2006 TOYOTA RAV4 2gr

2GR-FE EMISSION CONTROL – EMISSION CONTROL SYSTEMEC–5
EC
A136448E01

EC–62GR-FE EMISSION CONTROL – EMISSION CONTROL SYSTEM
EC
A136304E01

2GR-FE EMISSION CONTROL – EMISSION CONTROL SYSTEMEC–7
EC
A136311E01

EX–42GR-FE EXHAUST – EXHAUST PIPE
EX
INSTALLATION
1. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(a) Install a new gasket.
(b) Install the front exhaust pipe with the 2 nuts.
Torque: 62 N*m (632 kgf*cm, 46 ft.*lbf)
2. INSTALL NO. 1 FRONT EXHAUST PIPE SUPPORT
BRACKET
(a) Install the No. 1 front exhaust pipe support bracket
with the 2 bolts.
Torque: 21 N*m (214 kgf*cm, 16 ft.*lbf)
3. INSTALL CENTER EXHAUST PIPE ASSEMBLY
(a) Install 2 new gaskets.
(b) Connect the 3 exhaust pipe supports, and install the
center exhaust pipe.
(c) Install the 2 bolts and 2 nuts.
Torque: 43 N*m (440 kgf*cm, 32 ft.*lbf)
A132401

2GR-FE EXHAUST – EXHAUST PIPEEX–5
EX
4. INSTALL TAILPIPE ASSEMBLY
(a) Using a vernier caliper, measure the free length of
the compression spring.
Minimum length:
38.5 mm (1.516 in.)
If the length is less than the minimum, replace the
compression spring.
(b) Install a new gasket by hand so that its surface is
flush with the center exhaust pipe.
NOTICE:
• Tap in the gasket in the correct direction.
• Do not reuse the removed gasket.
• Do not push in the gasket while installing the
tailpipe.
(c) Connect the 2 exhaust pipe supports, and install the
tailpipe.
(d) Install the 2 compression springs and 2 bolts.
Torque: 43 N*m (440 kgf*cm, 32 ft.*lbf)
A132426
A077857E03
A076194E10

EX–62GR-FE EXHAUST – EXHAUST PIPE
EX
5. INSTALL HEATED OXYGEN SENSOR (for Sensor 2)
(See page EC-27)
6. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
7. CHECK FOR EXHAUST GAS LEAKS
If gas is leaking, tighten the problem areas to stop the
leak. Replace damaged parts as necessary.
A132395

CO–42GR-FE COOLING – COOLING FAN SYSTEM
CO
SYSTEM DIAGRAM
A132454E01

2GR-FE COOLING – COOLING FAN SYSTEMCO–5
CO
A132455E01