, it
probably needs service.
Remove the cables
in reverse order
to prevent electrical shorting. Take
care that they don't touch each other
or any other metal.
A. Heavy Metal Engine Part
B. Good Battery
c. Dead Battery
A
I Towing Your Vehicle
?y to have a GM dealer or a professional
]wing service tow your Chevrolet. The
sua1 towing equipment is a sling-type
A) or a wheel-lift (B) or car carrier (C)
3w truck.
f your vehicle has been changed or
nodified since
it was factory-new by
Idding aftermarket items like fog lamps,
Lero skirting, or special tires and wheels,
hese instructions and illustrations may
tot be correct.
3efore you do anything, turn on the
lazard warning flashers.

Downloaded from www.Manualslib.com manuals search engine When you call, tell the towing service:
0 That your vehicle cannot be towed
from the front or rear with sling-type
equipment.
drive.
That your vehicle has rear-wheel
0 The make, model, and year of your
0 Whether you can still move the shift
0 If there was an accident, what was
When the towing service arrives, let the
tow operator know that this manual
contains detailed towing instructions and
illustrations. The operator may want
to
see them.
vehicle.
lever.
damaged.
153 .I I.

Downloaded from www.Manualslib.com manuals search engine Problems on the Road
When your vehicle is being towed, have
the ignition key off. The steering wheel
should be clamped
in a straight-ahead
position, with a clamping device designed
for towing service. Do not use the
vehicle’s steering
column lock for this,
The transmission should be in “Neutral”
and the parking brake released.
Don’t have your vehicle towed on the rear
wheels, unless
you must. If the vehicle
must be towed on the rear wheels, don’t
go more than 35 mph (55 km/h) or
farther than
50 miles (80 km) or your
transmission will be damaged. If these
limits
must be exceeded, then the rear
wheels have to be supported on a
dolly.
?ront Towing Hook-Ups
Ittach T-hook chains to slots in frame
*earward of front wheels on both sides.
NOTICE:
Do not attach winch cables or “J”
hooks to suspension components
when using car carrier equipment.
Always use T-hooks inserted in the
T-hook
slots.
. . .154

Downloaded from www.Manualslib.com manuals search engine NOTICE:
Do not tow with sling-type equip-
ment or fascia/fog light damage
will
occur.
Use wheel
lift or car carrier equip-
ment. Additional ramping may be
required for car carrier equipment.
Use safety chains and wheel straps. Attach
a separate safety chain around
outboard end
of each lower control arm.
I
NOTICE:
I
Take care not to damage the brake
pipes and hoses or the ABS sensor
and wiring.
NOTICE:
Towing a vehicle over rough surfaces
could damage a vehicle. Damage
can occur from vehicle-to-ground
or vehicle-to-wheel-lift-equipment
contact. To help avoid damage,
install a towing dolly and raise
vehicle
until adequate clearance is
obtained between the ground and/or
wheel-lift equipment.
155 ...

Downloaded from www.Manualslib.com manuals search engine Problems on the Road
I I
I
Rear Towing Hook-Ups
Attach T-hook chains in front of rear
wheels
in bottom of frame rail on both
sides.
NOTICE:
Do not attach winch cables or "J"
hooks to suspension components
when using car carrier equipment.
Always use T-hooks inserted
in the
T-hook slots.
NOTICE:
Do not tow with sling-type equip-
ment or rear bumper valance will be
damaged.
Use wheel lift or car carrier equip-
ment. Additional ramping may be
required for car carrier equipment.
Use safety chains and wheel straps. 4ttach
a separate
safety chain around
jutboard end
of the rear axle.
NOTICE:
Take care not to damage the brake
pipes and cables.
. . .156

Downloaded from www.Manualslib.com manuals search engine NOTICE:
Towing a vehicle over rough
surfaces could damage
a vehicle.
Damage can occur from
vehicle-
to-ground or vehicle-to-wheel-lift-
equipment contact.
To help avoid
damage, install a towing dolly
and raise vehicle
until adequate
clearance
is obtained between the
ground and/or wheel-lift equipment.
Engine Overheating
You will find a coolant temperature gage
Dn your Chevrolet’s instrument panel.
You may also find a low coolant warning
light on your Chevrolet instrument panel.
If Steam Is Coming from Your Engine:
157.. .

Downloaded from www.Manualslib.com manuals search engine Problems on the Road
NOTICE:
If your engine catches fire because
you keep driving with
no coolant,
your vehicle can be badly damaged.
The costly repairs would not be
covered by your warranty.
If No Steam Is Coming from Your
Engine:
If you get the overheat warning but see or
hear no steam, the problem may not be
too serious. Sometimes
the engine can gel
a little too hot when you:
0 Climb a long hill on a hot day.
0 Stop after high speed driving.
0 Idle for long periods in traffic.
Tow a trailer.
If you get
the overheat warning with no
sign of steam,
try this for a minute or so:
1. If you have an air conditioner, turn it
2. Turn on your heater to full hot at the
off.
highest fan speed and open
the
window as necessary.
3. Tr!
to keep your engine under load
(in a drive gear where the engine runs
slower).
[f you no longer have the overheat
warning, you can drive. Just to be safe,
drive slower for about ten minutes. If the
warning doesn’t come back on,
you can
drive normally.
[f the warning continues, pull over, stop,
and park your vehicle right away.
If there’s still no sign of steam, you can
idle the engine for two or three minutes
while you’re parked, to see if the warning
stops. But
then, if you still have the
warning, TURN
OFF THE ENGINE
AND GET EVERYONE
OUT OF THE
VEHICLE until it cools down.
You may decide not to lift the hood but to
get service help right away.
Cooling System
When you decide it’s safe to lift the hood,
here’s what you’ll see on the
V6 engine:
1. Coolant recovery tank
2. Radiator pressure cap
3. Electric engine fan
. . .158