2010 MITSUBISHI GRANDIS Owner's Manual (in English)

Caution for installing the child re-
straint on vehicles with a front passen-
ger airbag
The
label shown here is attached on vehicles with a
front passenger airbag. WARNING
l Extreme Hazard!
Do

not use a rearward facing child re-
straint on a seat protected by an airbag in
front of it!
l A REARWARD FACING CHILD RE-
STRAINT must NOT be used in the front
passenger seat if the front passenger’s air-
bag has not been deactivated. The force
of an inflating airbag could kill or cause
serious injuries to the child. A rearward
facing child restraint should be used in
the rear seat.
Front passenger’s airbag ON NOTE
l If

you have a rearward facing child restraint
system that cannot be fitted to any seat other
than the front passenger seat, be sure to turn
OFF the front passenger’s airbag ON-OFF
switch before using it. (Refer to “To turn an
airbag off” on page 2-33.)
Front passenger’s air bag OFF WARNING
l A
FORWARD FACING CHILD RE-
STRAINT should be used in the rear seat
whenever possible; if used in the front
seat, adjust the seat to the most rearward
position. Infants and small children
E00406600579
When transporting infants and small children in
your vehicle, follow the instructions given below. Seat and seat belts
2-22
2
Presented by http://mmc-manuals.ru/ \251

Instructions:
l For
small infants, an infant carrier should be
used. For small children whose height when
seated allows the shoulder belt to lie in con-
tact with the face or the throat, a child seat
should be used.
l The child restraint system should be appropri-
ate for your child’s weight and height and
properly fit in the vehicle. For a higher de-
gree of safety: THE CHILD RESTRAINT
SYSTEM SHOULD BE INSTALLED IN
THE REAR SEAT. WARNING
l When
installing a child restraint system,
refer to the instructions provided by the
manufacturer of the restraint system. Fail-
ure to do so can result in severe or fatal
injury to your child.
l After installation, push and pull the child
restraint system back and forth, and side
to side, to see that it is properly secured.
If the child restraint system is not instal-
led securely, it may cause injury to the
child or other occupants in the case of ac-
cident or sudden stops.
l When the child restraint system is not in
use, keep your child or infant seat se-
cured with the seat belt or remove it from
the vehicle in order to prevent injury to
your child.
NOTE l Before

purchasing a child restraint system,
try installing it in the rear seat to make sure there is a good fit. Because of the location of
the

seat belt buckles and the shape of the seat
cushion, it may be difficult to securely install
some manufacturer’s child restraint systems.
If the child restraint system can be pulled for-
ward or to either side easily on the seat cush-
ion after the seat belt has been tightened,
choose another manufacturer’s child restraint
system.

Depending on the seating position in the ve-
hicle and the child restraint system that you
have, the child restraint can be attached us-
ing one of the following 2 locations: • To the lower anchorage in the rear seat,ONLY if the child restraint has ISOFIX
mountings (See page 2-27).
• To the seat belt (See page 2-28).
Older children E00406700192
Children who have outgrown the child restraint sys-
tem should be seated in the rear seat and wear com-
bination lap shoulder belt.
The lap portion of the belt should be snug and posi-
tioned

low on the abdomen so that it is below the
top of the hip-bone. Otherwise, the belt could in-
trude into the child’s abdomen during an accident
and cause injury. WARNING
l Children
who are not buckled up can be
thrown out of the vehicle in an accident.
l Children who are not buckled up can
strike other people in the vehicle in an ac-
cident. WARNING
l A
child should never be left unattended
in your vehicle. When you leave the vehi-
cle, take the child with you. Seat and seat belts
2-23 2
Presented by http://mmc-manuals.ru/ \251

Suitability for various seating positions
E00406800799
6 - person seat Mass group Seating position
Front passenger
Rear outboard Intermediate Outboard
Activated airbag
Deactivated airbag*
1 Left side Right side
0 - Up to 10 kg (0-9 months) XXUU U
0+ - Up to 13 kg (0-2 years) XL*2
U, L*2
U, L*2
U, L*2
I - 9 to 18 kg (9 months - 4 years) L*3
L*3
U, L*3
U, L*3
U, L*3
II & III - 15 to 36 kg (4-12 years) L*4
L*4
U, L*4
U, L*4
U, L*4 *
1
: With front passenger’s airbag deactivated by means of front passenger’s airbag ON-OFF switch.
Key of letters to be inserted in the table above: l U- Suitable for “universal” category restraints approved for use in this mass group.
l UF- Suitable for forward-facing “universal” category restraints approved for use in this mass group.
l L- Suitable for particular child restraints (

MITSUBISHI MOTORS genuine parts).
l B- Built-in restraint approved for this mass group.
l X- Seat position not suitable for children in this mass group.
L (Genuine part information) Genuine parts No. ECE No.
* 2
MZ312807 E1-04301146
* 3 MZ312745
E1-04301136
MZ313045 E1-04301133
* 4
MZ312808 E1-04301148Seat and seat belts
2-24
2
Presented by http://mmc-manuals.ru/ \251

NOTE
l The suitability table above applies to retention of child restraints using seat belts.
l When MITSUBISHI MOTORS
genuine part No. MZ313045 is used on the intermediate outboard seat, it can also be retained by means of ISOFIX child
restraint mountings.
l There is no applicable MITSUBISHI MOTORS Genuine Parts to the Mass Group “0- Up to 10 kg (0-9 months)”.

MITSUBISHI MOTORS Europe B.V. reserves the right to changes without any prior announcement.
For further information, please contact your MITSUBISHI MOTORS Authorized Service Point.
7 - person seat Mass group Seating position
Front passenger
Rear outboard Intermediate Outboard
Intermediate Cen-
tre Activated airbag
Deactivated airbag*
1 Left side Right side
0 - Up to 10 kg
(0-9 months) X XUUU X
0+ - Up to 13 kg (0-2 years) XL*2
U, L*2
U, L*2
U, L*2
L*2
I - 9 to 18 kg (9 months - 4 years) L*
3
L*3
U, L*3
U, L*3
U, L*3
L*3
II & III - 15 to 36 kg (4-12 years) L*4
L*4
U, L*4
U, L*4
U, L*4
X*
1
: With front passenger’s airbag deactivated by means of front passenger’s airbag
ON-OFF switch.
Key of letters to be inserted in the table above: l U- Suitable for “universal” category restraints approved for use in this mass group.
l UF- Suitable for forward-facing “universal” category restraints approved for use in this mass group.
l L- Suitable for particular child restraints (

MITSUBISHI MOTORS genuine parts).
l B- Built-in restraint approved for this mass group.
l X- Seat position not suitable for children in this mass group. Seat and seat belts
2-25 2
Presented by http://mmc-manuals.ru/ \251

L (Genuine part information)
Genuine parts No. ECE No.
* 2
MZ312807 E1-04301146
* 3 MZ312745
E1-04301136
MZ313045 E1-04301133
* 4
MZ312808 E1-04301148NOTE
l The suitability table above applies to retention of child restraints using seat belts.
l When MITSUBISHI MOTORS
genuine part No. MZ313045 is used on the intermediate outboard seat, it can also be retained by means of ISOFIX child
restraint mountings.
l There is no applicable MITSUBISHI MOTORS Genuine Parts to the Mass Group “0- Up to 10 kg (0-9 months)”.

MITSUBISHI MOTORS Europe B.V. reserves the right to changes without any prior announcement.
For further information, please contact your MITSUBISHI MOTORS Authorized Service Point. Seat and seat belts
2-26
2
Presented by http://mmc-manuals.ru/ \251

Installing a child restraint system to
the lower anchorage (ISOFIX child re-
straint mountings)
E00408900042
Your
vehicle’s second seat is fitted with lower an-
chorages for attaching a child restraint system with
ISOFIX mountings.
6-person seat
7-person seat Child restraint system with ISOFIX
mountings
E00409000532
The child restraint system is designed only for
seats

that incorporate lower anchorages. Retain the
child restraint system using the lower anchorages.
It is not necessary to retain the child restraint sys-
tem using the vehicle’s seat belts. Only a
MITSUBISHI MOTORS genuine child restraint
system can be used.
Genuine parts No.: MZ313045
ECE No.: E1-04301133
A: Child restraint system connectors
WARNING
l If
a child restraint system other than a
MITSUBISHI MOTORS genuine one is
used, it may not be properly retained and
the child could be seriously injured as a
result. Use only a MITSUBISHI
MOTORS genuine child restraint system. To install WARNING
l If
there is any foreign material in or
around the connectors, remove it before
installing the child restraint system. Also,
make sure the seat belt is away from, not
looped through or otherwise interfering
with, the child restraint system. If foreign
matter is not removed and/or the seat
belt interferes with the child restraint sys-
tem, the child restraint system will not be
secured properly and could move for-
ward in the event of sudden braking or a
collision, seriously injuring the child and
possibly other vehicle occupants.
l Use the top tether strap when fitting a
child restraint system with ISOFIX
mountings.
Otherwise, the child could be seriously in-
jured in the event of hard braking or a col-
lision.
l When the vehicle is moving do not adjust
the seat where the child restraint system
is installed.
1. Slide
the second seats to the fully backward position. (Refer to “To adjust forward or back-
ward” on page 2-07.) Seat and seat belts
2-27 2
Presented by http://mmc-manuals.ru/ \251

2. Open the gap a little between the seat cush-
ion (A) and the seatback (B) with your hand
to locate the lower anchorages (C). 3. Push
the child restraint system’s connectors
into the lower anchorages (C) in accordance
with the instructions provided by the child re-
straint system’s manufacturer.
4. Remove the head restraint from the location in which you wish to install a child restraint. 5. Latch
the tether strap hook (D) of the child
seat to the tether anchorage (E) and tighten
the top tether strap hook so it is securely fas-
tened. 6. Push
and pull the child restraint system in all
directions to be sure it is firmly secured.
To remove
Remove the child restraint in accordance with the
instructions provided by the child restraint sys-
tem’s manufacturer. Installing a child restraint system to a
3-point type seat belt (with emergency
locking mechanism)
E00408700545
Third seat Second seat Front passenger seat Installation:
1. Fasten
the seat belt to secure the child re-
straint system. Make sure you hear a “click”
when you insert the latch plate in the buckle.
2. Remove all slack by using the locking clip.
3. Push and pull the child restraint in all direc- tions to be sure it is secure. WARNING
l For
some types of child restraint, the lock-
ing clip (A) should be used to help avoid
personal injury during a collision or sud-
den manoeuvre.
It must be fitted and used in accordance
with the child restraint manufacturer’s in-
structions.
The locking clip must be removed when
the child restraint is removed. Seat and seat belts
2-28
2
Presented by http://mmc-manuals.ru/ \251

Seat belt inspection
E00406300550
l Check
the belts for cuts, worn or frayed web-
bing and for cracked or deformed metallic
parts. Replace the belt assembly if it is defec-
tive.
l A dirty belt should be cleaned with neutral de-
tergent in warm water. After rinsing in water,
let it dry in the shade. Do not attempt to
bleach or re-dye the belts because this will af-
fect their characteristics. WARNING
l We
recommend you have all seat belt as-
semblies including retractors and attach-
ing hardware inspected after any colli-
sion. We recommend that seat belt assem-
blies in use during a collision be replaced
unless the collision was minor and the
belts show no damage and continue to op-
erate properly.
l Do not attempt to repair or replace any
part of the seat belt assemblies; we recom-
mend you have this work done by a
MITSUBISHI MOTORS Authorized
Service Point. Incorrect repair or replace-
ment could reduce the effectiveness of the
belts and could result in serious injury in
the event of a collision.
l Once the pretensioner has been activated,
it cannot be re-used.
It must be replaced together with the re-
tractor. Supplemental restraint system
(SRS) - airbag E00407201742
The

information written in this Supplemental Re-
straint System (SRS) section contains important
points concerning the driver, front passenger, driv-
er’s knee, side and curtain airbags.
The SRS driver and front passenger airbags are de-
signed to supplement the primary protection of the
driver and front passenger side seat belt systems by
providing those occupants with protection against
head and chest injuries in certain moderate-to-se-
vere frontal collisions.

The SRS driver and front passenger airbags em-
ploy a dual stage airbag system. The SRS driver
and front passenger airbag is controlled by the im-
pact sensors (at the front of the vehicle and near the
center of the vehicle at floor level) and the driver’s
seat position sensor and the SRS front passenger air-
bag is controlled by the impact sensors.

The SRS side airbags are designed to supplement
properly worn seat belts and provide the driver and
front passenger with protection against chest and ab-
domen injuries in certain moderate-to-severe side
impact collisions.

The SRS curtain airbags are designed to supple-
ment properly worn seat belts and provide the driv-
er and passenger with protection against head inju-
ries in certain moderate-to-severe side impact colli-
sions.
Seat and seat belts
2-29 2
Presented by http://mmc-manuals.ru/ \251