2017 KIA OPTIMA PLUG-IN HYBRID Owners Manual

Vehicle recognition
0+'
Some vehicles ahead in your lane can‐
not be recognized by the sensor as fol‐ lows:
- Narrow vehicles such as motorcycles
or bicycles
- Vehicles offset to one side
- Slow-moving vehicles or sudden-de‐
celerating vehicles
- Stopped vehicles
- Vehicles with small rear profile such
as trailers with no loads A vehicle ahead cannot be recognized
correctly by the sensor if any of follow‐
ing occurs:
- When the vehicle is pointing upwards
due to overloading in the trunk
- While making turns by steering
- When driving to one side of the lane
- When driving on narrow lanes or on
curves
Adjust your vehicle speed by depressing
the brake pedal according to the road
condition ahead and driving condition.
0+'
• When vehicles are at a standstill and the vehicle in front of you changes to
the next lane, be careful when your vehicle starts to move because it may not recognize the stopped vehi‐
cle in front of you.
0+'
• Always look out for pedestrians when your vehicle is maintaining a distance
with the vehicle ahead.
Driving your vehicle
7-72

0+'
• Always be cautious for vehicles withhigher height or vehicles carrying
loads that stick out to the back of the vehicle.
WARNING
•The advanced smart cruise controlsystem cannot guarantee the stopfor every emergency situation.If an emergency stop is necessary,you must apply the brakes.
(Continued)
(Continued)
•Keep a safe distance according toroad conditions and vehicle speed.If the vehicle to vehicle distance istoo close during a high-speed driv‐ing, a serious collision may result.
•The advanced smart cruise controlsystem cannot recognize a stop‐ped vehicle, pedestrians or an on‐coming vehicle. Always look aheadcautiously to prevent unexpectedand sudden situations from occur‐ring.
•SCC system may have difficulty inmaintaining the correct distance orspeed, if the vehicle is driving on asteep incline or towing a trailer.
•When other vehicles are changinglanes in front of you frequently,the advanced smart cruise controlsystem may not operate appropri‐ately. Always look ahead cautious‐ly to prevent unexpected and sud‐den situations from occurring.
(Continued)
(Continued)
•The advanced smart cruise controlsystem is not a substitute for safedriving practices but a conveniencefunction only. It is the responsibili‐ty of the driver to always checkthe speed and the distance to thevehicle ahead.
•Always be aware of the selectedspeed and vehicle to vehicle dis‐tance.
•Always maintain sufficient brakingdistance and decelerate your vehi‐cle by applying the brakes if nec‐essary.
•As the advanced smart cruise con‐trol system may not recognizecomplex driving situations, alwayspay attention to driving conditionsand control your vehicle speed.
•For safe operation, carefully readand follow the instructions in thismanual before use.
•After an engine start, please stopfor several seconds. If system ini‐tialization is not completed, theSCC does not normally operate.
(Continued)

7-73
7
Driving your vehicle

(Continued)
•After an engine start, if any ob‐jects are not detected or the sen‐sor cover is obscured with foreignsubstances, there is a possibilitythat the SCC system may notwork.
•Below conditions are not allowed:over baggage loading in a trunk,suspension remodeling, tire re‐placement with unauthorized tiresor tires with different worn-outand pressure levels.
CAUTION
The advanced smart cruise controlsystem may not operate temporari‐ly due to electrical interference.
Driving your vehicle
7-74

DRIVE MODE INTEGRATED CONTROL SYSTEM (IF EQUIPPED)
Hybrid vehicle
5ZQF
"
0+'
5ZQF
#
0+'
The drive mode may be selected ac‐
cording to the driver’s preference or road condition. The system resets to be in the ECO
mode, when the hybrid system is re‐
started.
If there is a problem with the instru‐ ment cluster, the drive mode will be in
ECO mode and may not change to NOR‐
MAL mode or SPORT mode.
The mode changes whenever the DRIVE MODE button is pressed.

/03."-
41035
















&$0
❈ When normal mode is selected, it is
not displayed on the cluster.
ECO mode (Active ECO)
ECO
Active ECO helps
improve fuel effi‐
ciency by control‐ling certain en‐gine and trans‐axle system op‐erating parame‐ters. Fuel effi‐ciency depends
on the driver'sdriving habit and
road condition. • When the DRIVE MODE button is
pressed and the ECO mode is selec‐
ted, the ECO indicator (green) will illu‐ minate to show that the Active ECO
is operating.
• When the Active ECO is activated, it does not turn off even though the
engine is restarted again. To turn off
the system, press the DRIVE MODE button again.
When Active ECO is activated:
• The acceleration may slightly be re‐ duced even though you depress the
accelerator fully.
• The air conditioner performance may be limited.
• The shift pattern of the automatic transaxle may change.
• The engine noise may get louder.
The above situations are normal condi‐
tions when the active eco system is ac‐
tivated to improve fuel efficiency.
Limitation of Active ECO operation:
If the following conditions occur while Active ECO is operating, the system op‐
eration is limited even though there is
no change in the ECO indicator.

7-75
7
Driving your vehicle

• When the coolant temperature is low:The system will be limited until en‐
gine performance becomes normal.
• When driving up a hill: The system will be limited to gain
power when driving uphill because the engine torque is restricted.
• When using manual mode: The system will be limited according
to the shift location.
• When the accelerator pedal is deeply depressed for a few seconds:
The system will be limited, judging
that the driver wants to speed up.
SPORT mode
SPORT
SPORT mode focu‐ ses on dynamic driv‐ing by automatically
controlling thesteering wheel, en‐gine and transaxlesystem.
• When the DRIVE MODE button is pressed and the SPORT mode is se‐
lected, the SPORT indicator (yellow) will illuminate. • Whenever the hybrid system is re‐
started, the Drive Mode will revert
back to ECO mode. If SPORT mode is
desired, re-select SPORT mode from
the DRIVE MODE button
• If the system is activated: - After speeding, it maintains the gear and RPM for some time even
though the accelerator pedal is not depressed.
- Up-shifting is delayed.
NOTICE
In Sport drive mode, the fuel effi‐
ciency may decrease.
Driving your vehicle
7-76

DRIVE MODE INTEGRATED CONTROL SYSTEM (IF EQUIPPED)
Plug-in hybrid vehicle
0+')1-
The drive mode may be selected ac‐
cording to the driver’s preference or road condition.
The system resets to be in the ECO
mode, when the hybrid system is re‐
started.
If there is a problem with the instru‐ ment cluster, the drive mode will be in
ECO mode and may not change to NOR‐
MAL mode.
The mode changes whenever the DRIVE MODE button is pressed.
/03."- &$0
❈ When normal mode is selected, it is
not displayed on the cluster.
ECO mode (Active ECO)
ECO
Active ECO helps
improve fuel effi‐
ciency by control‐ling certain en‐gine and trans‐axle system op‐erating parame‐ters. Fuel effi‐ciency depends
on the driver'sdriving habit and
road condition.
• When the DRIVE MODE button is pressed and the ECO mode is selec‐
ted, the ECO indicator (green) will illu‐ minate to show that the Active ECO
is operating.
• When the Active ECO is activated, it does not turn off even though the
engine is restarted again. To turn off
the system, press the DRIVE MODE button again.
When Active ECO is activated:
• The acceleration may slightly be re‐ duced eventhough you depress the
accelerator fully.
• The air conditioner performance may be limited
• The shift pattern of the automatic transaxle may change.
• The engine noise may get louder.
The above situations are normal condi‐
tions when the active eco system is ac‐
tivated to improve fuel efficiency.
Limitation of Active ECO operation:
If the following conditions occur while Active ECO is operating, the system op‐
eration is limited even though there is
no change in the ECO indicator. • When the coolant temperature is low: The system will be limited until en‐
gine performance becomes normal.
• When driving up a hill: The system will be limited to gainpower when driving uphill because
the engine torque is restricted.
• When using manual mode: The system will be limited according
to the shift location.

7-77
7
Driving your vehicle

• When the accelerator pedal is deeplydepressed for a few seconds:
The system will be limited, judging
that the driver wants to speed up.
Driving your vehicle
7-78

LANE DEPARTURE WARNING SYSTEM (LDWS) (IF EQUIPPED)
06.
0+'
This system detects the lane with the
sensor at the front windshield and warns you when your vehicle leaves the
lane.
WARNING
•The LDWS does not make the vehi‐cle change lanes. It is the driver'sresponsibility to always check theroad conditions.
(Continued)
(Continued)
•Do not turn the steering wheelsuddenly, when the LDWS warnsyou that your vehicle is leaving thelane.
•If the sensor can not detect thelane or if the vehicle speed doesnot exceed around 60 km/h, theLDWS won't warn you even thoughthe vehicle leaves the lane.
•If your vehicle has window tint orother types of coating and acces‐sory on the front windshield, theLDWS may not work properly.
•Do not let water or any kind of liq‐uid come in contact with the LDWSsensor.
•Do not remove the LDWS partsand do not affect the sensor by astrong impact.
•Do not put objects that reflectlight on the dash board.
•Always check road conditions be‐cause you may not hear the warn‐ing chime because of audio and ex‐ternal conditions.

7-79
7
Driving your vehicle