82A
HORN - ENGINE IMMOBILISER
82A - 10
If further to t he diagnostic, it is necessary the replacement of t he E.C.U. injection, for its
dismountin g, proceed as follows:
- disconnect the battery (the contact being off);
- dismount the screw from the battery attachment clip;
-r emove the battery;
- disconnect the injection computer from the engine wiring;
- dismount the two attachment nuts of the injection computer.
For mounting, perform in the reverse order the dismounting operations.
The i njection c omputer is delivered not coded. It i s necessary the memorising of a n anti
starting code in the computer, after this has been mounted was mounted.
Proceed as follows:
1. Set the contact on, without starting the engine, for a few seconds.
2. Take off the contact; after 10 seconds, the anti starting function is activated, and the anti
starting indicator will blink rarely ( one blink per second).
3. Set the contact on. The anti starting indicator must turn off and the engine can be started.
In order to disconnect the injection computer (E.C.U. injection) act upon the blocking lever
(picture 9, position A) of the connector in the direction of the B arrow, then the connector will be
lifted in the direction of the C arrow. In case the vehicle is bl ocked on the road further to seri ous damages of t he a nti starting
system, the “ Procedure repairing code introduction” may be used, which allows the moving of
the vehicle to the nearest DACIA service center for complete repairing. In order to perform this
procedure it is necessary the CLIP tester and the specific repairing code of that vehicle. ELECTRIC CONTROL UNIT INJECTION REPLACEMENT
A
B
pict. 9
C
vnx.su
