2022 MERCEDES-BENZ CLS COUPE Owners Manual

cloth and wipe down with a dry cloth. Regu-
lar
ly clean the seat covers.
= For heavy soiling: use a leather care agent rec-
ommended for Mercedes-Benz asercare.
= Leather care: use a leather care agent that
has been recommended for Mercedes-Benz.
= Do not use a microNbre cloth.
= Do not allow the leather to become too damp.
= Do not use oil-based cleaning and care prod-
ucts.
% Leather is a natural product. It exhibits natural
sur
face properties such as diMerences in
structure, marks caused by growth and injury
or subtle colour diMerences. These surface
properties are characteristics of leather and
not material faults. Leather is also subject to
a natural ageing process during which the sur-
face properties change.
Waves or wrinkling in the seat cover may
occur due to the stress on the seat; this is
caused by the natural leather material.
Regular cleaning and care of the leather
reduces soiling, wear marks and ageing dam-
age and thus signiNcantly extends its life span. Clothing that can leave stains (e.g.
jeans) ma

y discolour the leather.
DINAMICA seat covers
= V

acuum up dirt such as crumbs or dust and
then use a damp cloth to clean.
= Do not use a microNbre cloth.
Imitation leather seat covers = Vacuum up dirt such as crumbs or dust and
then use a damp cotton cloth and a 1% soap
solution to clean the entire seat cover. Do not
spot clean.
= Use cleaning and care products recommen-
ded for Mercedes-Benz.
= Do not use a microNbre cloth.
= Do not use oil-based cleaning and care prod-
ucts.
Fabric seat covers
= Vacuum up dirt such as crumbs or dust and
then use a damp microNbre cloth and a 1%
soap solution to clean the entire seat cover.
Do not spot clean. =
Use cleaning and car
e products recommen-
ded for Mercedes-Benz.
= Do not use oil-based cleaning and care prod-
ucts. 318
Maintenance and care

Emergency
Removing the safety vest
The safety vests are located in the stowage com-
par
tments in the driver's and front passenger
door. 
Pull out the safety vest bag by the loop. 
Open the safety vest bag and pull out the
saf

ety vest.
% There are also safety vest compartments in
t

he rear door stowage compartments in which
safety vests can be stored. 1
Maximum number of washes
2 Maximum wash temperature 3
Do not bleach
4 Do not iron
5 Do not tumble dry
6 Do not dry clean
7 Class 2 safety vest
The requirements deNned b
y the legal standard
are only fulNlled if the safety vest is the correct
size and is fully closed.
Replace the safety vest in the following cases:
= The reOective strips are damaged or dirty
= The maximum permissible number of washes
is exceeded
= The Ouorescence property decreases, e.g. due
to permanent exposure to sunlight.
Dispose of the safety vest in an environmentally
friendly manner:
= Please contact your local waste disposal com-
pany. Warning triangle

qR
emoving the warning triangle

Push both sides of warning triangle holder 1
in t
he direction of the arrow and open it. 
Remove warning triangle 2. Breakdown assistance
319

qSetting up the warning triangle

Fold side r
eOectors 1 upwards to form a tri-
angle and attach at the top using upper press-
stud 2. 
Fold legs 3 do
wn and out to the side. First-aid kit
(sos sided) o
verview The Nr
st-aid
bag 1 is located on the les or right
side of the boot, depending on the vehicle ver-
sion.
% On vehicles with Burmester n
Sur
round Sound
System, the Nrst-aid bag is located in the boot
when the vehicle is delivered. Removing the Nr

e extinguisher &
WARNING Risk of accident due t
o an
incorrectly secured Nre extinguisher in the
driver's footwell
A Nr
e extinguisher may impede pedal travel or
block a depressed pedal.
This jeopardises the operating and road safety
of the vehicle.
The Nre extinguisher can be Oung around and
injure the driver or other vehicle occupants. 
Always store and secure the Nr
e extin-
guisher in the bracket. 
Do not remove the Nr
e extinguisher while
driving. 320
Breakdown assistance


Les-hand drive vehicle: pull tab 1 upwards.
Right-hand drive vehicle: pull t
ab 1 down-
wards. 
Remove Nr
e extinguisher 2. Flat tyre
Notes on Oat
tyr
es &
WARNING Risk of accident due t
o a Oat
tyre
A Oat tyr
e severely aMects the driving charac-
teristics as well as the steering and braking of
the vehicle. Tyres without
r
un-Oat characteristics: 
Do not drive with a Oat tyr
e. 
Change the Oat tyr
e immediately with an
emergency spare wheel or spare wheel.
Alternatively, consult a qualiNed special-
ist workshop.
Tyres with r
un-Oat characteristics: 
Observe the information and warning
no
tes on MOExtended tyres (run-Oat
tyres). In the event of a Oat
tyr
e, the following options are
available depending on your vehicle's equipment:
= Vehicles with MOExtended tyres: it is possible
to continue the journey for a short period of
time. Make sure you observe the notes on
MOExtended tyres (run-Oat tyres)
( page 321).
= Vehicles with a TIREFIT kit: you can seal the
tyre so that it is possible to continue the jour-
ney for a short period of time. To do this, use
the TIREFIT kit ( page 323). =
V
ehicles with Mercedes me connect: you can
make a call for breakdown assistance via the
overhead control panel in the case of a break-
down (  page 282).
= All vehicles: change the wheel (  page 350). Notes on MOExtended tyres
(r
un-Oat tyres) &
WARNING Risk of accident when dr
iving in
limp-home mode
Driving in emergency mode impairs the han-
dling c
haracteristics of the vehicle. 
Do not exceed the permissible maximum
speed of t
he MOExtended tyres. 
Avoid any abrupt steering and driving
manoeuvr
es as well as driving over
obstacles (kerbs, pot holes, oM-road).
This applies, in particular, to a loaded
vehicle. 
Stop driving in the emergency mode if
y

ou notice:
= banging noise Breakdown assistance
321

=
v ehicle vibration
= smoke which smells like rubber
= continuous ESP n
intervention
= cracks in the tyre sidewalls 
Aser dr
iving in emergency mode, have
the rims checked by a qualiNed specialist
workshop with regard to their further
use. 
The defective tyre must be replaced in
e

very case. With MOExtended tyres
(r
un-Oat tyres), you can
continue to drive your vehicle even if there is a
total loss of pressure in one or more tyres. How-
ever, the tyre aMected must not show any clearly
visible damage.
You can recognise MOExtended tyres by the
MOExtended marking which appears on the side
wall of the tyre.
Vehicles with tyre pressure loss warning system:
MOExtended tyres may only be used in conjunc-
tion with an activated tyre pressure loss warning
system. Vehicles with tyre pressure monitoring system:
MOExt

ended tyres may only be used in conjunc-
tion with an activated tyre pressure monitoring
system.
If a pressure loss warning message appears in the
driver's display, proceed as follows:
= Check the tyre for damage.
= If driving on, observe the following notes.
Driving distance possible in emergency mode
aser the pressure loss warning: Load condition Driving distance possi-
ble in emer
gency mode
Partially laden 80 km
Fully laden 30 km The driving distance possible in emergency mode
ma
y vary depending on the driving style. Observe
the maximum permissible speed of 80 km/h.
If a tyre has gone Oat and cannot be replaced with
an MOExtended tyre, you can use a standard tyre
as a temporary measure. TIREFIT kit storage location
The TIREFIT kit is located under the boot
Ooor
. 1
Tyre sealant bottle
2 Tyre inOation com
pressor
Depending on the vehicle version, the TIREFIT kit
ma
y be located in other positions under the boot
Ooor.
% You can Nnd inf
ormation on the power cate-
gory (LK) and/or electrical data on the back
of the tyre inOation compressor:
= LK2 !

At a distance of approximately 1 m to the tyre
inOation com
pressor and approximately 1.6 m
above the ground, the following sound pres-
sure levels apply:
= Emissions sound pressure level
L
PA 83 dB (A)
= Sound power level L
WA 91 dB (A)
The tyre inOation compressor is maintenance-
free. If there is a malfunction, please contact
a qualiNed specialist workshop. Using the TIREFIT kit
Requirements:
= T

yre sealant bottle and tyre inOator compres-
sor are ready for use ( page 322).
= TIREFIT sticker is present.
= Gloves are present.
You can use TIREFIT tyre sealant to seal perfora-
tion damage of up to 4 mm, particularly those in
the tyre contact surface. You can use TIREFIT in
outside temperatures down to -20 °C. &
WARNING Risk of accident when using
tyr
e sealant
The tyre sealant may be unable to seal the
tyr
e properly, especially in the following cases:
= there are large cuts or punctures in the
tyre (larger than damage previously men-
tioned)
= the wheel rims have been damaged
= aser journeys with very low tyre pressure
or with Oat tyres 
Do not continue driving. 
Consult a q
ualiNed specialist workshop. &
WARNING Risk of injur
y and poisoning
from tyre sealant
Tyre sealant is hazardous to health and causes
ir
ritation. Do not allow it to come into contact
with your skin, eyes or clothing, and do not
swallow it. Do not inhale any vapours. Keep
the tyre sealant away from children. Observe the following if you come into contact
wit
h the tyre sealant: 
Rinse oM t
he tyre sealant from your skin
using water immediately. 
If tyre sealant gets into your eyes, thor-
oughl

y rinse them using clean water
immediately. 
If tyre sealant has been swallowed, thor-
oughl
y rinse out your mouth immediately
and drink plenty of water. Do not induce
vomiting and seek medical attention
immediately. 
Change out of clothing which has come
int

o contact with tyre sealant immedi-
ately. 
If an allergic reaction occurs, seek medi-
cal att

ention immediately. *
NOTE Ov
erheating due to the tyre inOation
compressor running too long 
Do not run the tyre inOation com
pressor
for longer than ten minutes without inter-
ruption. Breakdown assistance
323

Comply with the manufacturer's safety notes on
t
he sticker on the tyre inOation compressor.
Have the tyre sealant bottle replaced in a qualiNed
specialist workshop every Nve years.
Do not remove any foreign objects which have
ent

ered the tyre. 
APx par
t 1 of the TIREFIT sticker to the
instrument cluster within the driver's Neld of
vision. 
APx par
t 2 of the TIREFIT sticker near the
valve on the wheel with the defective tyre. 
Pull plug 4 wit
h the cable and hose 5 out
of the tyre inOation compressor housing. 
Push the plug of hose 5 int
o Oange 6 of
tyre sealant bottle 1 until the plug engages. 
Place tyre sealant bottle 1 head do
wnwards
into recess 2 of the tyre inOation compres-
sor. 
Remove the valve cap from valve 7
on the
faulty tyre. 
Screw Nlling hose 8 ont
o valve 7. 
Insert plug 4 int
o a 12!


Let the tyre inOation com pressor run for a
maximum of ten minutes.
The tyre should then have attained a tyre pres-
sure of at least 200 kPa (2.0 bar/29 psi).
If tyre sealant leaks out, make sure you clean the
aMect
ed area as quickly as possible. It is prefera-
ble to use clean water.
If you get tyre sealant on your clothing, have it
cleaned as soon as possible with perchloroethy-
lene.
If, aser ten minutes, a tyre pressure of 200 kPa
(2.0 bar/29 psi) has not been attained: 
Switch oM t
he tyre inOation compressor. 
Unscrew the Nlling hose fr
om the valve of the
defective tyre.
Please note that tyre sealant may leak out when
unscr
ewing the Nlling hose. 
Drive forwards or in reverse very slowly for
appr
oximately 10 m. 
Pump up the tyre again.
Aser a maximum of t

en minutes the tyre pres-
sure must be at least 200 kPa (2.0 bar/
29 psi). &
WARNING Risk of accident due t
o the
speciNed tyre pressure not being attained
If the speciNed tyr
e pressure is not attained
aser the speciNed time, the tyre is too badly
damaged. The tyre sealant cannot repair the
tyre in this instance.
The braking and driving characteristics may be
greatly impaired. 
Do not continue driving. 
Consult a q
ualiNed specialist workshop. If, aser
t
en minutes, a tyre pressure of 200 kPa
(2.0 bar/29 psi) has been attained: 
Switch oM t
he tyre inOation compressor. 
Unscrew the Nlling hose fr
om the valve of the
defective tyre. &
WARNING Risk of accident fr
om driving
with sealed tyres
A tyre temporarily sealed with tyre sealant
im
pairs the handling characteristics and is not
suitable for higher speeds. 
Adapt your driving style accordingly and
dr

ive carefully. 
Do not exceed the maximum speed limit
wit
h a tyre that has been repaired using
tyre sealant. 
Observe the maximum permissible speed of
80 km/h

for a tyre sealed with tyre sealant.
* NOTE S
taining from leaking tyre sealant Aser
use, e
xcess tyre sealant may leak out
from the Nlling hose. 
Therefore, place the Nlling hose in t
he
plastic bag that contained the TIREFIT
kit. Breakdown assistance
325