2018 MITSUBISHI L200 Owner's Manual (in English)

Quick guideE08500500010Locking and unlocking the
doors
E08500601454
Keyless entry system*
Press the key switch, and all doors will be
locked or unlocked as desired.
It is also possible to operate the outside rear-
view mirrors. (Vehicles equipped with the mirror retractor switch)
The key switch will operate within approxi-
mately 4 m from the vehicle.
1. LOCK switch
2. UNLOCK switch
3. Indication lamp
Refer to “Keyless entry system*” on page
3-04.
For vehicles equipped with the mirror retrac- tor switch, the outside rear-view mirrors can
be folded and extended automatically if you press the LOCK switch (1) or UNLOCK
switch (2).
Refer to “Operation of the outside rear- view mirrors” on page 3-05.
Keyless operation system*
When you are carrying the keyless operation
key and within the operating range, if you
press the driver’s or front passenger’s door switch (A), the doors are locked/unlocked.The operating range is approximately 70 cm from the driver’s or front passenger’s door
lock/unlock switch.
Refer to “Keyless operation system*” on page 3-07.
Around the driver’s seat
E08500801775
Quick guide
1-15OKTE18E1Overview/Quick guide1Keyless entry key Keyless operation key

1-Electric remote-controlledoutside rear-view mirrors*
To adjust the mirror position
L-Left outside mirror adjustmentR-Right outside mirror adjustment1-Up2-Down3-Right4-Left5-Mirror retractor switch*

Refer to “Outside rear-view mirrors” on
page 6-09.
2-Engine switch*
If you are carrying the keyless operation key, you can start the engine. If you press the en-
gine switch without depressing the brake pedal ( A/T) or the clutch pedal ( M/T), you
can change the operation mode in the order of OFF, ACC, ON, OFF.
OFF-The indication lamp on the en-
gine switch turns off.ACC-The indication lamp on the en-
gine switch illuminates orange.ON-The indication lamp on the en-
gine switch illuminates green.

Refer to “Engine switch” on page 6-14.
3-Combination headlamps
Rotate the switch to turn on the lamps.
Type 1
OFFAll lamps offPosition, tail, licence plate and
instrument panel lamps onHeadlamps and other lamps go
on
Quick guide
1-16OKTE18E1Overview/Quick guide1Except for vehicles
equipped with the mirror
retractor switch
Vehicles equipped with
the mirror retractor
switch

Type 2OFFAll lamps off
AUTO
With the ignition switch or theoperation mode is in ON, head-
lamps, position, tail, licence plate and instrument panellamps turn on and off automati-
cally in accordance with outside
light level. All lamps turn off automatically when the ignition
switch is turned to “OFF” posi-
tion or the operation mode is put in OFF.Position, tail, licence plate and
instrument panel lamps onHeadlamps and other lamps go
on
Refer to “Combination headlamps and dipper switch” on page 5-17.
3-Turn-signal lever
The turn-signal lamps flash when the lever is
operated.
1. Turn-signals
2. Lane-change signals

Refer to “Turn-signal lever” on page 5-20.
4-Steering wheel height and
reach adjustment
1. Release the lever while holding the
steering wheel up.
2. Adjust the steering wheel to the desired
position.
3. Securely lock the steering wheel by pull-
ing the lever fully upward.A-LockedB-Release*:Vehicles equipped with the reach adjustment

Quick guide
1-17OKTE18E1Overview/Quick guide1

Refer to “Steering wheel height and reachadjustment” on page 6-07.
5-Wiper and washer switch
Except for vehicles equipped with rain sensor
MIST-Misting function
The wipers will operate
once.OFF-OffINT-Intermittent (Speed sensi- tive)LO-SlowHI-FastVehicles with rain sensorMIST-Misting function
The wipers will operate
once.OFF-OffAUTO-Auto-wiper control
Rain sensor
The wipers will automati- cally operate depending on
the degree of wetness on the windscreen.LO-SlowHI-Fast

The washer fluid will be sprayed onto the
windscreen by pulling the lever towards you.

Refer to “Wiper and washer switch” on page 5-23.
6-Electric window control*
Press the switch down for opening the win-
dow, and pull the switch for closing.
1. Driver’s door window
2. Front passenger’s door window
3. Rear left door window (Double cab)
4. Rear right door window (Double cab)
5. Lock switch
Lock switch
If you press the switch (5), the passenger’s switches cannot be operated. To cancel, press
it once again.

Refer to “Electric window control*” on
page 3-21.
Quick guide
1-18OKTE18E1Overview/Quick guide1 Driver’s switch
LHDDriver’s switch
RHD

7-Fuel tank filler door release
lever*
Open the fuel tank filler door.
The fuel tank filler is located on the rear left side of your vehicle.
Refer to “Filling the fuel tank” on page 2-03.
Automatic transmission Sports
Mode 5A/T
E08501001325
Selector lever operation
The transmission selects an optimum gear ra- tio automatically, depending on the speed of the vehicle and the position of the acceleratorpedal.
While depressing the brake ped-
al, move the selector lever through the gate.Move the selector lever through
the gate.
Selector lever positions
“P” PARK
This position locks the transmission to pre-
vent the vehicle from moving. The engine
can be started in this position.
“R” REVERSE
This position is to back up.
“N” NEUTRAL
At this position the transmission is disengag- ed.
“D” DRIVE
This position is for normal driving.

Refer to “Automatic transmission Sports Mode 5A/T” on page 6-29.
Multi information display
E08501201226
Always stop the vehicle in a safe place before
operating.
Quick guide
1-19OKTE18E1Overview/Quick guide1Type 1 Type 2 LHD RHD

The following information is included on themulti information display: odometer, tripme-
ter, average fuel consumption etc.
1- Engine coolant temperature display
® p. 5-06
2- Selector lever position display*
® p. 6-31
3- Speed limiter display* ® p. 6-70
4- Gearshift indicator* ® p. 6-27
5- Fuel remaining display ® p. 5-07
6- Frozen road warning* ® p. 5-06
7- Information display ® p. 5-03
8- Service reminder ® p. 5-07

Refer to “Multi-information display” on page 5-02.
Quick guide
1-20OKTE18E1Overview/Quick guide1

Fuel selection...................................................................................... 2-02Filling the fuel tank............................................................................. 2-03Entering or leaving the vehicle........................................................... 2-05Installation of accessories................................................................... 2-05
Modification/alterations to the electrical or fuel systems................... 2-06
Genuine parts...................................................................................... 2-06
Safety and disposal information for used engine oil........................... 2-06
Disposal information for used batteries.............................................. 2-07General information
OKTE18E12

Fuel selectionE00200105096Recommended fuel
Cetane number (EN
590) 51 or higherCAUTIONlYour vehicle is designed to use only diesel
fuel that meets the EN590 standard.
Use of any other type of diesel fuel (bio die-
sel, methylester, etc.) would adversely affect
the engine’s performance and durability.
l If proper “winter” fuel is not used in winter,
the diesel preheat indication lamp may blink and the engine speed may not rise above theidling speed because of fuel freezing. In this
case, keep the engine idling for approxi- mately 10 minutes, then turn off the ignition
switch or put the operation mode in OFF and immediately turn it on or put in ON again to
confirm that the diesel preheat indication lamp is off. (Refer to “Diesel preheat indica-
tion lamp” on page 5-14)NOTEl For diesel fuel, due to the separation of par-
affin, the fluidity of the fuel decreases con- siderably as the temperature falls.
Because of this fact there are two kinds of
fuel: “summer” and “winter”.
This must be considered in winter use.
Select either of the two kinds of fuel in ac- cordance with ambient temperature. Above -5 °C: “Summer” diesel
Below -5 °C: “Winter” diesel
When travelling abroad, find out in advance
about the fuels served in local service sta- tions.
l Poor-quality diesel fuel can cause deposits to
form in the injector, resulting in black smoke and rough idling.
If these problems occur, you are advised to
add a cleaning additive to the diesel fuel when you refuel the vehicle.
The additive will break up and remove the
deposits, thereby returning the engine to a normal condition.
Be sure to use a MITSUBISHI MOTORS
GENUINE DIESEL FUEL SYSTEM
CLEANER. Using an unsuitable additive could make the engine malfunction. For de-
tails, please contact your MITSUBISHI
MOTORS Authorized Service Point.Graphical expression for con-
sumer information
B7: Diesel fuel containing up to 7.0 % (V/V) Fatty Acid Methyl Esters - Eg. EN 590 com-pliant diesel
The diesel engine are compatible with B7
type diesel (containing 7 % fatty acid methyl
esters) conforming to European standards EN590.
CAUTIONl Do not use more than 7 % concentration of
fatty acid methyl esters (bio diesel) by vol-
ume.
Use of more than 7 % concentration would adversely affect the engine’s performance
and durability.
Fuel selection
2-02OKTE18E1General information2