2016 Hyundai Creta Owner's Manual

7-95
7
Maintenance
Cleaning the upholstery and interi
or trim
Vinyl
Remove dust and loose dirt from
vinyl with a whisk broom or vacuum
cleaner. Clean vinyl surfaces with a
vinyl cleaner.
Fabric
Remove dust and loose dirt from fab
ric with a whisk broom or vacuum
cleaner. Clean with a mild soap solu
tion recommended for upholstery or
carpets. Remove fresh spots imme
diately with a fabric spot cleaner. If
fresh spots do not receive immediate
attention, the fabric can be stained
and its color can be affected. Also, its
fireresistant proper ties can be
reduced if the material is not proper
ly maintained.
Using anything but recommended
cleaners and procedures may affect
the fabric’s appearance and fire
resistant properties.
Cleaning the lap/shoulder belt
webbing
Clean the belt webbing with any mild
soap solution recommended for
cleaning upholstery or carpet. Follow
the instructions provided with the
soap. Do not bleach or redye the
webbing because this may weaken it.
Cleaning the interior window glass
If the interior glass surfaces of the
vehicle become fogged (that is, cov
ered with an oily, greasy or waxy
film), they should be cleaned with
glass cleaner. Follow the directions
on the glass cleaner container.
Do not scrape or scratch the inside
of the rear window. This may result
in damage to the rear window
defroster grid.
NOTICE
NOTICE

7-96
Maintenance
EMISSION CONTROl SYSTEM
The emission control system of your
vehicle is covered by a written limited
warranty. Please see the warranty
information contained in the Service
Passport in your vehicle.
Your vehicle is equipped with an
emission control system to meet all
emission regulations.
There are three emission control
systems which are as follows.
(1) Crankcase emission control system
(2) Evaporative emission control sys tem
(3) Exhaust emission control system
In order to assure the proper function
of the emission control systems, it is
recommended that you have your
car inspected and maintained by an
authorized HYUNDAI dealer in
accordance with the maintenance
schedule in this manual.1. Crankcase emission control
system
The positive crankcase ventilation
system is employed to prevent air
pollution caused by blowby gases
being emitted from the crankcase.
This system supplies fresh filtered air
to the crankcase through the air
intake hose. Inside the crankcase,
the fresh air mixes with blowby
gases, which then pass through the
PCV valve into the induction system.
2. Evaporative emission control
system
The Evaporative Emission Control
System is designed to prevent fuel
vapors from escaping into the atmos
phere.
Canister
Fuel vapors generated inside the fuel
tank are absorbed and stored in the
onboard canister. When the engine is
running, the fuel vapors absorbed in
the canister are drawn into the surge
tank through the purge control sole
noid valve.
Purge Control Solenoid Valve(PCSV)
The purge control solenoid valve is
controlled by the Engine Control
Module (ECM); when the engine
coolant temperature is low during
idling, the PCSV closes so that evap
orated fuel is not taken into the
engine. After the engine warms up
during ordinary driving, the PCSV
opens to introduce evaporated fuel to
the engine.

7-97
7
Maintenance
3. Exhaust emission control
system
The Exhaust Emission Control
System is a highly effective system
which controls exhaust emissions
while maintaining good vehicle per
formance.
Vehicle modifications
• This vehicle should not be modified. Modification of your vehicle
could affect its performance, safety
or durability and may even violate
governmental safety and emis
sions regulations.
In addition, damage or perform
ance problems resulting from any
modification may not be covered
under warranty.
• If you use unauthorized electronic devices, it may cause the vehicle to
operate abnormally, wire damage,
battery discharge and fire. For your
safety, do not use unauthorized
electronic devices.
Engine exhaust gas precautions
(carbon monoxide)
• Carbon monoxide can be presentwith other exhaust fumes.
Therefore, if you smell exhaust
fumes of any kind inside your vehi
cle, have it inspected and repaired
immediately. If you ever suspect
exhaust fumes are coming into
your vehicle, drive it only with all
the windows fully open. Have your
vehicle checked and repaired
immediately. • Do not operate the engine in con
fined or closed areas (such as
garages) any more than what is
necessary to move the vehicle in or
out of the area.
• When the vehicle is stopped in an open area for more than a short
time with the engine running,
adjust the ventilation system (as
needed) to draw outside air into the
vehicle.
• Never sit in a parked or stopped vehicle for any extended time with
the engine running.
• When the engine stalls or fails to start, excessive attempts to restart
the engine may cause damage to
the emission control system.
Exhaust
Engine exhaust gases contain
carbon monoxide (CO). Though
colorless and odorless, it is dan
gerous and could be lethal if
inhaled. Follow the instructions on
this page to avoid CO poisoning.
WARNING

Operating precautions for catalytic
converters (if equipped)
Your vehicle is equipped with a cat
alytic conver ter emission control
device.
Therefore, the following precautions
must be observed:
• Use only UNLEADED FUEL forGasoline engine.
• Do not operate the vehicle when there are signs of engine malfunc
tion, such as misfire or a noticeable
loss of performance.
• Do not misuse or abuse the engine. Examples of misuse are
coasting with the ignition off and
descending steep grades in gear
with the ignition off.
• Do not operate the engine at high idle speed for extended periods (5
minutes or more).
• Do not modify or tamper with any part of the engine or emission con
trol system. All inspections and
adjustments must be made by an
authorized HYUNDAI dealer. • Avoid driving with a extremely low
fuel level. Running out of fuel could
cause the engine to misfire, dam
aging the catalytic converter.
Failure to observe these precautions
could result in damage to the catalyt
ic converter and to your vehicle.
Additionally, such actions could void
your warranties.
Fire
•A hot exhaust system can ignite
flammable items under your
vehicle. Do not park, idle, or
drive the vehicle over or near
flammable objects, such as
grass, vegetation, paper,
leaves, etc.
•The exhaust system and catalyt
ic system are very hot while the
engine is running or immediate
ly after the engine is turned off.
Keep away from the exhaust
system and catalytic, you may
get burned. Also, do not remove
the heat sink around the
exhaust system, do not seal the
bottom of the vehicle or do not
coat the vehicle for corrosion
control. It may present a fire risk
under certain conditions.
WARNING
Maintenance
7-98

8
Specifications & Consumer information
8
Specifications & Consumer information
8
Dimensions ..............................................................8-2
Engine ......................................................................8-2
Bulb wattage ...........................................................8-3
Tires and wheels ....................................................8-4
Recommended lubricants and capacities ...........8-5Recommended sae viscosity number ...........................8-7
Vehicle identification number (VIN) ....................8-8
Vehicle certification label .....................................8-8
Tire specification and pressure label .................8-9
Engine number .......................................................8-9
Air conditioner compressor label ......................8-10

8-2
Specifications & Consumer information
DImENSIoNS
Itemmm (in)
Overall length 4,270 (168.11)
Overall width 1,780 (70.08)
Overall height 1,630 (64.17) / 1,665 (65.55) * 1
Front tread 205/65R16 1,556.5 (61.28)
215/60R171,544.6 (60.81)
Rear tread205/65R161,570 (61.81)
215/60R171,558 (61.34)
Wheelbase2,590 (101.97)
*
1
: with roof rack
ItemU2 1.4 TCIU2 1.6 TCIGamma 1.6 MPI
Displacement cc (cu. in)
1,396 (85.2)1,582 (97.09)1,591 (97.09)
Bore x Stroke mm (in.)
75 x 79 (3.0 x 3.1)77.2 x 84.5 (3.04 x 3.33)77 x 85.44 (3.03 x 3.36)
Firing order
134213421342
No. of cylinders
4. Inline4. Inline4. Inline
ENGINE

bulb wattaGE
8-3
8
Specifications & Consumer information
* : If equipped
Light BulbWattage (W)
Front Headlight
Type A 60/55
Type B 60
Turn signal light 21
Position light Type A 5
Type B LED
Static bending light (SBL)* 55
Fog light* 35
Side Repeater light (Outside mirror) Type A 5
Type B LED
Daytime running light*21/5
Rear Rear combination light Stop/Tail 21/5
Tail 21/5
Turn signal 21
Back up 16
High mounted stop light 5
License plate light 5
Fog light*21
Interior Map lamp
8
Room lamp 8
Sunvisor lamp5
Luggage room lamp 8

8-4
Specifications & Consumer information
tIrES aND whEElS
When replacing tires, use the same size originally supplied with the vehicle.
Using tires of a different size can damage the related parts or make it work irregularly.
CAUTION
*1
: Normal load : Up to 3 persons
ItemTire sizeWheel size
Inflation pressure bar (psi)Wheel lug nut
torque
kgf•m (lbf•ft, N•m)
Normal load *1Maximum load
FrontRearFront Rear
Full size tire 205/65R16 6.0J X 16
230 (33) 230 (33) 250 (36) 250 (36) 9~11
(65~79, 88~107)
215/60R17 6.5J X 17
•It is permissible to add 3 psi to the standard tire pressure specification if colder temperatures are expected soon.
Tires typically loose 1 psi (7 kPa) for every 7°C temperature drop. If extreme temperature variations are expected,
recheck your tire pressure as necessary to keep them properly inflated.
•An air pressure generally decreases, as you drive up to a highaltitude area above sea level. Thus, if you plan to
drive a highaltitude area, check the tire pressures in advance. If necessary, inflate them to a proper level. (Air infla
tion per altitude : +10 kPa/1 km)
NOTICE