2016 Hyundai Creta Owner's Manual

2-11
Safety system of your vehicle
2
To prevent damage, NEVER hit or
pull on the headrests.
If you recline the seatback towards
the front with the head restraint and
seat cushion raised, the head
restraint may come in contact with
the sunvisor or other parts of the
vehicle.
Adjusting the height up and down
To r aise the headrest, pull it up to the
desired position (1). To lower the
headrest, push and hold the release
button (2) on the headrest support
and lower the headrest to the desired
position (3).
NOTICE
NOTICE
(Continued)
•NEVER adjust the headrest
position of the driver’s seat when
the vehicle is in motion.
•Adjust the headrest as close to
the passenger’s head as possi
ble. Do not use a seat cushion
that holds the body away from
the seatback.
•Make sure the headrest locks
into position after adjusting it.OLF034015OGS035023

Removal/Reinstall
To remov e the headrest:
1. Recline the seatback (2) with the recline lever (1).
2. Raise headrest as far as it can go.
3. Press the headrest release button (3) while pulling the headrest up (4). To reinstall the headrest :
1. Put the headrest poles (2) into the
holes while pressing the release
button (1).
2. Recline the seatback (4) with the recline lever (3).
3. Adjust the headrest to the appro priate height.
2-12
Safety system of your vehicle
NEVER allow anyone to ride in a
seat with the headrest removed.
WARNING
OGS035010
OGS035012
■ Type A
■Type BOGS035011
OGS035009
■Type A
■Type B

Seatback pocket (if equipped)Rear seats
Headrest
The rear seats are equipped with
headrests in all the seating positions
for the occupant's safety and com
fort.
The headrest not only provides com
fort for passengers, but also helps to
protect the head and neck in the
event of a collision. 2-13
Safety system of your vehicle
2
Always make sure the headrest
locks into position after reinstalling
and adjusting it properly.
WARNING
Seatback pockets
Do not put heavy or sharp objects
in the seatback pockets. In an
accident they could come loose
from the pocket and injure vehicle
occupants.
WARNING
OGC034023
OGS035036

2-14
Safety system of your vehicle
To prevent damage, NEVER hit or
pull on the headrests.
Adjusting the height up and down
(if equipped)
To r aise the headrest, pull it up (1).
To lower the headrest, push and hold
the release button (2) on the head
rest support and lower the headrest
(3). NOTICE
(Continued)
•NEVER adjust the headrest
position of the driver’s seat when
the vehicle is in motion.
•Adjust the headrest as close to
the passenger’s head as possi
ble. Do not use a seat cushion
that holds the body away from
the seatback.
•Make sure the headrest locks
into position after adjusting it.
To reduce the risk of serious injury
or death in an accident, take the
following precautions when
adjusting your headrests:
•Always properly adjust the head
rests for all passengers BEFORE
starting the vehicle.
•NEVER let anyone ride in a seat
with the headrests removed.
•
Adjust the headrests so the middle
of the headrests is at the same
height as the height of the top of
the eyes.
(Continued)
WARNING
OLF034072N
OGC034018

2-15
Safety system of your vehicle
2
Removal (if equipped)
To remove the headrest, raise it as far
as it can go then press the release
button (1) while pulling upward (2).
To reinstall the headrest, put the
headrest poles (3) into the holes
while pressing the release button (1).
Then adjust it to the appropriateheight.
Folding the rear seat
The rear seatbacks (or cushions)
may be folded to facilitate carrying
long items or to increase the luggage
capacity of the vehicle.
•Never allow passengers to sit on
top of the folded down seatback
while the vehicle is moving as
this is not a proper seating posi
tion and no seat belts are avail
able for use. This could result in
serious injury or death in case of
an accident or sudden stop.
•Objects carried on the folded
down seatback should not
extend higher than the top of the
front seats. This could allow
cargo to slide forward and cause
injury or damage during sudden
stops.
WARNING
Make sure the headrest locks in
position after adjusting it to prop
erly protect the occupants.
WARNING
OGC034019
•For maximum effectiveness in
case of an accident, the head
rest should be adjusted so the
middle of the headrest is at the
same height as the center of
gravity of an occupant's head.
•Do not operate the vehicle with
the headrests removed. Severe
injury to an occupant may occur
in the event of an accident.
Headrests may provide protec
tion against severe neck injuries
when properly adjusted.
WARNING

2-16
Safety system of your vehicle
Type A
1. Set the front seatback to the
upr ight position and if necessary,
slide the front seat forward.
2. Insert the rear lap/shoulder belt plate into the holder on the seat
and side trim. It will prevent the
lap/shoulder belt from interfering
with the seatback when folding. 3. Pull up both sides of the seatback
lever and fold the seatback toward
the front of the vehicle. To use the rear seat, lift and push up
the seatback backward. Push the
seatback firmly until it clicks into
place. Make sure the seatback is
locked in place.
When returning the rear seatbacks to
the upright position, remember to
return the rear shoulder belts to their
proper position.
OGS035031
OGS035013
OGS035014

2-17
Safety system of your vehicle
2
Type B
1. Inser t the rear seat belt webbing in
the guide to prevent the seat belt
from being damaged.
2. Set the front seatback to the upright position and if necessary,
slide the front seat forward.
3. Lower the rear headrests to the lowest position. 4. Pull up the seatback lever, then
fold the seat toward the front of the
vehicle. 5. To use the rear seat, lift and push
up the seatback backward. Push
the seatback firmly until it clicks
into place. Make sure the seatback
is locked in place.
When returning the rear seatbacks to
the upright position, remember to
return the rear shoulder belts to their
proper position.
OGC034006OGC034009OGS035037

2-18
Safety system of your vehicle
•When returning the rear seatbacks
to the upright position, remember
to return the rear shoulder belts to
their proper position.
•Routing the seat belt webbing
through the rear seat belt guides
will help keep the seat belts from
being trapped behind or under the
seats.
NOTICE
Cargo
Cargo should always be secured to
prevent it from being thrown about
the vehicle in a collision and caus
ing injury to the vehicle occupants.
Do not place objects in the rear
seats, since they cannot be proper
ly secured and may hit the front
seat occupants in a collision.
WARNING
When you return the rear seat
back to its upright position after
being folded down:
Be careful not to damage the seat
belt webbing or buckle. Do not
allow the seat belt webbing or
buckle to get caught or pinched in
the rear seat. Ensure that the
seatback is completely locked into
its upright position by pushing on
the top of the seatback.
Otherwise, in an accident or sud
den stop, the seat could fold down
and allow cargo to enter the pas
senger compartment, which could
result in serious injury or death.
WARNING
Cargo loading
Make sure the engine is off, the
manual transaxle is in R (Reverse)
or 1st, and the parking brake is
securely applied whenever loading
or unloading cargo. Failure to take
these steps may allow the vehicle
to move if the shift lever is inadver
tently moved to another position.
WARNING