2016 Hyundai Creta Owner's Manual

5-33
Driving your vehicle
5
•Do not apply the accelerator pedal
while the parking brake is
engaged. If you depress the accel
erator pedal with the parking brake
engaged, warning will sound.
Damage to the parking brake may
occur.
•Driving with the parking brake on
can overheat the braking system
and cause premature wear or
damage to brake parts. Make sure
the parking brake is released and
the Brake Warning Light is off
before driving.Check the Parking
Brake Warning Light by
placing the ignition
switch to the ON posi
tion (do not start theengine).
This light will be illuminated when the
parking brake is applied with the igni
tion switch in the START or ON position.
Before driving, be sure the parking
brake is released and the Brake
Warning Light is OFF.
NOTICE
•Whenever leaving the vehicle or
parking, always come to a com
plete stop and continue to
depress the brake pedal. Move
the shift lever into the 1st gear
(for manual transaxle vehicle) or
P (Park, for automatic transaxle
vehicle) position, then apply the
parking brake, and place the
ignition switch in the LOCK/OFF
position.
Vehicles with the parking brake
not fully engaged are at risk for
moving inadvertently and caus
ing injury to yourself or others.
•NEVER allow anyone who is
unfamiliar with the vehicle to
touch the parking brake. If the
parking brake is released unin
tentionally, serious injury may
occur.
•Only release the parking brake
when you are seated inside the
vehicle with your foot firmly on
the brake pedal.
WARNING

5-34
Driving your vehicle
If the Parking Brake Warning Light
remains on after the parking brake is
released while engine is running,
there may be a malfunction in the
brake system. Immediate attention is
necessary.
If at all possible, cease driving the
vehicle immediately. If that is not pos
sible, use extreme caution while
operating the vehicle and only con
tinue to drive the vehicle until you
can reach a safe location.Antilock Brake System (ABS) (if
equipped )
ABS is an electronic braking system
that helps prevent a braking skid.
ABS allows the driver to steer and
brake at the same time.
(Continued)
Drive your vehicle at reduced
speeds during the following condi
tions:
•Rough, gravel or snowcovered
roads.
•On roads where the road sur
face is pitted or has different
surface height.
•Tire chains are installed on your
vehicle.
The safety features of an ABS
equipped vehicle should not be
tested by high speed driving or
cornering. This could endanger
the safety of yourself or others.
An AntiLock Braking System
(ABS) will not prevent accidents
due to improper or dangerous
driving maneuvers. Even though
vehicle control is improved during
emergency braking, always main
tain a safe distance between you
and objects ahead of you. Vehicle
speeds should always be reduced
during extreme road conditions.
The braking distance for cars
equipped with ABS may be longer
than for those without these sys
tems in the following road condi
tions.
(Continued)
WARNING

5-35
Driving your vehicle
5
Using ABS
To obtain the maximum benefit from
your ABS in an emergency situation,
do not attempt to modulate your
brake pressure and do not try to
pump your brakes. Depress your
brake pedal as hard as possible.
When you apply your brakes under
conditions which may lock the
wheels, you may hear sounds from
the brakes, or feel a corresponding
sensation in the brake pedal. This is
normal and it means your ABS is
active.
ABS does not reduce the time or dis
tance it takes to stop the vehicle.
Always maintain a safe distance from
the vehicle in front of you.
ABS will not prevent a skid that
results from sudden changes in
direction, such as trying to take a
corner too fast or making a sudden
lane change. Always drive at a safe
speed for the road and weather con
ditions. ABS cannot prevent a loss of stabili
ty. Always steer moderately when
braking hard. Severe or sharp steer
ing wheel movement can still cause
your vehicle to veer into oncoming
traffic or off the road.
On loose or uneven road surfaces,
operation of the antilock brake sys
tem may result in a longer stopping
distance than for vehicles equipped
with a conventional brake system.
The ABS warning light ( ) will stay
on for several seconds after the igni
tion switch is in the ON position.
During that time, the ABS will go
through selfdiagnosis and the light
will go off if everything is normal. If
the light stays on, you may have a
problem with your ABS. We recom
mend that you contact an authorized
HYUNDAI dealer as soon as possi
ble.
If the ABS warning light () is on
and stays on, you may have a
problem with the ABS. Your power
brakes will work normally. To
reduce the risk of serious injury or
death, we recommend that you
contact your HYUNDAI dealer as
soon as possible.
WARNING

5-36
Driving your vehicle
Information
When you jump start your vehicle
because of a drained battery, the ABS
warning light ( ) may turn on at the
same time. This happens because of
the low battery voltage. It does not
mean your ABS is malfunctioning.
Have the battery recharged before
driving the vehicle.Electronic Stability Control (ESC)
(if equipped)
The Electronic Stability Control
(ESC) system helps to stabilize the
vehicle during cornering maneuvers.
ESC checks where you are steering
and where the vehicle is actually
going. ESC applies braking pressure
to any one of the vehicle’s brakes
and intervenes in the engine man
agement system to assist the driver
with keeping the vehicle on the
intended path. It is not a substitute
for safe driving practices. Always
adjust your speed and driving to the
road conditions.
i
When you drive on a road having
poor traction, such as an icy road,
and apply your brakes continuous
ly, the ABS will be active continu
ously and the ABS warning light
() may illuminate. Pull your car
over to a safe place and turn the
engine off.
Restart the engine. If the ABS
warning light is off, then your ABS
system is normal. Otherwise, you
may have a problem with your
ABS system. We recommend that
you contact an authorized
HYUNDAI dealer as soon as pos
sible.
CAUTION
OGC054007

ESC operation
ESC ON condition
When the ignition switch is in the ON
position, the ESC and the ESC OFF
indicator lights illuminate for approxi
mately three seconds and goes off,
then the ESC is turned on.
When operating
When the ESC is in opera
tion, the ESC indicator light
blinks:
• When you apply yourbrakes under conditions
which may lock the
wheels, you may hear
sounds from the brakes, or
feel a corresponding sen
sation in the brake pedal.
This is normal and it
means your ESC is active.
• If the Cruise Control was in use when the ESC activates, the Cruise
Control automatically disengages.
The Cruise Control can be reen
gaged when the road conditions
allow. See “Cruise Control System”
later in this chapter. (if equipped).
• When moving out of the mud or driving on a slippery road, the
engine rpm (revolutions per minute)
may not increase even if you press
the accelerator pedal deeply. This is
to maintain the stability and traction
of the vehicle and does not indicate
a problem.
5-37
Driving your vehicle
5
Never drive too fast for the road
conditions or too quickly when cor
nering. The ESC system will not
prevent accidents.
Excessive speed in turns, abrupt
maneuvers, and hydroplaning on
wet surfaces can result in severe
accidents.
WARNING

ESC OFF condition
This vehicle has 2 kinds of
ESC off states.
If the engine stops when
ESC is off, ESC remains off.
Upon restarting the engine,
the ESC will automatically
turn on again. To cancel ESC operation :
• State 1
Press the ESC OFF button shortly
(ESC OFF indicator light and mes
sage illuminates). At this state, the
engine control function does not
operate. The traction control function
does not operate but only the brake
control function operates.
• State 2
Press the ESC OFF button for more
than 3 seconds. ESC OFF indicator
light will illuminate.
At this state, the engine control func
tion and brake control function does
not operate. The vehicle stability con
trol function does not operate any
more.
Indicator lights
When the ignition switch is pressed
to the ON position, the ESC indicator
light illuminates, then goes off if the
ESC system is operating normally.
The ESC indicator light blinks when
ever the ESC is operating.
If ESC indicator light stays on, your
vehicle may have a malfunction with
the ESC system. When this warning
light illuminates we recommend that
the vehicle be checked by an author
ized HYUNDAI dealer as soon as
possible.
5-38
Driving your vehicle
■ ESC indicator light (blinks)
■ ESC OFF indicator light (comes on)

The ESC OFF indicator light comes
on when the ESC is turned off with
the button.
Driving with wheels and tires with dif
ferent sizes may cause the ESC sys
tem to malfunction. Before replacing
tires, make sure all four tires and
wheels are the same size. Never
drive the vehicle with different sized
tires and wheels installed.
ESC OFF usage
When Driving
The ESC OFF mode should only be
used briefly to help free the vehicle if
stuck in snow or mud by temporarily
stopping operation of the ESC to
maintain wheel torque.
To turn ESC off while driving, press
the ESC OFF button while driving on
a flat road surface.To prevent damage to the transaxle:
•Do not allow wheel(s) of one axle
to spin excessively while the ESC,
ABS, and parking brake warning
lights are displayed. The repairs
would not be covered by the vehi
cle warranty. Reduce engine
power and do not spin the wheel(s)
excessively while these lights are
displayed.
•When operating the vehicle on a
dynamometer, make sure the ESC
is turned off (ESC OFF light illumi
nated).
Information
Turning the ESC off does not affect
ABS or standard brake system operation.NOTICEi
NOTICE
5-39
Driving your vehicle
5
When the ESC is blinking, this
indicates the ESC is active:
Drive slowly and NEVER attempt
to accelerate. NEVER turn the
ESC off while the ESC indicator
light is blinking or you may lose
control of the vehicle resulting in
an accident.
WARNING

Vehicle Stability Management (if
equipped)
Vehicle Stability Management (VSM)
helps ensure the vehicle stays stable
when accelerating or braking sud
denly on wet, slippery and rough
roads where traction over the four
tires can suddenly become uneven.
VSM operation
VSM ON condition
The VSM operates when:
• The Electronic Stability Control(ESC) is on.
• Vehicle speed is approximately above 15 km/h (9 mph) on curve
roads.
• Vehicle speed is approximately above 20 km/h (12 mph) when the
vehicle is braking on rough roads.
When operating
When you apply your brakes under
conditions which may activate the
ESC, you may hear sounds from the
brakes, or feel a corresponding sen
sation in the brake pedal. This is nor
mal and it means your VSM is active.
Information
The VSM does not operate when:
• Driving on bank road such as gradi ent or incline
• Driving rearward.
• ESC OFF indicator light is on.
• EPS (Electronic Power Steering) warning light ( ) is on. i
5-40
Driving your vehicle
Take the following precautions
when using the Vehicle Stability
Management (VSM):
•ALWAYS check the speed and
the distance to the vehicle
ahead. The VSM is not a substi
tute for safe driving practices.
•Never drive too fast for the road
conditions. The VSM system will
not prevent accidents.
Excessive speed in bad weath
er, slippery and uneven roads
can result in severe accidents.
WARNING