Page 1022 of 3870
Rear door: 11 +
/-4 mm (0.43 +/-0.16 inch)
Fig. 16: Checking Door Outside Handle Play
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor
Page 1023 of 3870
2. If the door outside handle play is not within the standard value range, check the
door outside handle or the door latch assembly. Replace if necessary. DOOR INSIDE HANDLE PLAY CHECK 1. Check that the door inside handle play is within the standard value range.
Standard value (B):
Front door: 42 +/- 16 mm (1.65 +/-0.63 inch)
Rear door: 44 +/- 14 mm (1.73 +/-0.55 inch)
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor
Page 1035 of 3870
SWITCH POSITION
TESTER
CONNECTION
SPECIFIED
CONDITION
FRONT (LH)
UP
8-13, 9-12,
Less than 2 ohms
OFF
8-12, 9-12
Less than 2 ohms
DOWN
9-13, 8-12
Less than 2 ohms
FRONT (RH)
UP
3-13, 11-12*
Less than 2 ohms
OFF
3-11, 3-12*, 11-12*
Less than 2 ohms
DOWN
11-13, 3-12*
Less than 2 ohms
REAR (LH)
UP
1-13, 2-12*
Less than 2 ohms
OFF
1-2, 1-12*, 2-12*
Less than 2 ohms
DOWN
2-13, 1-12*
Less than 2 ohms
REAR (RH)
UP
13-14, 6-12*
Less than 2 ohms
OFF
6-14, 6-12*, 12*--14
Less than 2 ohms
DOWN
6-13, 12*--14
Less than 2 ohms
NOTE: *: Set the window lock switch to UNLOCK position.
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor
Page 1037 of 3870
Fig. 27: Identifying Sub Front Switch Terminals
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
SUB SWITCH < REAR> SUB SWITCH SPECIFICATION SWITCH POSITION
TESTER CONNECTION
SPECIFIED
CONDITION
UP
4-5, 6-7
Less than 2 ohms
OFF
4-5, 7-8
Less than 2 ohms
DOWN
4-6, 7-8
Less than 2 ohms
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor
Page 1038 of 3870
Fig. 28: Identifying Sub Rear Switch Terminals
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
DOOR WINDOW REGULATOR CHECK 1. Connect a battery directly to the motor terminals and check that the motor runs
smoothly.
2. Check that the motor runs in the opposite direction when the battery is
connected with the polarity reversed.
3. If defect is found, re
place the window re
gulator as an assembl
y.
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor
Page 1040 of 3870
Fig. 29: Identifying Door Window Motor Terminals (Front Door)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
< REAR DOOR > DOOR WINDOW REGULATOR CHECK SPECIFICATION BATTERY CONNECTION
SLIDER POSITION
Connect terminal No. 1 and the
UP
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor
Page 1041 of 3870
Fig. 30: Identifying Door Window Motor Terminals (Rear Door)
negative battery terminal. Connect terminal No. 2 and the
positive battery terminal. Connect terminal No. 2 and the
negative battery terminal. Connect terminal No. 1 and the
positive battery terminal.
DOWN
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor
Page 1043 of 3870
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA
.
Fig. 32: Removing/Installing Door Handle And Latch (2 Of 2)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Required Special Tool:
MB991223: Harness Set
INSTALLATION SERVICE POINTS >>A<< DOOR CHECK INSTALLATION Install the door check so that the identification mark faces upwards.
DOOR CHECK INSTALLATION SPECIFICATION ITEM
IDENTIFICATION MARK
Front Door
Left door
PUFL
Right door
PUFR
Rear Door
Left door
PURL
Right door
PURR
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor
