Lumbar support (if equipped)
The lumbar support can be adjusted by
pressing the lumbar support switch on the side of the Driver's seat. 1. Press the front portion of the switch to increase support, or the
rear portion of the switch, to de‐
crease support.
2. Release the switch once it reaches the desired position.
Front seat adjustment - power
(if equipped)
The front seat can be adjusted by usingthe control switches located on the
outside of the seat cushion. Before
driving, adjust the seat to the proper position so you can easily control the
steering wheel, pedals and switches on
the instrument panel.
WARNING
The power seat is operable with theengine start/stop button in OFF.Therefore, children should never beleft unattended in the vehicle.
CAUTION
•The power seat is driven by anelectric motor. Stop operating oncethe adjustment is completed. Ex‐cessive operation may damage theelectrical equipment.
(Continued)
(Continued)
•When in operation, the power seatconsumes a large amount of elec‐trical power. To prevent unneces‐sary charging system drain, don’tadjust the power seat longer thannecessary while the engine is notrunning.
•Do not operate two or more powerseat control switches at the sametime. Doing so may result in powerseat motor or electrical compo‐nent malfunction.
Safety features of your vehicle
4-06
(Continued)
•When you operate the steering
wheel in a low temperature, ab‐
normal noise could occur. If the
temperature rises, the noise will
disappear. This is a normal condi‐
tion.
Tilt & telescopic steering
A tilt and telescopic steering wheel al‐
lows you to adjust the steering wheel before you drive. You can also raise it
to give your legs more room when you
exit and enter the vehicle.
The steering wheel should be posi‐ tioned so that it is comfortable for you
to drive, while permitting you to see
the instrument panel warning lights and gauges.
WARNING
•Never adjust the angle of thesteering wheel while driving. Youmay lose steering control andcause severe personal injury,death or accidents.
(Continued)
(Continued)
•After adjusting, push the steeringwheel both up and down to be cer‐tain it is locked in position.
0 + '
To change the steering wheel angle,
pull down the lock release lever (1), ad‐ just the steering wheel to the desired
angle (2) and height (3), then pull up
the lock-release lever (4) to lock the steering wheel in place. Be sure to ad‐
just the steering wheel to the desired
position before driving.
NOTICE
After adjustment, sometimes the
lock-release lever may not lock the
steering wheel.
It is not a malfunction. This occurs
when two gears engage. In this case,
adjust the steering wheel again and
then lock the steering wheel.
5-41
5
Features of your vehicle
