1994 CHEVROLET CAMARO oil type

Downloaded from www.Manualslib.com manuals search engine Don’t use any of these unless this manual
says you can.
In many uses, these will
damage your vehicle:
Alcohol
Laundry Soap
0 Bleach
Reducing Agents
Cleaning the lnside of Your
Chevrolet
Use a vacuum cleaner often to get rid of
dust and loose dirt. Wipe
vinyl or leather
with a clean, damp cloth.
Your Chevrolet dealer has two
GM
cleaners - a solvent-type spot lifter and
a foam-type powdered cleaner. They will
clean normal spots and stains
very well.
Do not use them on vinyl or leather.
Here are some cleaning tips:
0 Always read the instructions on the
Clean up stains as soon as you can -
0 Use a clean cloth or sponge, and
cleaner label.
before they
set.
change
to a clean area often. A soft
brush may be used if stains are
stubborn.
0 Use solvent-type cleaners in a
well-ventilated area only.
If you use
them, don’t saturate the stained area.
clean the
entire area immediately or it
will set.
If a ring forms after spot cleaning,
Using Foam-Type Cleaner on Fabric
Vacuum and brush the area to remove
any loose dirt.
Always clean a whole trim panel or
section.
Mask surrounding trim along
stitch or
welt lines.
Mix Multi-Purpose Powdered Cleaner
following the directions on the
container label.
Use suds only and apply
with a clean
sponge.
Don’t saturate the material.
Don’t rub
it roughly.
As soon as you’ve cleaned the section,
use a sponge to remove the suds.
Rinse the section
with a clean, wet
sponge.
Wipe off what’s left
with a slightly
damp paper towel or cloth.
Then dry
it immediately with a blow
dryer or
a heat lamp.
I NOTICE:
I
Be careful with a hair dryer or heat
lamp. You could scorch
the fabric. I
Wipe with a clean cloth.
Using Solvent-’1[Sipe Cleaner on Fabric
First, see if you have to use solvent-type
:leaner
at all. Some spots and stains will
:lean off better with just water and mild
;oap.
If you need to use a solvent:
Gently scrape excess soil from the
trim material with a clean, dull knife
or scraper. Use very little cleaner, light
pressure and clean cloths (preferably
cheesecloth). Cleaning should start at
the outside
of the stain, “feathering”
toward the center. Keep changing to a
clean section of the cloth.
When you clean
a stain from fabric,
immediately dry the area
with an air
hose, hair dryer, or heat lamp to help
prevent a cleaning ring. (See the
previous NOTICE.)
221 . . .

Downloaded from www.Manualslib.com manuals search engine Service and Appearance Care
Fabric Protection
Your Chevrolet has upholstery and carpet
that has been treated
with Scothgardm
Fabric Protector, a 3M product.
Scotchgard- protects fabric by repelling
oil and water, which are the carriers of
most stains. Even
with this protection,
you still need
to clean your upholstery
and carpet often to keep
it looking new.
Further information on cleaning is
available by calling 1-800-433-3296
(in
Minnesota, 1-800-642-6 167).
Special Cleaning Problems
Greasy or oily stains:
Such as grease,
oil, butter, margarine, shoe polish, coffee
with cream, chewing gum, cosmetic
creams, vegetable oils, wax crayon, tar
and asphalt.
0
0
0
Carefully scrape off excess stain.
Follow the solvent-type instructions
described earlier.
Shoe polish, wax crayon, tar and
asphalt
will stain if left on a vehicle
seat fabric. They should be removed
as soon as possible. Be careful,
because the cleaner
will dissolve
them and may cause them to spread.
Non-greasy stains: Such as catsup,
coffee (black), egg, fruit,
fruit juice, milk,
soft drinks, wine, vomit, urine and blood.
0 Carefully scrape off excess stain, then
sponge the soiled area
with cool water.
0 If a stain remains, follow the
foam-type instructions above.
or urine, treat the area
with a
waterbaking soda solution:
1 teaspoon (5 ml) of baking soda to
1 cup (250 ml) of lukewarm water.
solvent-type cleaner.
0 If an odor lingers after cleaning vomit
0 If needed, clean lightly with
Combination stains: Such as canay,
ice cream, mayonnaise, chili sauce and
unknown stains.
Carefully scrape off excess stain, then
clean
with cool water and allow to
dry.
solvent-type cleaner.
0 If a stain remains, clean it with
Cleaning Vinyl
Use warm water and a clean cloth.
0 Rub with a clean, damp cloth to
remove dirt. You may have to do
it
more than once.
Things like tar, asphalt and shoe
polish
will stain if you don’t get them
off quickly. Use a clean cloth and
solvent-type
vinyl cleaner.
Cleaning Leather
Use a soft cloth with lukewarn water and
a mild soap or saddle soap.
For stubborn stains, use a mild
solution of 10% isopropyl alcohol
(rubbing alcohol) and 90% water.
Never use oils, varnishes,
solvent-based or abrasive cleaners,
furntiure polish or shoe polish on
leather.
Soiled leather should be cleaned
immediately. If
dirt is allowed to work
into finish,
it can harm the leather.
Cleaning the Top of the Instrument
Panel
Use only mild soap and water to clean the
top surfaces of the instrument panel.
Sprays containing silicones or waxes may
cause annoying reflections
in the
windshield and even make
it difficult to
see through the windshield under certain
conditions.
. . .222

Downloaded from www.Manualslib.com manuals search engine Maintenance Schedule
Section A: Scheduled Maintenance Services (cont.)
Explanation of Scheduled
Maintenance Services
Following are explanations of the services
listed in Schedule
I and Schedule 11.
The proper fluids and lubricants to use are
listed
in Section D. Make sure whoever
services your vehicle uses these. All parts
should be replaced and all necessary
repairs done before you or anyone else
drives the vehicle.
NOTE: To determine your engine’s
displacement and code, see
“Engine Identification”
in the
Index.
ITEM
NO. SERVICE
1 Engine Oil and Filter Change” -
Always use SH or SG Energy
Conserving I1 oils of proper
viscosity. The
“SH” or “SG”
designation may be shown alone
or
in combination with others,
such as “SH/CD,”
“SH, SG,
CD,” “SG/CD,” etc. To deter-
mine the preferred viscosity for
your vehicle’s engine (e.g., SAE
ITEM
NO.
2
3
4
SERVICE
5W-30 or SAE 1OW-30)’ see
“Engine Oil”
in the Index.
Chassis Lubrication
- Lubricate
the suspension and steering
linkage. Lubricate the
transmission shift linkage.
Tire and Wheel Rotation and
InsDection
- For proper wear
and maximum tire life, rotate
your tires following the
instructions
in this manual. See
“Tires, Inspection and Rotation”
in the Index. Check the tires for
uneven wear or damage. If you
see irregular or premature wear,
check the wheel alignment.
Check for damaged wheels also.
Engine Accessory Drive Belt(s)
Inspection
- Inspect the belt(s)
for cracks, fraying, wear and
proper tension. Replace as needed. (Belts can have many
small cracks
in individual ribs
without affecting performance.)
ITEM
NO. SERVICE
5 Cooling System Service* -
Drain, flush and refill the system
with new or approved recycled
coolant conforming to
GM
Specification 1825M. Keep
coolant at the proper mixture as
specified. See “Coolant”
in the
Index. This provides proper
freeze and boil protection,
corrosion inhibitor level and
maintains proper engine
operating temperature.
Inspect hoses and replace
if they
are cracked, swollen or deterior-
ated. Tighten screw-type hose
clamps. Clean the outside
of the
radiator and air conditioning
condenser. Wash the pressure
cap and neck.
To help ensure proper operation,
we recommend a pressure test of
both the cooling system and the
pressure cap.
* An Emission Control Service.
. . .244