Page 384 of 933
EXTERNAL PROTECTIONS
55
55 - 2
DISMOUNTING
Disconnect
the rear fog spotlights, from the rear wiring.
Dismo unt :
- the nuts ( 1) and the attachment screws (3) of the rear bumper (4) on the carriage body,
by means of lateral supports (2), respectively by the bumper ends on the rear wheels passage.
-the attachment nuts (7) of the counterblade (6) on the carriage body.
D etach the rear bumper (5).
REMOUNTING
Perform the dismounting operations in the reverse order. RE
AR BUMPER
vnx.su
Page 454 of 933
80
BATTERY - FRONT HEADLIGHTS
80 - 5
FOG LAMPS
DISMOUNTING – REMOUNTING
Disconnect the fog lamp (A) connectors from the vehicle wiring.
Dismount the two fog lamp attachment nuts (B and C) on the front bumper.
Remove the fog lamp off the bumper.
Position in the bumper the new fog lamp.
Mount the two fog lamp attachment nuts (B and C).
Connect the fog lamp (A) connectors to the vehicle wiring.
Check the operation of the fog lamps.
NOTE:
After mounting t he fog l amps, it is obl igatory to perform their adjustment.
vnx.su
Page 457 of 933

80
BATTERY - FRONT HEADLIGHTS
80 - 8
HEADLAMPS ADJUSTMENT
FOG LAMPS ADJUSTMENT
The fog lamps adjustment is to be performed in the following conditions:
- the vehicle to be placed on a horizontal surface;
- the vehicle has not passengers inside the cockpit or weights in the trunk;
- the tires a re pressurized a t the manufacturer prescribed pressure.
Further on, proceed as follows:
Bring the vehicle at the working place.
Position the adjustment device (headlamp adjustment device – E) in front of an optical center
of a fog lamp.
Switch on the fog lamps.
Rotate the adjustment screw of the fog lamp (D), so that an adjustment of 2 % is obtained and
the separation between the lighted area and the dark one from the adjustment device is located
under the marked line (G).
This adjustment is performed in the same way as for the meeting lights adjustment.
Bring the adjustment device in front of the optical center of the second fog lamp.
Perform the fog lamp adjustment.
Switch off the fog lamps.
G
E
vnx.su
Page 458 of 933
81
REAR AND INTERIOR LIGHTING
81 - 1
BULBS REPLACEMENT
BULB REPLACEMENT OF THE REAR TURNING, PARKING AND BRAKE STOP LIGHT
Disconnect the battery.
Push towards interior the two attachment clips (1 ), then extract the plastic cap (2).
Disconnect the connector (6).
Push upwards the attachment clips (3) of the printed circuit plate (4), swing it and pull out the
plate from the attachment shoulders (5).
For remounting perform the dismounting operations in the reverse order.
FOG LAMP BULB REPLACEMENT
Di smount the attachment scre ws (1) of the
fog lamp glass and remove the glass;
Remove the burnt bulb and replace it.
REPLACEMENT OF THE LICENSE PLATE LAMP BULB
Dismount the lamp attachment screws.
Replace the burnt bulb.
For remounting, perform the dismounting operations in the reverse order.
vnx.su
Page 459 of 933
REAR AND INTERIOR LIGHTING
81
81 - 2
BULBS
Hugh/low beam lights Two phases bulb R2-12V-40/45 W
He adl a mp swith flange holder P45t41
Parking lights Bulb 12V-4W with holder BA 9s
Front turning lamp Bulb 12V-21W (colored) with holder BAU 15s
Fog lamps Halogen bulb H3, 12V-55W with holder Pk22s
Rear Parking, stop lights Bulb 12V-21/5W with holder BAY 15d
lamps Turning and reverse driving Bulb 12V-21W with holder BA15s
Rear fog lamps Bulb 12V-21W with holder BA 15s
Lamps: side signaling, trunk lighting Bulb 12V-5W with holder W2,1x9,5
License plate, ceiling, document compartment Bulb SOFIT 10 x 35 type AS02; 12 V-5W
lamps with holder Sv 8,5
Lamp STOP-S3 on the ceiling Bulb 12V-21W type C21W with holder Sv 8,5
Instrument panel Bulb 12V-1,2W holderW 2 x 4,6d BULBS
vnx.su
Page 461 of 933
REAR AND INTERIOR LIGHTING
81
81 - 4
FOG LAMPS NOT WORKING
F 10 fuse is burnt; replace the fuse.
The relay is supplied.
Ground wire broken. Check the fuse F 10.
F
10 fuse is good.
Check the supply of the R1 relay.
The relay is supplied.
Check the lamps supply. The relay i s not supplied. Is there + 12 V
at pole 4 of the fog lamps contact ?
Disconnected wiresor defect contact. Lights switch
device
defect or F05 fuse burnt.
Lamps are not supplied .Check the fog lamps control relay.
Relay defect.
Replace the relay. Relay good. Lamps supplying
wire
broken or disconnected.
Yes No
DIAGNOSTIC
vnx.su
Page 536 of 933
84
CONTROLS - SIGNALLING
FOG LAMPS SWITCH84-5
FOG PROJECTORS SWITCH FOG LAMPS SWITCH
Pos Destination2 Fog lamp
4 High beam, low beam
5+ parking lights
6 Mass
7 Fog lamp
9 Fog lamp relay control
Pos Destination
1 + Parking lights
2 Fog lamps relay control
3 + Parking lights
4 Mass
vnx.su
Page 563 of 933

89A
ELECTRICAL DIAGRAMS
89A - 11
39HANDBRAKE INDICATOR AND BRAKING SYSTEM FAILURE S S S
40 FUEL LEVEL INDICATOR CIRCUIT S S S
41 OIL PRESSURE INDICATOR CIRCUIT S S S
42 DIAG NOSTIC SOCKET S S S
43 INSTRUMENT PANEL AE1 S
44 INSTRUMENT PANEL AE2, AE3 S S
45 WA TER TEMPERATURE INDICATOR CIRCUIT S S S
46 BRAKE PADS WEAR INDICATOR CIRCUIT S S S
47 VEHICLE SPEED S S S
48 SOUND W ARNING S S S
49 REAR WINDOW DEFROSTING S S S
50 WINDSCREEN WIPER-WASHING S S S
51 REAR FOG LAMP S S S
52 FOG HEADLIGHTS AE2, AE3 S S
53 MEETING LIGHTS S S S
54 REVERSE DRIVING LIGHTS S S S
55 PA R K I N G LIGHTS S S S
56 ROAD LIGHTS S S S
57 STOP LIGHTS AE1, AE2 S S
58 STOP LIGHTS AE2(aileron) O
59 STOP LIGH TS AE2(CA), AE3 O S
60 TURNING AND HAZARD LIGHTS AE1 S
61 TURNING AND HAZARD LIGHTS AE2, AE3 S S
Note : these electr ic diagrams are valid for vehicle manufactured until 01.06.2001; AE1
( Confort), AE2 (Rapsodie), AE3 (Clima) represent equipping levels of the vehicle.
FUNCTIONAL DIAGRAMS LIST
vnx.su