TRANSFER ASSEMBLY
TF-111
C
E
F
G
H
I
J
K
L
MA
B
TF
TRANSFER ASSEMBLYPFP:33100
Removal and InstallationEDS0032O
REMOVAL
1. Switch 4WD shift switch to 2WD and set transfer assembly to 2WD.
2. Remove the drain plug and gasket. Drain the fluid. Refer toTF-12, "
Replacement".
3. Remove the transmission undercover.
4. Remove the main muffler. Refer toEX-3, "
Removal and Installation".
5. Remove the front and rear propeller shafts. Refer toPR-4, "
Removal and Installation"(front) andPR-8,
"Removal and Installation"(rear).
CAUTION:
Do not damage spline, sleeve yoke and rear oil seal when removing rear propeller shaft.
NOTE:
Insert a plug into the rear oil seal after removing the rear propeller shaft.
6. Remove transmission bolts. Refer toAT-247, "
Removal and Installation"(A/T models) orMT-16,
"Removal and Installation from Vehicle"(M/T models).
7. Position two suitable jacks under the transmission and transfer assembly.
8. Remove the transmission crossmember. Refer toAT- 2 4 7 , "
Removal and Installation"(A/T models) orMT-
16, "Removal and Installation from Vehicle"(M/T models).
WARNING:
Support transmission and transfer assembly using two suitable jacks while removing transmis-
sion crossmember.
9. Disconnect the electrical connectors from the following:
lAT P s w i t c h
l4LO switch
lWait detection switch
lTransfer control device
10. Disconnect each air breather hose from the following. Refer toTF-107, "
A/T MODELS"(A/T models) or
TF-109, "
M/T MODELS"(M/T models).
lTransfer control device
lBreather tube (transfer)
11. Remove the transfer to transmission and transmission to trans-
fer bolts.
WARNING:
Support transfer assembly with suitable jack while remov-
ing it.
12. Remove the transfer assembly.
CAUTION:
Do not damage transmission rear oil seal.
SDIA3181E
