2017 KIA OPTIMA PLUG-IN HYBRID Owners Manual

5ZQF
"
5ZQF
#
0+'-
To reinstall the headrest:1. Put the headrest poles (2) into the holes while pressing the release
button or switch (1). 2. Recline the seatback(4) with the
recline lever or switch (3).
3. Adjust the headrest to the appro‐ priate height.
WARNING
Always make sure the headrestlocks into position after reinstallingand adjusting it properly.
Seatback pocket
0+'

The seatback pocket is provided on the
back of the front passenger’s and driv‐ er’s seatbacks.
WARNING
nSeatback pockets
Do not put heavy or sharp objects inthe seatback pockets. In an accidentthey could come loose from thepocket and injure vehicle occupants.
Rear seat adjustment
Headrest (if equipped)
0.(
The rear seat is equipped with headr‐
ests for the occupant's safety and comfort.
Safety features of your vehicle
4-12

The headrest not only provides comfort
for passengers, but also helps to pro‐
tect the head and neck in the event of a collision.
WARNING

•For maximum effectiveness incase of an accident, the headrestshould be adjusted so the middleof the headrest is at the sameheight of the center of gravity ofan occupant's head. Generally, thecenter of gravity of most people'shead is similar with the height ofthe top of their eyes. Also adjustthe headrest as close to your headas possible. For this reason, theuse of a cushion that holds thebody away from the seatback isnot recommended.
(Continued)
(Continued)
•Do not operate the vehicle withthe headrests removed. Severe in‐jury to an occupant may occur inthe event of an accident. Headr‐ests may provide protectionagainst severe neck injuries whenproperly adjusted.
Adjusting the height up and down
(if equipped)
0+'
To raise the headrest, pull it up to the
desired position (1). To lower the head‐ rest, push and hold the release button
(2) on the headrest support and lower
the headrest to the desired position (3).
CAUTION
When there is no occupant in therear seats, adjust the height of theheadrest to the lowest position. The
(Continued)

4-13
4
Safety features of your vehicle

(Continued)
rear seat headrest can reduce thevisibility of the rear area.
Removal and installation (if equipped)
0+'-
To remove the headrest, raise it as far
as it can go then press the release but‐ ton (1) while pulling upward (2).
To reinstall the headrest, put the head‐
rest poles (3) into the holes while
pressing the release button (1). Then
adjust it to the appropriate height.
WARNING
Make sure the headrest locks in po‐sition after adjusting it to properlyprotect the occupants.
Armrest
0+'
To use the armrest, pull it forward
from the seatback.
Folding the rear seat (if equipped)
The rear seatbacks may be folded to
facilitate carrying long items or to in‐ crease the luggage capacity of the ve‐
hicle.
WARNING
The purpose of the fold-down rearseatbacks is to allow you to carrylonger objects than could not other‐wise be accommodated.Never allow passengers to sit on topof the folded down seatback whilethe car is moving as this is not aproper seating position and no seatbelts are available for use. This couldresult in serious injury or death incase of an accident or sudden stop.Objects carried on the folded downseatback should not extend higherthan the top of the front seats. Thiscould allow cargo to slide forwardand cause injury or damage duringsudden stops.
(Continued)
Safety features of your vehicle
4-14

(Continued)
¥
)ZCSJE
0+')2#
•Do not put objects in the centerlower part of rear seats. This couldblock the battery cooling ductcausing battery degradation.
(Continued)
(Continued)
0+')1-#
¥
1MVHJO
IZCSJE
•Do not put objects on the left sideof rear seat. This could block thebattery cooling duct causing bat‐tery degradation.
To fold down the rear seatback (for Hy‐brid, if equipped):
0+'-
1. Make sure the rear seat belt web‐
bing is in the guide to prevent the
seat belt from being damaged.
2. Set the front seatback to the up‐ right position and if necessary, slide the front seat forward.
3. Lower the rear headrests to the lowest position.

4-15
4
Safety features of your vehicle

0+'
4. Pull out the seatback locking knob(1) in the trunk, then fold the seat
toward the front of the vehicle. 5. To use the rear seat, lift and pull
the seatback backward. Pull the
seatback firmly until it clicks into
place. Make sure the seatback is
locked in place.
6. Return the rear seat belt to the proper position.
WARNING
After folding the rear seat, unlessthe driver’s position is properly setaccording to the driver’s physical fig‐ure, do not fold the rear seat. It mayincrease body injuries in a suddenstop or collision.
WARNING
nUprighting seat
When you return the seatback to itsupright position, hold the seatbackand return it slowly. If the seatbackis returned without holding it, theback of the seat could spring for‐ward resulting in injury caused bybeing struck by the seatback.
WARNING
When you return the rear seatbackto its upright position after beingfolded down:Be careful not to damage the seatbelt webbing or buckle. Do not allowthe seat belt webbing or buckle toget caught or pinched in the rearseat. Ensure that the seatback iscompletely locked into its uprightposition by pushing on the top of theseatback. Otherwise, in an accidentor sudden stop, the seat could folddown and allow cargo enter the pas‐senger compartment, which couldresult in serious injury or death.
CAUTION
nDamaging rear seat belt buck‐les
When you fold the rear seatback, in‐sert the buckle between the rearseatback and cushion. Doing so canprevent the buckle from being dam‐aged by the rear seatback.
Safety features of your vehicle
4-16

CAUTION
nRear seat belts
When returning the rear seatbacksto the upright position, remember toreturn the rear shoulder belts totheir proper position.
WARNING
nCargo
Cargo should always be secured toprevent it from being thrown aboutthe vehicle in a collision and causinginjury to the vehicle occupants. Donot place objects in the rear seats,since they cannot be properly se‐cured and may hit the front seat oc‐cupants in a collision.
WARNING
nCargo loading
Make sure the engine is off, the au‐tomatic transaxle is in P (Park) and
(Continued)
(Continued)
the parking brake is securely appliedwhenever loading or unloading cargo.Failure to take these steps may al‐low the vehicle to move if the shiftlever is inadvertently moved to an‐other position.

4-17
4
Safety features of your vehicle

SEAT BELTS
Seat belt restraint system
WARNING
•For maximum restraint systemprotection, the seat belts must al‐ways be used whenever the vehi‐cle is moving.
•Seat belts are most effective whenseatbacks are in the upright posi‐tion.
•Children age 12 and under must al‐ways be properly restrained in therear seat. Never allow children toride in the front passenger seat. Ifa child over 12 must be seated inthe front seat, he/she must beproperly belted and the seatshould be moved as far back aspossible.
•Never wear the shoulder belt un‐der your arm or behind your back.An improperly positioned shoulderbelt can cause serious injuries in acrash.The shoulder belt should be posi‐tioned midway over your shoulderacross your collarbone.
(Continued)
(Continued)
•Never wear a seat belt over fragileobjects. If there is a sudden stopor impact, the seat belt can dam‐age it.
•Avoid wearing twisted seat belts.A twisted belt can't do its job well.In a collision, it could even cut intoyou. Be sure the belt webbing isstraight and not twisted.
•Be careful not to damage the beltwebbing or hardware. If the beltwebbing or hardware is damaged,replace it.
WARNING
Seat belts are designed to bear uponthe bony structure of the body, andshould be worn low across the frontof the pelvis or the pelvis, chest andshoulders, as applicable; wearing thelap section of the belt across the ab‐dominal area must be avoided.Seat belts should be adjusted asfirmly as possible, consistent withcomfort, to provide the protectionfor which they have been designed.
(Continued)
(Continued)
A slack belt will greatly reduce theprotection afforded to the wearer.Care should be taken to avoid con‐tamination of the webbing with pol‐ishes, oils and chemicals, and partic‐ularly battery acid. Cleaning maysafely be carried out using mild soapand water. The belt should be re‐placed if webbing becomes frayed,contaminated or damaged. It is es‐sential to replace the entire assem‐bly after it has been worn in a se‐vere impact even if damage to theassembly is not obvious. Belts shouldnot be worn with straps twisted.Each belt assembly must only beused by one occupant; it is danger‐ous to put a belt around a child beingcarried on the occupant's lap.
Safety features of your vehicle
4-18

WARNING
•No modifications or additionsshould be made by the user whichwill either prevent the seat beltadjusting devices from operatingto remove slack, or prevent theseat belt assembly from being ad‐justed to remove slack.
•When you fasten the seat belt, becareful not to latch the seat belt inbuckles of other seat. It's verydangerous and you may not beprotected by the seat belt proper‐ly.
•Do not unfasten the seat belt anddo not fasten and unfasten theseat belt repeatedly while driving.This could result in loss of control,and an accident causing death, se‐rious injury, or property damage.
•When fastening the seat belt,make sure that the seat belt doesnot pass over objects that are hardor can break easily.
•Make sure there is nothing in thebuckle. The seat belt may not befastened securely.
Seat belt warning
Driver's seat belt warning
0+'-
As a reminder to the driver, the seat
belt warning light will illuminate and warning chime will sound for approxi‐
mately 6 seconds each time you turn
the Engine Start/Stop button ON if the seat belt is unfastened.
If you continue not to fasten the seat
belt and you drive over 9 km/h, the
warning light will stay illuminated until you drive under 6 km/h. (if equipped) If you continue not to fasten the seat
belt and you drive over 20 km/h the
seat belt warning chime will sound for approximately 100 seconds and the
corresponding warning light will blink.
(if equipped)
If you unfasten the seat belt while driv‐ ing under 20 km/h, the seat belt warn‐
ing light will illuminate until the seat
belt is fastened.
If you unfasten the seat belt while driv‐ ing over 20 km/h, the seat belt warning
chime will sound for approximately 100
seconds and the corresponding warning light will blink.

4-19
4
Safety features of your vehicle