2014.5 Citroen BERLINGO MULTISPACE RHD Owner's Manual

Berlingo_2_VP_en_Chap08_aide-rapide_ed02-2014
175
PASSEnGEr cOMPArtMEnt FuSES
Fuses F Amperes
 
Aa
llocation
1 - Spare
2 20 Heated seats
3 - Spare
4 15 Folding
  mirrors   relay
5 15 Refrigeration
  equipment   socket   relay
Changing a fuse
QUICk HELP
8

Berlingo_2_VP_en_Chap08_aide-rapide_ed02-2014
176
FuSES undEr tHE BOnnEt
after opening the bonnet, unclip and tilt
the corresponding box to gain access
to
  the   fuses. Fuses
F Amperes  Aa
llocation
1 20 Engine
  management
2 15 Horn
3 10 Front
  and   rear   wash-wipe   pump
4 20 Headlamp
  wash   pump
5 15 Engine
  components
6 10 Steering wheel angle sensor,
d SC
7 10Brake
  switch,   clutch   switch
8 25 Starter
9 10Headlamp
  beam   motor,   parc   management   unit
10 30 Engine
  components
11 40 Spare
12 30 Wipers
13 40 Built-in
  systems   interface
14 30 Pump
15 10 Right-hand
  main   beam   headlamp
16 10Left-hand
  main   beam   headlamp
17 15Right-hand
  dipped   beam   headlamp
18 15 Left-hand
  dipped   beam   headlamp
Changing a fuse

Berlingo_2_VP_en_Chap08_aide-rapide_ed02-2014
177
Placing the windscreen wiper
blades in the special position
- Less  than   a   minute   after   switching  of
f  the  ignition,  press  the  wiper  stalk  
downwards to position the wiper
blades along the windscreen pilla

rs
(special
  position).
c
hanging a front wiper blade
-  
Lift
  the   wiper   arm.
-  Unclip   the   blade   and   remove   it.
-  Fit   the   new   blade.
-
 
Push
  back   the   wiper   arm.
To return the windscreen wipers to
their
  normal   position,   switch   on   the  
ignition

  and   operate   the   wiper   stalk.
c
hanging the rear wiper blade
-  
Lift
  the   wiper   arm,   then   unclip   the  blade
  and   remove   it.
-  Fit   the   new   blade   and   push   back  
the

  wiper   arm.
cHAnGInG A WIPEr BLAdE
Changing a wiper blade
QUICk HELP
8

Berlingo_2_VP_en_Chap08_aide-rapide_ed02-2014
178
Without lifting (4 wheels on the
road)
You should always use a towing bar.
BEInG tOWEd
Ths procedure involves the use of the
towing eye supplied with the tools for
changing
  a   wheel.
From the front
- Unclip the cover by pressing the
bottom  part.
-
 
Fully
  screw   in   the   removable   towing  
eye.
From the rear
- Unclip the cover using a coin or the
flat  part   of   the   towing   eye.
-
 
Fully
  screw   in   the   removable   towing  
eye. When towing with the engine
switched

  off,   there   is   no   braking   or  
steering

  assistance.
Lifting (only 2 wheels on the
road)
It is preferable to raise the vehicle
using
  professional   lifting   equipment.
Vehicles fitted with a manual
gearbox (d iesel version)
In the case of vehicles fitted with a  manual   gearbox,   the   gear   lever  
must

  be   in   neutral,   failure   to   observe  
this

  special   condition   may   result   in  
damage

  to   transmission   and   braking  
components

  and   the   absence   of  
braking

  assistance   when   the   engine   is  
started

  again.
Chapter
 
9,
 
"Changing
 
a
 
wheel"
 
section.
Having your vehicle towed

Berlingo_2_VP_en_Chap08_aide-rapide_ed02-2014
179
Precautions...
QUICk HELP
8

180
Berlingo_2_VP_en_Chap09_Caract-technique_ed02-2014
dimensions

181
Berlingo_2_VP_en_Chap09_Caract-technique_ed02-2014
dIMEnSIOnS (MM)
Loverall length 4380
H
o
verall height 1801-1862
aWheelbase 2728
B Front overhang 925
C Rear overhang 727
dWidth

  over   panels: without
  mirrors1810
with
  mirrors2112
E Width
  of   front   tracks 1505-1507
F Width
  of   rear   tracks 1554-1556
- Length of the loading surface to the
seat Row 2
990
Row 2, seat fully folded 1343
With front passenger seat folded 3000
dimensions
TECHnICaL daTa
9

182
Berlingo_2_VP_en_Chap09_Caract-technique_ed02-2014
rEAr dOOrS (mm)
M Max
 
threshold
 
with
 
205/65
 
R15
 
tyre
 
and
 
tailgate
 

trim 582
Hinged doors Tailgate
Small Large
nUseable opening height (under panel) 111

8
oWidth 4955431582
dimensions