2014.5 Citroen BERLINGO MULTISPACE RHD Owner's Manual

23
Berlingo_2_VP_en_Chap03_Pret-a-partir_ed02-2014
Operation in the event of a
battery failure
Front and side passenger doors
In the event of a battery or of the
central  locking   fault,   use   the   lock   to  
lock

  the   doors   mechanically.
-

T
o open the door and get out of the
vehicle,
  pull   the   interior   control.
-
 
T
o   lock   the   door,   insert   the   key   in  
the

  lock,   located   on   the   edge   of   the  
door

, then turn it one eighth of a
turn.
d

river's door
-
 
Insert
  the   key   in   the   lock,   then   turn  
it

  to   the   right   to   lock   or   to   the   left   to  
unlock.
tAILGAtE
From inside
Emergency control
In  the   event   of   a   central   unlocking  
operating

  fault,   this   permits   unlocking  
of

  the   tailgate   from   the   inside.
Insert
  a   small   screwdriver   in   the  
opening, between the tailgate and the
floor

.  
T
o   unlock   the   lock,   move   the  
catch

  to   the   left   then   push   the   tailgate.
From outside
Locking/unlocking is by means of the remote  control.
To open, press the control below the
trim
  then   raise   the   tailgate.
a pull strap is available to close the
tailgate

  in   the   high   position.
Guide the closing of the tailgate to the
balance point of its travel then apply
a
  final   press   on   the   tailgate   to   close   it  
fully

.
access
REadY To Go
3

24
Berlingo_2_VP_en_Chap03_Pret-a-partir_ed02-2014
HInGEd rEAr dOOrS
From outside
To open, pull the handle towards you. Pull the lever to open the right-hand
door
.
To close, start with the right-hand door
then   close   the   left-hand   door.
With   the   roof   rear   flap,   the   rear   bumper  
has been reinforced to serve as a
footrest

  when   entering   the   vehicle.
The hinged rear doors are
asymmetrical   (2/3   -   1/3),   with   the  
smaller

  door   on   the   right.
They   are   fitted   with   a   central   lock.
tailgate screen
The opening rear screen allows you to
access the rear of the vehicle directly,
without
  having   to   open   the   tailgate.
Opening
After
  unlocking   the   vehicle   using   the  
remote

  control   or   the   key,   press   the  
control and raise the rear screen to
open

  it.
c

losing
Close the rear screen by pressing
the centre of the glass until it is fully
closed.
The tailgate and tailgate screen
cannot both be open at the
same

  time,   to   prevent   damage   to  
the screen.
access

25
Berlingo_2_VP_en_Chap03_Pret-a-partir_ed02-2014
In practice
It is possible to drive with the right-
hand  door   open   to   make   it   easier   to  
carry

  long   loads.  
The
  left-hand   door   is  
kept

  closed   by   the   distinctive   "yellow"  
lock,

  positioned   at   the   base   of   the   door.  
This

  closed   door   must   not   be   used   as  
a

  load   retainer.
d

riving with the right-hand door open
is
  a   special   dispensation.   Comply   with  
the usual safety indications to warn
other

  drivers.
From inside
When present on the vehicle, pulling
this handle towards you opens the left-
hand  door.
Opening to approximately 180°
A check   strap   system   permits   extension  of
  the   opening   from   approximately   90°  
to

  approximately   180°.
Pull the yellow control when the door is
open.
The
  check   strap   will   engage   again  
automatically

  on   closing.
When parked with the rear  doors   open   to   90°,  
the

  doors   mask   the   rear  
lamps.

 
T
o   signal   your  
position to other road
users

  driving   in   the   same  
direction

  who   may   not  
have seen your vehicle,
use a warning triangle
or

  other   device   required  
by the legislation in your
country

.
access
REadY To Go
3

26
Berlingo_2_VP_en_Chap03_Pret-a-partir_ed02-2014
rEAr rOOF FLAPSupport bar
a support bar is provided for
transporting long loads, after opening
the
  rear   roof   flap.
Fold
  back   the   support   bar   by   lifting   the  
lever

.
Guide
  it   to   the   door   pillar.
Support the long loads to be
transported,
  lift   them   and   reposition   the  
support

  bar   with   one   hand.
Ensure that it is secured correctly by
pressing the handle downwards past
the point of resistance and secure the
loads
  firmly. The
  rear   bumper   has   been  
reinforced to serve as a footrest
when

  entering   the   vehicle.
The   rear   doors   only   lock   when   the  
support

  bar   is   installed.
When
  the   rear   roof   flap   is   open,   take  
care when driving where height is
restricted.
n

ever rest loads directly on the rear
doors.
Comply
  with   the   usual   indications,   to  
warn

  other   drivers.
Reserve
  the   use   of   the   rear   roof   flap  
for

  short   journeys.
The side supports can be used as
hooking
  points.
-  
lower
  the   black   paddle   to   secure  
the

  rear   roof   flap.
Securing   the   rear   roof   flap   places   it   on  
the seal correctly and ensures sealing
without

  noise.
This
 
rear
 
roof
 
flap
 
is
 
only
 
compatible
 
with

 
side-hinged
 
rear
 
doors.
To
 
open
 
the
 
rear
 
roof
 
flap:
-
 
raise

 
the
 
black
 
paddle
 
of
 
the
 
toggle,
-

relieve the toggle by pressing the
rear

 
roof
 
flap
 
(downwards)
 
then
 release
 
the
 
hook,
-
 lift
 
the
 
rear
 
roof
 
flap,
-

pass the point of resistance to
secure

 
the
 
rear
 
roof
 
flap
 
using
 
the
 
support

 
stays.
Never
 
drive
 
without
 
the
 
stays
 
in
 
place.
To
 
close
 
the
 
rear
 
roof
 
flap:
-
 
check

 
that
 
the
 
support
 
bar
 
is
 
secured correctly

,
-
 
lower

 
the
 
rear
 
roof
 
flap,
-
 
while

 
pressing
 
the
 
rear
 
roof
 
flap
 
(downwards),

 
take
 
hold
 
of
 
the
 
two
 
loops of the spring then place the
hook

 
in
 
its
 
housing,
n
ever attach any load to the rear roof
flap.n ever drive without the support bar in
place.
access

27
Berlingo_2_VP_en_Chap03_Pret-a-partir_ed02-2014
cEntrAL LOcKInG
An initial press permits central  locking   of   the   vehicle,  
when all of the doors are
closed.
A
 

second   press   permits  
central

 
unlocking   of   the   vehicle.
The control is inactive when the vehicle
has
 
been
  locked   using   the   remote  
control

 
or   the   key   from   the   outside.
The
 
doors   can   still   be   opened   from   the  
inside.
d
oor open warning lamp
The
  control   switch   LED:
-
flashes when the doors are locked with the vehicle stationary and the engine of f,
- comes on when the doors are locked and from  the   time   the   ignition   is   switched   on.
Anti-intrusion security
If this warning lamp comes on,  check   that   all   of   your  
vehicle's doors are closed
correctly

.
Locking while driving
When
 
the   vehicle   moves   off,   as   soon  
as

 
you
 
reach   approximately   6   mph  
(10 km/h),

  the   system   locks   the   doors.  
The

 
characteristic   central   locking   noise  
is

 
heard.
 
The
  LED   in   the   switch   on   the  
dashboard

  central   switch   panel   comes  
on.
During

 
the   journey,   opening   a   door  
results

 
in
  complete   unlocking   of   the  
vehicle.
Activating / deactivating the
function
With the ignition on, press
and hold this switch to
activate or deactivate the
function.
Driving

 
with
 
the
 
doors
 
locked
 
may
 make
 
access
 
to
 
the
 
interior
 
more
 
difficult

 
in
 
an
 
emergency.
access
REadY To Go
3

Berlingo_2_VP_en_Chap03_Pret-a-partir_ed02-2014
28
dials
1. Distance  recorder   in   kilometres   /  miles.
2.
 
Screen.
3.

 
Fuel
  level,   coolant   temperature.
4.
 
Rev
  counter.
5.
 
T
rip   distance   recorder   /   service  
indicator

  zero   reset.
6.
 
Instrument
  panel   lighting   dimmer.
Level 2 display screen
Instrument panel
Level 1 display screen
displays
- Speed  limiter   /   Cruise   control.
-  
Kilometres
  /   Miles   travelled.
-
 
Service
  indicator,   total   kilometres   /  
miles.
-


Presence of water in the
d iesel
filter.
-
 
Diesel
  pre-heating.
Screens
The format of the information presented in the screen depends on
the  vehicle's   equipment.
Instruments and controls

Berlingo_2_VP_en_Chap03_Pret-a-partir_ed02-2014
29
centre console with screen
Instrument panel without screen
-
turn to the right to increase the
hours (hold the button to the right
for rapid scrollin

g),
-
 
turn
  to   the   left:   24H   or   12H   is  
displayed,
-


turn to the right to select 24H or
12H,
-

 
turn
  to   the   left   to   complete   the   time  
adjustment.
After

  approximately   30   seconds  
without any action, the screen returns
to

  the   normal   display.
AdJuStInG tHE tIME
To adjust the time and date indicated in the screen, refer to
the  "Adjusting   the   date   and   time"  
section

  of   chapter   10.
centre console without screen
The display - time sequence is  linked   according   to   model  
(version).

 
The
  access   to  
the

  "Date"   adjustment   is  
only

  active   when   the   model  
version

 
of
fers  
a
 
date
 
in
 
words.
T

o
 
adjust
 
the
 
time
 
of
 
the
 
clock, use the left-hand button on

the
 
instrument
 
panel
 
then
 carry out the operations in the


following
 
order:
-
 
turn

 
to
 
the
 
left:
 
the
 
minutes
 
flash,
-

turn to the right to increase the
minutes

 
(hold
 
the
 
button
 
to
 
the
 
right
 
for rapid scrollin

g),
-
 
turn

 
to
 
the
 
left:
 
the
 
hours
 
flash,
Instruments and controls
REadY To Go
3

Berlingo_2_VP_en_Chap03_Pret-a-partir_ed02-2014
30
Warning lamps
Each time the vehicle is started: a series of warning lamps comes on applying a self-test check. They  go   off   almost   immediately.
When   the   engine   is   running:   the   warning   lamp   becomes   a   warning   if   it   remains   on   continuously   or   flashes.  
This
  initial   warning  
may

  be   accompanied   by   an   audible   signal   and   a   message   which   appears   in   the   screen.
Do
  not   ignore   these   warnings.
Warning lamp is indicatesSolution - action
S t
OP on, associated
with another
warning
lamp

  and  
accompanied

 
by

  a   message  
in

  the   screen.major
  faults   linked   with  
the

  "Brake   fluid   level",  
"Engine oil pressure and
temperature",

  "Coolant  
temperature",

  "Electronic  
brake

  force   distribution"   and  
"Power steering" warning
lamps.Y

ou must stop as soon as it is safe to do
so. Park and switch off the ignition. Have it
checked by a
c I tr OË n dealer or a qualified
workshop.
Parking
brake / Brake
fluid level /
EBF
d
on.that the parking  brake  is  applied or
  has   not   been   released   fully.Releasing the parking brake switches off the warning  lamp.
on. low
 
brake
 
fluid
 
level. Top   up   using   a   fluid   recommended   by   CITROËN.
remaining on even though the level
is correct and
associated with the
ABS
 
warning
 
lamp.
a fault with the electronic
brake  force   distribution. You must stop as soon as it is safe to do
so. Park and switch off the ignition. Have it
checked by a CITROËN dealer or a qualified
workshop.
Engine oil
pressure and
temperature on while
driving.
low pressure or a high
temperature. Park
  and   switch   off   the   ignition   then   allow   to   cool.  
V

isually   check   the   level.
Chapter
  7,   "Levels"   section.
remaining on, even though the
level  is   correct.a major fault. Have   it   checked   by   a   CITROËN   dealer   or   a  qualified
  workshop.
Instruments and controls