Page 529 of 556
Page 530 of 556
Page 531 of 556
Page 532 of 556

FUEL INFORMATION
Gasoline engine
CAUTION
Do not use leaded gasoline. Using leaded
gasoline will damage the three-way catalyst.
2.0L gasoline engine model
:
Use unleaded premium gasoline with an octane
rating of at least 91 AKI (Anti-Knock Index)
number (Research octane number 95).
If unleaded premium gasoline is not available,
unleaded regular gasoline with an octane rating
of at least 89 AKI number (Research octane
number 93) may be temporarily used, but only
under the following precautions:
•Have the fuel tank filled only partially with
unleaded regular gasoline, and fill up with
unleaded premium gasoline as soon as pos-
sible.
•Avoid full throttle driving and abrupt accel-
eration.
Use unleaded premium gasoline for maximum
vehicle performance.
CAUTION
•Using a fuel other than that specified could
adversely affect the emission control sys-
tem, and may also affect warranty coverage.
•Under no circumstances should a leaded
gasoline be used, because this will damage
the three-way catalyst.
•Do not use E-15 or E-85 fuel in your vehicle.
Your vehicle is not designed to run on E-15 or
E-85 fuel. Using E-15 or E- 85 fuel in a vehicle
not specifically designed for E-15 or E-85
fuel can adversely affect the emission con-
trol devices and systems of the vehicle.
Damage caused by such fuel is not covered
by the INFINITI new vehicle limited war-
ranty.
•U.S. government regulations require etha-
nol dispensing pumps to be identified by a
small, square, orange and black label with
the common abbreviation or the appropri-
ate percentage for that region.
RECOMMENDED ENGINE OIL
See Recommended fluids/lubricants and
capacities in the9. Maintenance and Sched-
ules section.
TIRE COLD PRESSURE
See the tire and loading information label af-
fixed to the driver’s side center pillar.
GASOLINE STATION INFORMATION
Page 533 of 556
•In case of emergency ... 6-2
(Flat tire, engine will not start, overheating,
towing)
•How to start the engine ... 5-16
•How to read the meters and gauges ... 2-4
•Maintenance and do-it-yourself ... 8-2
•Technical information ... 9-2
QUICK REFERENCE
Page 534 of 556
2017 Infiniti QX30
Printing: November 2016 (02) / OM17E0 0H15U1 / Printed in U.S.A.
For your safety, read carefully and keep in this vehicle.2017 Infiniti QX30
Owner’s Manual and
Maintenance Information
Page 535 of 556
Owner’s Manual Supplement
The information contained within this supplement updates the following information
in the 2017 INFINITI QX30:
●SUPPLEMENTAL RESTRAINT SYSTEM (SRS)in the “Safety—Seats, seat
belts and supplemental restraint system” section.
●FORWARD-FACING CHILD RESTRAINT INSTALLATION USING THE
SEAT BELTS in the “Safety—Seats, seat belts and supplemental restraint
system” section.
Read carefully and keep in vehicle
Printing: February 2017 (01)
Publication No. SU17E0 1H15U0
Page 536 of 556

8. After attaching the child restraint, test it be-fore you place the child in it. Push it from side
to side while holding the child restraint near
the seat belt path. The child restraint should
not move more than 1 inch (25 mm) , from
side to side. Try to tug it forward and check
to see if the belt holds the restraint in place.
If the restraint is not secure, tighten the seat
belt as necessary, or put the restraint in
another seat and test it again. You may need
to try a different child restraint. Not all child
restraints fit in all types of vehicles. 9. Check to make sure the child restraint is
properly secured prior to each use. If the
seat belt is not locked, repeat steps 2
through 8.
10. If the child restraint is installed in the frontpassenger seat, place the ignition switch in
the ON position. Either the
AIR BAG ON> indicator light or
SENGER AIR BAG OFF> indicator light
will illuminate depending on the size of the
child and the type of child restraint used.
See “Front passenger air bag and status
light” in the “1. Safety — seats, seat belts
and supplemental restraint system” sec-
tion. After the child restraint is removed and
the seat belt is fully retracted, the ALR
mode (child restraint mode) is canceled.
Forward-facing – step 8
WRS0698
Forward-facing – step 10
LRS2874