2007 HUMMER H2 Owners Manual

Driving in Water
Heavy rain can mean ash ooding, and ood
waters demand extreme caution.
Find out how deep the water is before you drive
through it. If it is deep enough to cover your wheel
hubs, axles, or exhaust pipe, do not try it — you
probably will not get through. Also, water that deep
can damage your axle and other vehicle parts.
Your vehicle is capable of depths up to 20 inches.
Know how to judge whether the water is deeper
than this before proceeding into it.
If the water is not too deep, drive slowly through it.
At faster speeds, water splashes on your ignition
system and your vehicle can stall. Stalling can also
occur if you get your tailpipe under water. And,
as long as your tailpipe is under water, you
will never be able to start your engine. When you
go through water, remember that when your
brakes get wet, it may take you longer to stop.{CAUTION:
Driving through rushing water can be
dangerous. Deep water can sweep your
vehicle downstream and you and your
passengers could drown. If it is only
shallow water, it can still wash away the
ground from under your tires, and you
could lose traction and roll the vehicle
over. Do not drive through rushing water.
SeeDriving in Rain and on Wet Roads on
page 344for more information on driving
through water.
337

After Off-Road Driving
Remove any brush or debris that has collected
on the underbody, chassis, or under the hood.
These accumulations can be a re hazard.
After operation in mud or sand, have the brake
linings cleaned and checked. These substances
can cause glazing and uneven braking. Check the
engine and oil coolers for mud accumulation.
Thoroughly and carefully clean these devices to
allow proper cooling. Check the body structure,
steering, suspension, wheels, tires, and exhaust
system for damage. Also, check the fuel lines and
cooling system for any leakage.
Your vehicle will require more frequent service
due to off-road use. See the Maintenance
Schedule for additional information.
Assist Steps
Your vehicle may be equipped with removable
side steps.
Remove the steps prior to off-roading to give your
vehicle more ground clearance and to prevent
damage to the vehicle from the side steps
dragging and/or catching on obstacles.
Notice:Do not drive off-road with the side
steps attached to your vehicle. You can damage
the side steps and/or your vehicle’s frame if
they get caught or drag against an obstacle.
This damage would not be covered by your
vehicle’s warranty. Always remove the side
steps prior to any off-road driving.
338

U-Type Side Steps
The following instructions show how to install the
optional U-type steps. If you want to remove
them, just reverse the instructions:
1. Start with the side step brackets pointing up
and away from you, or just make sure the
HUMMER logo faces up.
2. For the front step, use the rst and third
brackets on the vehicle from the front tire.
For the rear step, use the rst and third
brackets on the vehicle from the rear tire.
You will notice that the side steps have pins
on both sides of the step brackets. This is
because the steps are interchangeable
between front/back and the driver/passenger
sides of the vehicle. Use the pins as follows:
Driver Side:Look at the side step with the
HUMMER logo facing you. You will use the
pins which are on the right side of each
side step bracket. This works for the front or
rear of the vehicle.
Passenger Side:Look at the side step with
the HUMMER logo facing you. You will use
the pins which are on the left side of
each side step bracket. This works for the
front or rear of the vehicle.3. Guide the pins on the side step brackets
into the holes in the vehicle’s rocker panel
protector brackets. If you have difficulty doing
this, it may help to have someone hold up
the step while you guide the pins into
the holes.
You will be guiding three pins into the holes
with the fourth hole in the vehicle’s rocker panel
protector brackets empty until the next step.
339

4. Thread the knob through the remaining
hole — rst into the rocker panel protector
and then into the threaded hole in the
side step bracket.
Notice:Threading the knob into the side step
and then into the rocker panel will not
secure the step. The step could fall off the
vehicle and be damaged. Always thread
the knob through the rocker panel rst. After
the knob is installed, try moving the step
left and right to be sure the step is secure.5. Hand-tighten the knob by turning it clockwise
until it is seated against the rocker panel
protector bracket and then tighten it to 10 lb ft
(13.5
Y) with the tool as shown.
340

6. Once the knob is
torqued, install the
cotter pin through
the hole in the
end of the knob’s
threaded shaft.
This will help prevent the knob from coming
completely loose and falling out.Tubular Side Steps
The driver’s side of the vehicle is shown with the
body removed for clarity. To remove a step:
1. Remove the nuts and bolts attaching the step
to the vehicle.
2. Remove the step from the vehicle.
341

To install a step:
1. Before installing the bolts:
Remove all traces of the original adhesive
patch.
Clean the threads of the bolts with
denatured alcohol or equivalent and allow
threads to dry.
Apply Threadlocker (GM Part No. 12345382,
in Canada 10953489) or equivalent.
2. Install the side step to the vehicle. You may
need someone to assist you in the installation.
3. Install the nuts and bolts for the two
inner brackets rst, but do not tighten them.
4. Using a level, make sure the step is level in
relationship to the vehicle. Then, tighten the
inner bracket nuts and bolts.
5. Install the other nuts and bolts. Tighten all
nuts and bolts to 39 lb ft (50
Y).
Driving at Night
Night driving is more dangerous than day driving.
One reason is that some drivers are likely to
be impaired — by alcohol or drugs, with night
vision problems, or by fatigue.
Here are some tips on night driving.
Drive defensively.
Do not drink and drive.
Adjust the inside rearview mirror to reduce the
glare from headlamps behind you.
Since you cannot see as well, you may need
to slow down and keep more space between
you and other vehicles.
Slow down, especially on higher speed roads.
Your vehicle’s headlamps can light up only so
much road ahead.
In remote areas, watch for animals.
If you are tired, pull off the road in a safe
place and rest.
342

No one can see as well at night as in the daytime.
But as we get older these differences increase.
A 50-year-old driver may require at least twice as
much light to see the same thing at night as a
20-year-old.
What you do in the daytime can also affect your
night vision. For example, if you spend the
day in bright sunshine you are wise to wear
sunglasses. Your eyes will have less trouble
adjusting to night. But if you are driving, do not
wear sunglasses at night. They may cut down on
glare from headlamps, but they also make a
lot of things invisible.
You can be temporarily blinded by approaching
headlamps. It can take a second or two, or
even several seconds, for your eyes to re-adjust
to the dark. When you are faced with severe glare,
as from a driver who does not lower the high
beams, or a vehicle with misaimed headlamps,
slow down a little. Avoid staring directly into
the approaching headlamps.Keep the windshield and all the glass on your
vehicle clean — inside and out. Glare at night is
made much worse by dirt on the glass. Even the
inside of the glass can build up a lm caused
by dust. Dirty glass makes lights dazzle and ash
more than clean glass would, making the pupils
of your eyes contract repeatedly.
Remember that the headlamps light up far less
of a roadway when you are in a turn or curve.
Keep your eyes moving; that way, it is easier
to pick out dimly lighted objects. Just as the
headlamps should be checked regularly for proper
aim, so should your eyes be examined regularly.
Some drivers suffer from night blindness — the
inability to see in dim light — and are not even
aware of it.
343

Driving in Rain and on Wet Roads
Rain and wet roads can mean driving trouble. On a
wet road, you cannot stop, accelerate, or turn as
well because your tire-to-road traction is not as
good as on dry roads. And, if your tires do not have
much tread left, you will get even less traction.It is always wise to go slower and be cautious if rain
starts to fall while you are driving. The surface may
get wet suddenly when your reexes are tuned for
driving on dry pavement.
The heavier the rain, the harder it is to see. Even if
your windshield wiper blades are in good shape, a
heavy rain can make it harder to see road signs and
traffic signals, pavement markings, the edge of the
road, and even people walking.
It is wise to keep your wiping equipment in good
shape and keep your windshield washer uid
reservoir lled with washer uid. Replace
your windshield wiper inserts when they show
signs of streaking or missing areas on the
windshield, or when strips of rubber start to
separate from the inserts.
344