2018 KIA PICANTO Owners Manual

2. Accelerate to the desired speed,which must be more than 30 km/h
(20 mph).
NOTICE
nManual transaxle
For manual transaxle vehicles, you
should depress the brake pedal at
least once to set the cruise control
aýter startinþ the enþine.
3. Mov e the lever down (to SET-), and
release it at the desired speed. The
cruise set indicator liþht will illumi‐
nate. Release the accelerator pedal
at the same time. The desired speed will automatically be main‐
tained.
æn a steep þrade, the vehicle may
slow down or speed up sliþhtly while þoinþ downhill.

6-43
6
Drivinþ your vehicle

To increase cruise control set
speed:
Follow either oý these procedures:• Move the lever up (to RES+) and hold
it. Your vehicle will accelerate. Re‐
lease the lever at the speed you want.
• Move the lever up (to RES+) and re‐ lease it immediately. The cruisinþ
speed will increase by 2.0 km/h
(1.2 mph) each time you move the
lever up (to RES+) in this manner.
To decrease the cruisinþ speed:
Follow either oý these procedures:
Drivinþ your vehicle
6-44

• Move the lever down (to SET-) andhold it. Your vehicle will þradually
slow down. Release the lever at the speed you want to maintain.
• Move the lever down (to SET-) and release it immediately. The cruisinþ
speed will decrease by 2.0 km/h
(1.2 mph) each time you move the
lever down (to SET-) in this manner.
To temporarily accelerate with
the cruise control on:
Iý you want to speed up temporarily
when the cruise control is on, depress the accelerator pedal. Increased speed
will not interýere with cruise control op‐
eration or chanþe the set speed.
To return to the set speed, take your ýoot oýý the accelerator pedal.
To cancel cruise control, do one
oý the ýollowinþ:
• Depress the brake pedal. • Depress the clutch pedal iý equipped
with a manual transaxle.
• Shiýt into N (Neutral) iý equipped with an automatic transaxle.
• çress the æ/CANCEL switch located on the steerinþ wheel.
• Decrease the vehicle speed lower than the memory speed by 20 km/h
(12 mph).
• Decrease the vehicle speed to less than approximately 30 km/h
(20 mph).
Each oý these actions will cancel cruise
control operation (the cruise set indica‐ tor liþht will þo oýý), but it will not turn the system oýý. Iý you wish to resumecruise control operation, move up the lever (to RES+) located on your steerinþ wheel. You will return to your previous‐ly preset speed.

6-45
6
Drivinþ your vehicle

To resume cruisinþ speed at
more than approximately 30
km/h (20 mph):
Iý any method other than the cruise /
CRUISE button was used to cancel
cruisinþ speed and the system is still
activated, the most recent set speed
will automatically resume when you
move the lever up (to RES+).
It will not resume, however, iý the vehi‐ cle speed has dropped below approxi‐
mately 30 km/h (20 mph).
To turn cruise control oýý, do
one oý the ýollowinþ:
• çr ess the cruise / CRUISE button
(the cruise indicator liþht will be turn
oýý).
• Turn the iþnition oýý.
Both oý these actions cancel cruise con‐ trol operation. Iý you want to resumecruise control operation, repeat the steps provided in L

SPEED LIMIT CONTROL SYSTEM (IF EQUIPPED)
You can set the speed limit when you
do not want to drive over a speciýic
speed.
Iý you drive over the preset speed limit, the warninþ system operates (set
speed limit will blink and chime will
sound) until the vehicle speed returns within the speed limit.
NOTICE
While speed limit control is in opera‐
tion, the cruise control system can‐
not be activated.
Speed limit control switch
æ: Cancels set speed limit.: Turns speed limit control sys‐
tem on or oýý.
RES+: Resumes or increases speed limit
control speed.
SET-: Sets or decreases speed limit
control speed.
To set speed limit:
1. çress the speed limit button
twice on the steerinþ wheel, to
turn the system on.
The speed limit indicator liþht will
illuminate.

6-47
6
Drivinþ your vehicle

2. Move the lever down (to SET-).3. Move the lever up (to RES+) or
down (to SET-), and release it at
the desired speed. Move the lever
up (to RES+) or down (to SET-) and
hold it. The speed will increase or
decrease by 5 km/h (3 mph).
The set speed limit will be displayed.
To drive over the preset speed limit you
must depress hard on the accelerator pedal (more than approximately 80%)
until the kick down mechanism works
with a clickinþ noise. Then the set speed limit will blink and chime will
sound until you return the vehicle
speed within the speed limit.
Drivinþ your vehicle
6-48

NOTICE
•Depressinþ the accelerator pedal
less than approximately 50%, the
vehicle will not speed over the pre‐
set speed limit but maintain the
vehicle speed within the speed lim‐
it.
•A clickinþ noise heard ýrom the
kick down mechanism by depress‐
inþ the accelerator pedal ýully is a
normal condition.
To turn oýý the speed limit
control, do one oý the ýollowinþ:
• çress the speed limit switch
once aþain.
• Turn the iþnition oýý.
Iý you press the æ switch once, the set speed limit will cancel, but it will not
turn the system oýý. Iý you wish to re‐
set the speed limit, move the lever up (to RES+) or down (to SET-) to the de‐
sired speed.CAUTION
The L

RADAR TYPE AUTONOMOUS EMERGENCY BRAKING (IF EQUIPPED)
The AEB system is to reduce or to
avoid accident risk. It recoþnizes the
distance ýrom the vehicle ahead
throuþh the sensors (i.e. radar), and, iý
necessary, warns the driver or applies emerþency brakinþ oý accident risk
with the warninþ messaþe or the warn‐ inþ alarms. ❈ Radar type AEB system does not
operate ýor pedestrians in ýront.
WARNING
Take the ýollowinþ precautions whenusinþ the Autonomous EmerþencyBrakinþ (AEB):•This system is only a supplemen‐tal system and it is not intendedto, nor does it replace the need ýorextreme care and attention oý thedriver. The sensinþ ranþe and ob‐jects detectable by the sensors arelimited. Pay attention to the roadconditions at all times.
•NEVER drive too ýast in accordancewith the road conditions or whilecornerinþ.
(Continued)
(Continued)
•Always drive cautiously to preventunexpected and sudden situationsýrom occurrinþ. AEB does not stopthe vehicle completely and doesnot avoid collisions.
System settinþ and activation
System settinþ
The driver can activate the AEB by
placinþ the iþnition switch to the æN position and by selectinþ 'User Set‐
tinþs', 'Drivinþ Assist', and 'Autonomous
Emerþency Brakinþ System'. The AEB deactivates, when the driver cancels
the system settinþ.
The warninþ liþht illuminates on the LCD display, whenyou cancel the AEB system.
It illuminates even with the ESC (Elec‐
tronic Stability Control) state 2 æFF.
The driver can monitor the AEBæN/æFF status on the LCD display.
When the warninþ liþht remains æN
with the AEB activated, have the sys‐tem checked by a proýessional work‐
shop. Kia recommends to visit an au‐
thorized Kia dealer/service partner. The driver can select the initial warninþ
activation time in the User Settinþs and Drivinþ Assist in the instrument cluster
LCD display. The options ýor the initial
Forward Collision Warninþ include the ýollowinþ:
• EARLY - When this condition is se‐
lected, the initial Forward
Collision Warninþ is acti‐vated earlier than nor‐
mal. Iý the L