Page 1082 of 3870
2004 DRIVELINE/AXL
E
Propeller Shaft - Endeavor
GENERAL DESCRIPTION For AWD vehicles, 3 way split 4-joint type propeller shaft with center bearing is
adopted, and it has the following features.
The DOJ, which is of less sliding resistance, is used for the No.3 joint. This
reduces the idling vibration. A insulator is located at the center bearing to vehicle body joint, reducing
vibration.
CONSTRUCTION DIAGRAM Fig. 1: Identifying Construction Diagram Of Propeller Shaft
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
PROPELLER SHAFT DIAGNOSIS INTRODUCTION TO PROPELLER SHAFT DIAGNOSIS If an abnormal noise is heard from the propeller shaft while driving, some parts of
the
propeller shaft ma
y be worn or dama
ged, or some mountin
g bolts ma
y be loose.
NOTE: DOJ: Double Offset Joint
2004 Mitsubishi Endeavor LS
2004 DRIVELINE/AXLE Propeller Shaft - Endeavor
2004 Mitsubishi Endeavor LS
2004 DRIVELINE/AXLE Propeller Shaft - Endeavor
Page 1188 of 3870
2004 ENGINE
Engine Cooling - Endeavor
GENERAL DESCRIPTION The cooling system is designed to keep every part of the engine at appropriate
temperature in whatever condition the engine may be operated. The cooling method
is of the water-cooled, pressure forced circulation type in which the water pump
pressurizes coolant and circulates it throughout the engine. If the coolant
temperature exceeds the prescribed temperature, the thermostat opens to circulate
the coolant through the radiator as well so that the heat absorbed by the coolant may
be radiated into the air. The water pump is of the centrifugal type and is driven by
the drive belt from the crankshaft. The radiator is the corrugated fin, down flow
type. CONSTRUCTION DIAGRAM Fig. 1: Identifying Engine Cooling Construction Diagram
2004 Mitsubishi Endeavor Limited 2004 ENGINE Engine Cooling - Endeavor
2004 Mitsubishi Endeavor Limited 2004 ENGINE Engine Cooling - Endeavor
Page 1196 of 3870
Fig. 5: Radiator Fan and Condenser Fan Drive Circuit Diagram & Connector Identification
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2004 Mitsubishi Endeavor Limited 2004 ENGINE Engine Cooling - Endeavor
Page 1270 of 3870
Fig. 1: Charging System Circuit Diagram (Up To December 2003)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Fig. 2: Charging System Circuit Diagram (From January 2004)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
ADJUSTMENTS BELT TENSION
2004 Mitsubishi Endeavor Limited
2004 STARTING & CHARGING SYSTEMS Generators & Regulators - Endeavor
Page 1300 of 3870
TORQUE SPECIFICATION
S
See illustration in REMOVAL & INSTALLATION
or OVERHAUL
.
WIRING DIAGRAMS For wiring diagrams, see STARTING/CHARGING
.
2004 Mitsubishi Endeavor Limited
2004 STARTING & CHARGING SYSTEMS Generators & Regulators - Endeavor
Page 1629 of 3870
Fig. 5: Radio And CD Player Or Radio, CD Player And CD Changer Power Supply Circuit Diagram
Courtes
y of MITSUBISHI MOTOR SALES OF AMERICA
.
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Radio With Tape Player & Cd Player - Endeavor
Page 1643 of 3870
Fig. 16: Remote Controlled Radio Switch Power Supply Circuit Diagram & Connector Identification
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
CIRCUIT OPERATION
If the remote controlled radio switch is operated, the output voltage will
change. The radio, CD player and CD changer operates according to the
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Radio With Tape Player & Cd Player - Endeavor
Page 1676 of 3870
Fig. 47: Audio Amplifier Power Supply Circuit Diagram & Connector Identification
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
CIRCUIT OPERATION Power is supplied from the battery directly to the audio amplifier. TECHNICAL DESCRIPTION (COMMENT) The cause is
probabl
y a fault
y audio am
plifier
power su
pply circuit s
ystem.
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Radio With Tape Player & Cd Player - Endeavor
