2019 MITSUBISHI L200 Owner's Manual (in English)

tire type octane maintenance fuse box engine coolant fuse

Page 145 of 458

MITSUBISHI L200 2019 Owners Manual (in English) �M�a�n�u�a�l� �t�r�a�n�s�m�i�s�s�i�o�n�*
�T�h�e� �s�h�i�f�t� �p�a�t�t�e�r�n� �i�s� �s�h�o�w�n� �o�n� �t�h�e� �g�e�a�r�s�h�i�f�t �l�e�v�e�r� �k�n�o�b�.� �T�o� �s�t�a�r�t� �o�f�f�,� �d�e�p�r

Manual transmission*
The shift pattern is shown on the gearshift lever knob. To start off, depress the clutch
pedal all the way down and shift into 1 st
or
“R” (Reverse) position.
Then operate the gearshift lever slowly. Af- terwards gradually release the clutch pedal
while depressing the accelerator pedal.CAUT,ONz Do not put the gearshift lever into the re-
verse position while the vehicle is moving forward. Doing so could damage the trans-
mission.
z Do not rest your foot on the clutch pedal
while driving as this will cause premature
clutch wear or damage.
z Do not coast in the “N” (Neutral) position.
z Do not use the gearshift lever as a hand rest,
because this can result in premature wear ofthe transmission shift forks.
z Quick or slight clutch engagement made
while the engine is running at high speed
will cause damage to the clutch and trans-
mission because the traction force is very great.NOTEz During cold weather, shifting may be diffi-
cult until the transmission lubricant has
warmed up. This is normal and not harmful
to the transmission.
z If it is hard to shift into 1 st
, depress the
clutch pedal again; the shift will then be eas- ier to make.
z In case of hot weather condition or long time
cruising with high speed, a speed limitation function may work to restrict the oil temper-
ature rising of the manual transmission. Af-
ter the oil temperature drops to the appropri-
ate level, the speed limitation function is cancelled.
z The gearshift indicator shows recommended
gearshift points for fuel-efficient driving. It
shows a
when an upshift is recommen-
ded.
Moving the gearshift lever to
the “R” (Reverse) position
Depress and hold the gearshift lever to the
“R” (Reverse) position.
CAUT,ONz Do not depress the gearshift lever when
moving it to any position other than the “R”
(Reverse) position. If you always depress the gearshift lever when moving it, you could unintentionally move the gearshift lever tothe “R” (Reverse) position and cause an ac-
cident and/or a transmission fault.Possible driving speed
Avoid shifting down at high speed, as this
may cause excessive engine speed (the tach- ometer needle into the red zone) and damage
the engine.
Manual transmission*
6-272.7((Starting and driving6

Page 146 of 458

MITSUBISHI L200 2019 Owners Manual (in English) �2�W�D� �m�o�d�e�l�s�S�h�i�f�t� �p�o�i�n�t�S�p�e�e�d� �l�i�m�i�t�1�s�t
� �g�e�a�r�3�0� �k�m�/�h� �(�1�9� �m�p�h�)�2�n�d
� �g�e�a�r�6�0� �k�m�/�h� �(�3�7� �m�p�h�)�3�r�d
� �g�e�a�r�1�0�0� �k�m�/�h� �(�

Page 147 of 458

MITSUBISHI L200 2019 Owners Manual (in English) �T�h�e� �s�e�l�e�c�t�o�r� �l�e�v�e�r� �(�A�)� �h�a�s� �2� �g�a�t�e�s�;� �t�h�e� �m�a�i�n�g�a�t�e� �(�B�)� �a�n�d� �t�h�e� �m�a�n�u�a�l� �g�a�t�e� �(�C�)�.�W�h�i�l�e� �d�e�p�r�e�s�s�i�n�g� �t

Page 148 of 458

MITSUBISHI L200 2019 Owners Manual (in English) �3�.�I�n�s�e�r�t� �a� �s�t�r�a�i�g�h�t� �b�l�a�d�e� �(�o�r� �m�i�n�u�s�)� �s�c�r�e�w�-
�d�r�i�v�e�r� �w�i�t�h� �a� �c�l�o�t�h� �o�v�e�r� �i�t�s� �t�i�p� �i�n�t�o� �n�o�t�c�h �(�A�)� �o�r� �t�h

Page 149 of 458

MITSUBISHI L200 2019 Owners Manual (in English) �S�e�l�e�c�t�o�r� �l�e�v�e�r� �p�o�s�i�t�i�o�n� �d�i�s�p�l�a�y
�W�h�e�n� �t�h�e� �i�g�n�i�t�i�o�n� �s�w�i�t�c�h� �i�s� �t�u�r�n�e�d� �t�o� �t�h�e
�“�O�N�”� �p�o�s�i�t�i�o�n� �o�r� �t�h�e� �

Selector lever position display
When the ignition switch is turned to the
“ON” position or the operation mode is put in
ON, the position of the selector lever is indi- cated in the multi information display.
Selector lever positions
“P” PARK
This position locks the transmission to pre-vent the vehicle from moving. The engine
can be started in this position.
“R” REVERSE
This position is to back up.
CAUT,ONz Never shift into the “P” (PARK) or “R” (RE-
VERSE) position while the vehicle is in mo- tion to avoid transmission damage.
“N” NEUTRAL
At this position the transmission is disengag-
ed. It is the same as the neutral position on amanual transmission, and should only be used when the vehicle is stationary for an ex-
tended length of time during driving, such as
in a traffic jam.
:ARN,NGz Never move the selector lever to the “N”
(NEUTRAL) position while driving. A se-rious accident could occur since you could
accidentally move the lever into the “P”
(PARK) or “R” (REVERSE) position or you will lose engine braking.
z On a gradient, the engine should be star-
ted in the “P” (PARK) position, not in the “N” (NEUTRAL) position.
z To prevent rolling, always keep your foot
on the brake pedal when the vehicle is in“N” (NEUTRAL) position, or when shift-
ing into or out of “N” (NEUTRAL) posi- tion.“D” DRIVE
This position is used for most city and high-
way driving. The transmission will automati- cally change its gear depending on road and
driving conditions.
CAUT,ONz To prevent transmission damage, never shift
into the “D” (DRIVE) position from the “R” (REVERSE) position while the vehicle is inmotion.Sport mode
Whether the vehicle is stationary or in mo-
tion, sports mode is selected by gently push- ing the selector lever from the “D” (DRIVE)
position into the manual gate (A).
To return to “D” range operation, gently push the selector lever back into the main gate (B).
In sports mode, gear shifts can be made rap-
idly simply by moving the selector lever backward and forward. For vehicles equippedwith the shift paddles, shift paddles at the
steering wheel can also be used to perform gearshift. In contrast to a manual transmis-
sion, the sports mode allows gear shifts with
the accelerator pedal depressed.
Automatic transmission Sports Mode 5A/T
6-312.7((Starting and driving6

Page 150 of 458

MITSUBISHI L200 2019 Owners Manual (in English) �N�O�T�E�z�I�f� �y�o�u�r� �v�e�h�i�c�l�e� �i�s� �e�q�u�i�p�p�e�d� �w�i�t�h� �s�h�i�f�t� �p�a�d�-
�d�l�e�s�,� �y�o�u� �c�a�n� �s�h�i�f�t� �i�n�t�o� �s�p�o�r�t�s� �m�o�d�e� �w�i�t�h
�s�h�i

Page 151 of 458

MITSUBISHI L200 2019 Owners Manual (in English) �S�p�o�r�t�s� �m�o�d�e� �i�n�d�i�c�a�t�o�r
�I�n� �s�p�o�r�t�s� �m�o�d�e�,� �t�h�e� �c�u�r�r�e�n�t�l�y� �s�e�l�e�c�t�e�d� �p�o�s�i�-�t�i�o�n� �i�s� �i�n�d�i�c�a�t�e�d� �b�y� �t�h�e� �i�n�d�i

Page 152 of 458

MITSUBISHI L200 2019 Owners Manual (in English) �C�A�U�T�,�O�N�z�I�f� �t�h�e� �l�a�m�p� �c�o�m�e�s� �o�n�,� �r�e�d�u�c�e� �t�h�e� �e�n�g�i�n�e
�s�p�e�e�d� �a�n�d� �s�t�o�p� �t�h�e� �v�e�h�i�c�l�e� �i�n� �a� �s�a�f�e� �a�r�e�a�.�T�h�e

CAUT,ONzIf the lamp comes on, reduce the engine
speed and stop the vehicle in a safe area.Then set the selector lever to “P” (PARK)
position and idle the engine until the warn- ing lamp goes off. When the warning lamp
goes off, resume normal driving. If the warn-
ing lamp does not go off, we recommend
you to have your vehicle inspected.Operation of the A/TCAUT,ONz Before selecting a gear with the engine run-
ning and the vehicle stationary, fully depress
the brake pedal to prevent the vehicle from
creeping.
The vehicle will begin to move as soon as the gear is engaged, especially when the en- gine speed is high, at fast idle or with the airconditioner operating, the brakes should on-
ly be released when you are ready to drive
away.
z Depress the brake pedal with the right foot at
all times.
Using the left foot could cause driver move- ment delay in case of an emergency.
z To prevent sudden acceleration, never race
the engine when shifting from the “P”
(PARK) or “N” (NEUTRAL) position.CAUT,ONz Operating the accelerator pedal while the
other foot is resting on the brake pedal will affect braking efficiency and may cause pre-
mature wear of brake pads.
z Use the selector lever in the correct shift po-
sition in accordance with driving conditions.
Never coast downhill backward with the se-
lector lever in the {“D” (DRIVE) or sports mode} or coast forward with the selector
lever in the “R” (REVERSE) position.
The engine may stop and the unexpected in- crease in brake pedal effort and steering
wheel weight could lead to an accident.
z Do not race the engine with brake pedal
pressed when the vehicle is stationary.
This can damage the A/T.
Also, when you depress the accelerator ped- al while holding down the brake pedal withthe selector lever in the “P” (PARK), “N”
(NEUTRAL) or “D” (DRIVE) position, the engine revolutions may not rise as high as
when performing the same operation with
the selector lever in the “N” (NEUTRAL)
position.Passing acceleration
To gain extra acceleration in “D” (DRIVE)
position, push the accelerator to the floor.
The A/T will automatically downshift.
NOTEz In sports mode, downshifts do not take place
when the accelerator is depressed all the way to the floor.Waiting
For short waiting periods, such as at traffic
signals, the vehicle can be left in gear and
held stationary with the service brake.
For longer waiting periods with the engine running, place the selector lever in the “N”
(NEUTRAL) position and apply the parking brake, while holding the vehicle stationary with the service brake.
CAUT,ONz Never hold the vehicle stationary on a hill
using the accelerator pedal (without using
the brake pedal). Always apply the parking
brake and/or service brakes.Parking
To park the vehicle, first bring it to a com-
plete stop, fully engage the parking brake, and then move the selector lever to the “P” (PARK) position.
If you are going to leave the vehicle unatten-
ded, always switch off the engine and carry the key.
Automatic transmission Sports Mode 5A/T
6-342.7((Starting and driving6

Load next 8 pages

Page: < prev 1-10 ... 113-120 121-128 129-136 137-144 145-152 153-160 161-168 169-176 177-184 ... 464 next >

winter tyres fuel tank removal fuse box location fold seats oil capacities apple carplay