2015 Peugeot RCZ Owner's Manual

87
RCZ_en_Chap05_securite_ed01-2015
DIRECTION INDICATORS
If you forget to cancel the direction indicators for more than
twenty seconds, the volume of the audible signal will increase if
the speed is above 40 mph (60 km/h).
F

Left: lower the lighting stalk passing the point of resistance.
F


Right: raise the lighting stalk passing the point of resistance.
HAZARD WARNING LAMPS
A visual warning by means of the direction indicators to alert other road\

users to a vehicle breakdown, towing or accident.
F Press
this button, the direction indicators flash.
They can operate with the ignition off.
AUTOMATIC OPERA TION OF HAZAR d
W

ARNING LAMPS *
When braking in an emergency, depending on the deceleration, the
hazard warning lamps come on automatically.
They
switch off automatically the first time you accelerate.
F

Y
ou can also switch them off by pressing the button.
Deactivating the DSC/ASR systems also deactivates the automatic
operation of the hazard warning lamps; refer to the "Trajectory control
systems - Deactivation" section.
* Except for the 1.6 THP 270 hp version.
Three flashes of the direction indicators
F Press briefly upwards or downwards, without going beyond the point of resistance; the direction indicators will flash 3 times.
5/
SAFETY

88
RCZ_en_Chap05_securite_ed01-2015
HORN
Audible warning to alert other road users to an imminent danger.
F
Press one of the spokes of the steering wheel.
EMERGENCY OR ASSISTANCE
CALL
This system allows you to make an emergency or assistance call to the
emergency services or to the dedicated PEUGEOT service.
For more information on the use of this function, refer to the
"Audio
equipment and telematics" section. Use the horn with moderation, observing the driving regulations of
the country you are driving in.

89
RCZ_en_Chap05_securite_ed01-2015
BRAKING ASSISTANCE SYSTEMS
Group of supplementary systems which help you to obtain optimum
braking in complete safety in emergency situations:
-
anti-lock braking system (ABS),
-


electronic brake force distribution (EBFD),
-


emergency braking assistance (EBA).
ANTI-LOCK BRAKING SYSTEM AN d
ELECTRONIC

BRAKE FORCE d ISTRIBUTION
Linked systems which improve the stability and manoeuvrability of your
vehicle when braking, in particular on poor or slippery surfaces.
Activation
The anti-lock braking system comes into operation automatically when
there is a risk of wheel lock.
Normal operation of the ABS may make itself felt by slight vibration of
the brake pedal.
When
braking in an emergency, press very firmly without releasing
the pressure.
Operating fault
If this warning lamp comes on, accompanied by an audible
signal and a message in the screen, it indicates a malfunction
of the anti-lock braking system which could result in loss of
control of the vehicle when braking. If this warning lamp comes on, together with the
STOP and
ABS warning lamps, accompanied by an audible signal and
a message in the screen, it indicates a malfunction of the
electronic brake force distribution which could result in loss of contro\
l of
the vehicle when braking.
You must stop as soon as it is safe to do so.
In either case, contact a PEUGEOT

dealer or a qualified workshop.
When replacing wheels (tyres and rims), ensure that they conform
to the manufacturer's recommendations.
When braking in an emergency, press firmly without releasing the
pressure.
EMERGENCY BRAKING ASSISTANCE
System which, in an emergency, enables you to obtain the optimum
braking
pressure more quickly, thus reducing the stopping distance.
Activation
It is triggered by the speed at which the brake pedal is pressed.
The effect of this is a reduction in the resistance of the pedal and an
increase
in braking efficiency.
5/
SAFETY

90
RCZ_en_Chap05_securite_ed01-2015
TRAjECTORY CONTROL SYSTEMS
dYNAMIC STABILITY CONTROL ( d SC) AN d
ANTI

- SLIP

REGULATION (ASR)
The anti-slip regulation (also known as traction control) optimises
traction to prevent skidding of the wheels, by acting on the brakes of t\
he
driving wheels and on the engine.
The electronic stability control acts on the brake of one or more wheels\

and
on the engine to keep the vehicle on the trajectory required by the
driver

, within the limits of the laws of physics.
Activation
These systems are activated automatically each time the vehicle is
started.
These systems act on the operation of the engine and brakes as soon
as they detect a problem of grip or trajectory. This
is indicated by flashing of this warning lamp in the
instrument panel.
SNOW dRIVING ASSISTANCE
(I NTELLIGENT T RACTION C ONTROL )
Your vehicle has a system to help driving on snow: Intelligent Traction
Control.
This
automatic system continuously checks for situations of difficult
surface

adhesion that could make it difficult to move off or make
progress on deep fresh snow or compacted snow

.
In these situations, Intelligent Traction Control limits the amount of
wheel slip to provide the best traction and trajectory control.
In extremely severe conditions (deep snow, mud…), it can be useful to
temporarily deactivate the dynamic stability control and wheel anti-
slip systems to allow a degree of wheel spin and so recover grip.
It is recommended that the system be reactivated as soon as possible.
Snow tyres are strongly recommended on surfaces offering low levels
of adhesion.

91
RCZ_en_Chap05_securite_ed01-2015
deactivation
In exceptional conditions (starting a vehicle which is bogged down,
stuck in snow, on soft ground...), it may be advisable to deactivate the
DSC and ASR, so that the wheels can turn freely and regain grip.
Reactivate the systems as soon as the level of grip permits.
F
Press this button.
The indicator lamp in the button comes on.
The DSC

and ASR systems no longer act on the operation of the engine
and on the brakes in the event of a involuntary change of trajectory.
This action also deactivates the automatic operation of hazard warning
lamps (except for the 1.6 THP 270 hp version).
Reactivation
The systems are reactivated automatically every time the ignition is
switched back on.
You can also reactivate them manually:
F

Press this button again.
This action also reactivates the automatic operation of hazard warning
lamps (except for the 1.6

THP 270 hp version).
Operating fault
d

SC/ASR
The DSC and ASR systems offer increased safety in normal
driving, but they should not encourage the driver to take extra
risks or drive at high speed.
It is in difficult driving conditions (rain, snow, ice) that the risk of
loss of grip increases. It is therefore important for your safety to
keep the DSC and

ASR systems activated in all conditions, and
particularly
in difficult conditions.
The correct operation of these systems depends on observation
of the manufacturer's recommendations regarding as much the
wheels (tyres and rims), braking and electronic components as the
assembly and repair procedures used by PEUGEOT dealers.
To
benefit in full from the effectiveness of the DSC and
ASR

systems

in wintry conditions, the vehicle must be fitted with four
snow tyres, allowing the the vehicle to retain neutral behaviour on
the road.Illumination of this warning lamp and the lamp in the
deactivation button, accompanied by an audible signal and a
message, indicate a fault with the system.
Contact
a PEUGEOT

dealer or a qualified workshop to have the system
checked.
After an impact, have these systems checked by a PEUGEOT

dealer
or a qualified workshop.
5/
SAFETY

92
RCZ_en_Chap05_securite_ed01-2015
ACTIVE BONNET
Operating fault
The active bonnet has been designed to maximise the safety of
pedestrians in the event of an impact with the front of the vehicle.The deployment of the active bonnet is accompanied by a slight
emission of harmless smoke and a noise, due to the activation
of the pyrotechnic cartridge integrated in the system. The airbag
warning lamp comes on.
After deployment, close the bonnet by pressing on the hinges.
Go
to the nearest PEUGEOT

dealer or a qualified workshop at a
maximum speed of 20 mph (30 km/h). This system can only operate once. If a second impact occurs
(during

the same or a subsequent accident), the active bonnet will
not operate.
After an accident or theft of the vehicle, have the system checked.
Do not handle the pyrotechnic systems, located under the bonnet
near the struts: risk of explosion.
All work on this system must be carried out only by the skilled
personnel

of a PEUGEOT

dealer or a qualified workshop.
If this warning lamp comes on on the instrument panel,
accompanied by an audible signal and a message in the
screen,
contact a PEUGEOT

dealer or a qualified workshop to
have the system checked.

The active bonnet may no longer
be deployed in the event of an impact.

93
RCZ_en_Chap05_securite_ed01-2015
ACTIVE SPOILEROPERATION
The use of the vehicle must comply with the legislation in force
in your country. This system can be used to its full potential on a
closed circuit.
Automatic mode
The spoiler rises automatically according to the speed and has two
positions.
-
When the speed of the vehicle is higher than 50 mph (85 km/h), the
spoiler rises automatically to the intermediate position A

. It remains
in this position for as long as the speed remains above 35 mph
(55
km/h).
-

If the speed of the vehicle falls below 35 mph (55 km/h), the spoiler \
retracts automatically

.
-

When the speed of the vehicle is higher than 95 mph (155 km/h),
the spoiler rises automatically to the maximum position B

. It
remains in this position for as long as the speed remains above
90
mph (142 km/h).
-

If the speed of the vehicle falls below 90 mph (142 km/h), the
spoiler retracts automatically to the intermediate position.
In this mode, the indicator lamp in the control button is of

f.
Manual mode
To control the operation of the spoiler manually, with the ignition on:
F press the control button briefly, the spoiler rises to the maximum
position B

.
In this mode, the indicator lamp on the control button is on.
When stationary or moving at less than 6 mph (10 km/h), press and
hold the button until the indicator lamp goes off, the spoiler then retracts
completely.
Except the 1.6 THP 270 hp version
System which improves the aerodynamics and stability of the vehicle
when driving. It can be controlled automatically or manually.
5/
SAFETY

94
RCZ_en_Chap05_securite_ed01-2015
Before operating the spoiler, ensure that no one is in the proximity
of the moving parts to avoid any risk of injury.
Nevertheless, in the event of pinching, you must reverse the
movement of the spoiler. To do this, release the control button
then press it again to raise the spoiler.
MAINTENANCE
To maintain the spoiler, with the vehicle stationary, ignition on:
F
raise the spoiler to the maximum position B

by pressing the button
briefly,
F

once the cleaning is complete, retract the spoiler: press and hold
the button until the end of the manoeuvre.
The keep this system in good working order

, check the spoiler and its
housing periodically preventing the unwanted accumulation of leaves,
ice or snow.
OPERATING F AULT
If the control system fails, the indicator lamp in the control button
flashes,
accompanied by an audible signal and a message in the
screen.

As a safety precaution, the spoiler rises to the maximum
position, regardless of the speed of the vehicle.
If the problem persists and you wish to retract the spoiler:
F

stop where it is safe to do so,
F


switch of
f the ignition,
F

switch the ignition on again.
If

the indicator lamp no longer flashes, the failure was temporary, the
system has resumed normal operation.

To retract the spoiler, refer to
the paragraph "To exit from manual mode".
If
the indicator lamp flashes again and the spoiler is still raised, the
system is still faulty

.
Have
it checked by a PEUGEOT

dealer or a qualified workshop.
In the event of a system operating fault (e.g. jamming of the spoiler)\
, the
indicator
lamp in the control button flashes, accompanied by an audible
signal and a message in the screen. For safety reasons, do not exceed
a speed of 85 mph (140 km/h).
Have

it checked by a PEUGEOT

dealer or a qualified workshop.
Before washing the vehicle, always retract the spoiler into its
housing.
Keep the end of the high-pressure nozzle at least 1 metre from the
spoiler housing. Never press on the spoiler to close the boot or push the vehicle as
this may damage it.
The installation of load-carrying accessories on the vehicle limits
the effectiveness of the spoiler.
Do not install load carrying accessories which are not
recommended by PEUGEOT.
To exit from manual mode:
F press

the

button

briefly:

the

indicator

lamp

on

the

button

goes

off

(return to automatic mode).
At speeds below 6 mph (10 km/h), the spoiler stays in the open
position. It retracts automatically as soon as the vehicle exceeds
this speed threshold.