H24378
H24395
H24324
H24325
H24326
± BODYFRONT SEAT (Power Adjuster Type)
BO±115
3668 Author: Date:
2005 SEQUOIA (RM1146U)
(c) Remove the hog rings from the seat cushion cover.
(d) Unlatch the seat cushion cover hooks, then remove the
seat cushion cover and seat cushion pad.
12. REMOVE SEAT CUSHION COVER
Remove the hog rings and seat cushion cover from the seat
cushion pad.
13. w/ Seat heater:
REMOVE SEAT CUSHION HEATER ASSEMBLY
Cut off the tack pins which fasten the seat heater, and then re-
move the seat cushion heater assembly from the seat cushion
cover.
14. REMOVE LUMBAR SUPPORT ADJUSTER
(a) Disconnect the connector.
(b) Disengage the seatback spring edge from the seat frame
assembly.
NOTICE:
Be careful when releasing the seatback spring edge, be-
cause there is a possibility that the spring may break due
to tension by the lumbar support.
(c) Remove the 2 screws and lumbar support adjuster.
(d) Remove the bushing from the lumbar support adjuster.
15. REMOVE RH AND LH RECLINING ADJUSTER INSIDE
COVERS
(a) Remove the screw and RH reclining adjuster inside cover.
(b) Disconnect the wire harness clamp.
(c) Perform the same procedure on the other side.
BO4SA±01
H24327
H24326
H24325
± BODYFRONT SEAT (Power Adjuster Type)
BO±117
3670 Author: Date:
2005 SEQUOIA (RM1146U)
REASSEMBLY
CAUTION:
Wear safety gloves, because the sharp edges and surfaces
of the seat frame may cause injury to the hands.
HINT:
The procedures listed below are for the LH side.
A bolt without a torque specification is shown in the stan-
dard bolt chart (see page SS±2).
1. Driver 's seat:
INSTALL SEAT POSITION SENSOR
(SEE PAGE RS±108)
2. INSTALL VERTICAL ADJUSTER BRACKET INNER
AND OUTER COVERS
(a) Install the vertical adjuster bracket inner cover with the
screw.
(b) Perform the same procedure on the other side.
3. INSTALL RH AND LH SEATBACK SHIELDS
(a) Install the RH seatback shield with the 2 screws.
(b) Perform the same procedure on the other side.
4. INSTALL RH AND LH RECLINING ADJUSTER INSIDE
COVERS
(a) Connect the wire harness clamp.
(b) Install the RH reclining adjuster inside cover with the
screw.
(c) Perform the same procedure on the other side.
5. INSTALL LUMBAR SUPPORT ADJUSTER
(a) Install a new bushing to the lumbar support adjuster.
(b) Install the lumbar support adjuster with the 2 screws.
05_SEQUOIA_U (L/O 0408)
48
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
CAUTION
Avoid reclining the seatback any
more than needed. The seat belts pro-
vide maximum protection in a frontal
or rear collision when the driver and
the front passenger are sitting up
straight and well back in the seats. If
you are reclined, the lap belt may
slide past your hips and apply re-
straint forces directly to the abdomen
or your neck may contact the shoul-
der belt. In the event of a frontal
collision, the more the seat is re-
clined, the greater the risk of death
or personal injury.
3. SEAT LUMBAR SUPPORT
ADJUSTING SWITCH
Push the control switch in the desired
direction.
The amount of lumber support will change
while the switch is pushed.
Vehicles with the driving position memory
systemÐThe position of the driver's seat
and outside rear view mirrors can be
memorized. For details, see ªDriving posi-
tion memory systemº on page 71 in this
Section.
CAUTION
Adjustment should not be made
while the vehicle is moving.
When adjusting the seat, be careful
not to hit the seat against a pas-
senger or luggage.
Third seats only: Adjust both seat
cushions to the same position and
align both seatbacks at the same
angle when a person sits in the
third seat center position. Other-
wise, the person cannot wear the
seat belt properly and this may
cause serious injuries in a collision.
When folding up the third seats, do
not fold down or up the second
seats.
After adjusting the seat position, re-
lease the lever and try sliding the
seat forward and backward to make
sure it is lock in position.
After adjusting the seatback, push
your body back against the seat to
make sure the seat is locked in
position.
Do not allow sitting on top of a
folded±down seatback, or in the
luggage compartment while driving.
Persons not properly seated and/or
properly restrained by seat belts
can be severely injured in the event
of emergency braking or a collision.
Do not operate any equipment in
the luggage compartment while
driving. People not properly seated
and/or properly restrained by seat
belts can be severely injured in the
event of emergency braking or a
collision.
Do not load luggage with only the
seatback folded down. Do not fail
to swing the whole seat up in such
a case. Luggage sliding forward
during braking may cause an acci-
dent or severe injury.
Rear seatsÐ
ÐRear seat precautions
