2019 MITSUBISHI L200 Owner's Manual (in English)

2- Rear window demister switch o p. 5-25
3- Blower speed selection dial
4- Air conditioning switch*
5- Temperature control dial
6- Air selection leverBlower speed selection dial
Select the blower speed by turning the blower
speed selection dial clockwise or anticlock- wise.
The blower speed will gradually increase as
the dial is turned to the right.
Temperature control dial
Turn the temperature control dial clockwise
to make the air warmer. Turn it anticlockwise to make the air cooler.
NOTEz While the engine coolant temperature is low,
the temperature of the air from the heater will be cool/cold until the engine warms up, even if you have selected warm air with the
dial.Mode selection dial
To change the position of air flowing from
the ventilators, turn the mode selection dial.
(Refer to “Mode selection” on page 7-03.)
CAUT,ONz When using the mode selection dial between
the “” and “” positions, prevent fog-
ging by moving the air selection lever to se-
lect outside air. (Refer to “Air selection lever” on page 7-06.)
Heater/Manual air conditioning*
7-052.7((For pleasant driving7

NOTEzWith the mode selection dial between the
“” and “” positions, air flows mainly
to the upper part of the passenger compart-
ment. With the mode selection dial between
the “
” and “” positions, air flows
mainly to the leg area.
z With the mode selection dial between the
“
” and “” positions, air flows mainly
to the leg area. With the mode selection dial
between the “
” and “” positions, air
flows mainly to the windscreen and door
windows.
Air selection lever
To change the air selection, use the air selec-
tion lever.
z “
” Outside air
Outside air is introduced into the passen-
ger compartment.
z “
” Recirculated air
Air is recirculated inside the passenger
compartment.CAUT,ONz Use of the “” (recirculation) position for
extended time may cause the windows to fog up.NOTEz Normally, use the “” (outside) position to
keep the windscreen and side windows clear
and quickly remove fog or frost from the windscreen.
If high cooling performance is desired, or if
the outside air is dusty or otherwise contami-
nated, use the “
” (recirculation) position.
Switch to the “
” (outside) position peri-
odically to increase ventilation so that the windows do not become fogged up.
Air conditioning switch*
Push the switch to turn the air conditioning
on, indication lamp (A) will come on.
Push the switch again to switch it off.
Operating the air conditioning
system
Select dials and levers as shown in the illus-
tration according to your purpose.
Heater/Manual air conditioning*
7-062.7((For pleasant driving7

HeatingNOTEzFor maximum heat, set the blower speed at
the 3 rd
position.Cooling (Manual air condition-
ing)CAUT,ONz If the outside air is dusty or otherwise conta-
minated, or if high cooling performance is
desired, set air selection lever to the “
”
(recirculation) position and the temperature control dial all the way to the right.
Switch to the “
” (outside) position peri-
odically to increase ventilation so that the windows do not become fogged up.
Combination of unheated air
and heated airDemisting of the windscreenand door windowsCAUT,ONz For safety, make sure you have a clear view
through all the windows.
Heater/Manual air conditioning*
7-072.7((For pleasant driving7LHD
RHD LHD
RHD LHD
RHD

For ordinary demistingFor quick demistingNOTEzTo demist effectively, direct the air flow
from the side ventilators towards the door
windows.
z Do not set the temperature control dial to the
max. cool position. Cool air will blow
against the window glasses and prevent de- misting.Introduction of outside air
Heater/Manual air conditioning*
7-082.7((For pleasant driving7RHD
LHD LHD
RHD LHD
RHD

Automatic climate control air conditioner*
The air conditioner can only be used while the engine is running.CAUT,ONz The engine speed may increase when the air conditioning is operating. With an increased engine speed, an
A/T vehicle will creep to a greater degree than
with a lower engine speed. Fully depress the brake pedal to prevent the vehicle from creeping.

Control panel1- Temperature control switch
2- Air conditioning switch
3- MODE switch
4- Blower speed selection switch5- Air selection switch
6- Demister switch
7- AUTO switch
8- Rear window demister switch o p. 5-259- OFF switch
10- Temperature display o p. 7-11
11- Air conditioning indicator
12- Mode selection display
Automatic climate control air conditioner*
7-092.7((For pleasant driving7 Automatic climate control air conditioner - Type 1

13- Blower speed display1-Driver’s side temperature control switch
(LHD vehicles)
Passenger’s side temperature control
switch (RHD vehicles)
2- Air conditioning switch
3- Blower speed selection switch
4- MODE switch
5- Passenger’s side temperature control
switch (LHD vehicles)
Driver’s side temperature control switch
(RHD vehicles)
6- Air selection switch
7- Demister switch
8- AUTO switch
9- Rear window demister switch o p. 5-25
10- OFF switch11- Driver’s side temperature display (LHD
vehicles) o p. 7-11
Passenger’s side temperature display
(RHD vehicles) o p. 7-11
12- DUAL indicator
13- Mode selection display
14- Passenger’s side temperature display
(LHD vehicles) o p. 7-11
Driver’s side temperature display (RHD
vehicles) o p. 7-11
15- Air conditioning indicator
16- Blower speed displayNOTEz There is an interior air temperature sensor
(A) in the illustrated position.
Never place anything on top of the sensor,
since doing so will prevent it from function- ing properly.
Automatic climate control air conditioner*
7-102.7((For pleasant driving7Dual-zone automatic climate control air conditioner - Type 2

NOTEzIn extreme cold, the air conditioning control
panel screen may operate sluggishly. This does not indicate a problem.
It will disappear when the vehicle interior
temperature rises to a normal temperature.Blower speed selection switch
Press of the blower speed selection
switch to increase the blower speed.
Press
of the blower speed selection
switch to decrease the blower speed.
The selected blower speed will be shown in
the display (A).
1- Increase
2- Decrease
Temperature control switch
Press or of the temperature control
switch to the desired temperature.
The selected temperature will be shown in
the display (A).

NOTEz The temperature value of air conditioner is
switched in conjunction with outside temper-
ature display unit of the multi information
display.
Refer to “Changing the temperature unit” on
page 5-10.NOTEz While the engine coolant temperature is low,
the temperature of the air from the heater will be cool/cold until the engine warms up, even if you have selected warm air with the
switch.
To prevent the windscreen and windows
from fogging up, the ventilator mode will be
changed to “
” and the blower speed will
be reduced while the system is operating in the AUTO mode.
z When the temperature is set to the highest or
the lowest, the air selection and the air con-
ditioner will be automatically changed as follows.
Also, if the air selection is operated manual-
ly after an automatic changeover, manual operation will be selected.

For further information, we recommend youto consult a MITSUBISHI MOTORS Au-
thorized Service Point.
Refer to “Customizing the air conditioning switch” on page 7-13.
Refer to “Customizing the air selection” on
page 7-12.
Synchronized mode and dual mode*
The driver’s side and the passenger’s side temperature can be controlled independently.
At this time, the “DUAL” indicator will be shown in the display (A).
z Synchronized mode
If the driver’s side temperature control switch is pressed, the passenger’s side
temperature will also be controlled to the
same setting temperature as the driver’s side.
z Dual mode
If the passenger’s side temperature con-
trol switch is pressed under synchron-
ized mode, the system will switch to du- al mode. In dual mode, the driver’s side
and the passenger’s side temperature can be set separately by using each tempera-
ture control switch.
Press the AUTO switch to return to synchronized mode.Air selection switch
To change the air selection, simply press theair selection switch.
z Outside air: Indication lamp (A) is OFF
Outside air is introduced into the passen-
ger compartment.
z Recirculated air: Indication lamp (A) is
ON
Air is recirculated inside the passenger
compartment.
CAUT,ONz Use of the recirculation position for exten-
ded time may cause the windows to fog up.NOTEz Normally, use the outside position to keep
the windscreen and side windows clear and
quickly remove fog or frost from the wind- screen.
If high cooling performance is desired, or if
the outside air is dusty or otherwise contami- nated use the recirculation position. Switch
to the outside position periodically to in- crease ventilation so that the windows do notbecome fogged up.
z When the engine coolant temperature rises
to a certain level, the air selection is auto- matically switched to the recirculation posi-
tion and the indication lamp (A) comes on. At this time, the system will not switch tothe outside position even if the air selection
switch is pressed.Customizing the air selection
Functions can be changed as desired, as sta-
ted below.
z Enable automatic air control
When the AUTO switch is pressed, the
air selection switch is also controlled au- tomatically.

Automatic climate control air conditioner*
7-122.7((For pleasant driving7