2004 MITSUBISHI ENDEAVOR sunroof

MOTORS MOTORS LOCATION SENDING UNITS & SENSORS SENDING UNITS & SENSORS LOCATION
4 .
Power Window Main Switch CPU
Integral to power window main switch.
See Fig. 15
.
SRS ECU
Under front of center console.Fig. 14
.
Sunroof ECU
At front of sunroof opening.Fig. 13
.
Component
Location
Door Lock Actuator (Left Front) (E-
20)
Rear of left front door.Fig. 77
.
Door Lock Actuator (Left Rear) (E-13)
Rear of left rear door.Fig. 77
.
Door Lock Actuator (Right Front) (E-
03)
Rear of right front door.Fig. 77
.
Door Lock Actuator (Right Rear) (E-
07)
Rear of right rear door.Fig. 77
.
Fuel Pump Module
In top of fuel tank.Fig. 64
.
Liftgate Actuator (F-11)
Lower center of liftgate. See Fig. 88
.
Power Steering Oil Pump
Lower right side of engine
compartment. See Fig. 36
.
Rear Blower Motor (C-20)
Rear of center console.Fig. 76
.
Rear Washer Motor (A-26)
In washer tank assembly.Fig. 79
.
Sunroof Motor Assembly
Right front of roof. See Fig. 62
.
Windshield Washer Motor (A-27)
In washer tank assembly.Fig. 79
.
Windshield Wiper Motor (A-03)
On left side of firewall.Fig. 79
.
Component
Location
ABS G Sensor Or G & Yaw Rate
Sensor
Under center console. See Fig. 67
.
Acceleration Pedal Position
Above accelerator pedal.Fig. 59
.

2004 Mitsubishi Endeavor LS
2004 MITSUBISHI Endeavor

<< A >> GROUND CABLE AND SUNROOF ASSEMBLY CONNECTO
RREMOVA
L
Disconnect the ground cable and the connector as shown.
1. GROUND
2. SUNROOF ASSEMBLY CONNECTOR (10)
Fig. 3: Disconnecting Ground Cable And Connector

Courtes
y of MITSUBISHI MOTOR SALES OF AMERICA
.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Headlining - Endeavor

2004 BODY & ACCESSORIES
Sunroof Assembly - Endeavor
GENERAL DESCRIPTION A motor-driven inner slide-type glass sunroof with a tilt-up mechanism is adopted
in some models as a standard or optional equipment. Even when the sunroof is fully
closed, a sufficient amount of lighting and a feeling of openness can still be
obtained by opening the sunroof sunshade. SUNROOF ASSEMBLY The sunroof system is controlled by the Simplified Wiring System (SWS). Refer to
SYMPTOM CHART
.
SPECIAL TOOL Fig. 1: Special Tool Chart

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
ON-VEHICLE SERVICE WATER TEST Check if there are an
y leaks in the sunroof b
y the followin
g procedure.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor


2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

1. Fully close the roof lid glass.
2. Adjust the water pressure so that water comes out of the hose to a height of
approximately 50 cm (19.7 inches) when the hose is held vertically facing
upwards.
3. Hold the end of the hose approximately 30 cm (11.8 inches) above the roof and
let the water run onto the weatherstrip for 5 minutes or more.
Fig. 2: Performing Water Test

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
4. Check if any water leaks can be found in the room while watering. Even
though there are any water leaks around the roof lid glass, it can be acceptable
as long as water is caught in the drip area.
SUNROOF TIMER FUNCTION CHECK Keep the door closed, turn OFF the ignition switch and check to see if the sunroof
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

can be operated for 30 seconds after that. If not, perform troubleshooting (Refer to
SYMPTOM CHART
).
SUNROOF FIT ADJUSTMENT 1. Fully close the roof lid glass.
2. Fully open the sunshade.
3. Loosen the roof lid glass assembly mounting screws. Align the roof lid glass
by moving it backward, forward, up or down along the guide oblong hole so
that the clearance between the
glass and the vehicle bod
y is even.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

Fig. 3: Locating Roof Lid Mounting Screws

Courtes
y of MITSUBISHI MOTOR SALES OF AMERICA
.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

4. Check to be sure that the roof lid glass is flush with the roof panel at corner
areas.
5. Check to be sure that the sunroof operates smoothly. SUNROOF SAFETY FUNCTION CHECK 1. Close the roof lid glass by applying an approximately 10mm (0.39 inch)
thickness solid object placed at a right angle to the roof lid glass.
2. Check to see if the roof lid glass opens after the motor turns when the roof lid
glass catches the object (Refer to SYMPTOM CHART
).
SUNROOF CHECK Check to see that the sunroof operates by pressing the sunroof switch. Perform
troubleshooting if operations malfunction (Refer to SYMPTOM CHART
).
ROOF LID GLASS OPERATION CURRENT CHECK 1. Remove the fuse of the sunroof, then connect the circuit tester as shown.
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

Fig. 4: Checking Roof Lid Glass Operation Current

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Turn ON the sunroof switch, then measure the operating current when the roof
lid glass has been halfly slidden.
Standard value: 7 A or less [at 20 ° C (68 ° F)]
3. Check the following areas if the operating current of exceeds the standard
value:
Sunroof installation, deformation and appearance of any foreign
substances. Drive cable installation. Tilting of roof lid glass.
SUNROOF INITIALIZATION
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor