2000 YAMAHA TDR 125 Owners Manual

3-2
0
0
0100
01000140
180 120 100 80
1 2 3456
7
8
9
10
11
12
~1 000r/minkm/h
CH
12
43
EAU00056Indicator lights
EAU00057Turn indicator light “5 5
”
This indicator flashes when the turn
switch is moved to the left or right.
EAU00061Neutral indicator light “N”
This indicator comes on when the
transmission is in neutral.
EAU00063High beam indicator light “& &
”
This indicator comes on when the
headlight high beam is used.
EAU01313Oil level indicator light “7 7”
This indicator comes on when the oil
level is low. This light circuit can be
checked by the procedure on page
3-3.
EC000000
cC
Do not run the motorcycle until
you know it has sufficient engine
oil.
NOTE:
Even if the oil is filled to the specified
level, the indicator light may flicker
when riding on a slope or during sud-
den acceleration or deceleration, but
this is normal.
1. Turn indicator light “5”
2. High beam indicator light “&”
3. Neutral indicator light “N”
4. Oil level indicator light “
7”
INSTRUMENT AND CONTROL FUNCTIONS
1
2
3
4
5
6
7
8
9
5AE-9-E3 (ENG) 4/11/0 11:06 AM Page 15

3-3
EAU00071
Oil level indicator circuit
check
INSTRUMENT AND CONTROL FUNCTIONS
1
2
3
4
5
6
7
8
9
Oil level indicator light
Check engine oil level. Oil level indicator light
Put the transmission in neutral or apply the
Oil level indicator light
Oil level indicator lightOil levelOil level
Engine oil level and
Ask a Yamaha dealerSupply
Turn the main switch to “ON”
and the engine stop switch to “#”.
does not come on.comes on.
clutch lever, then push the start switch.
comes on. does not come on.
is OK.is low.
engine oil.
to inspect electrical
circuit. electrical circuit are OK.
Go ahead with riding.
5AE-9-E3 (ENG) 4/11/0 11:06 AM Page 16

3-4
0
0
0100
01000140
180 120 100 80
60
40
20
km/h
CH
3
2
4
1
EAU01087Speedometer
The speedometer shows riding
speed. This speedometer is equipped
with an odometer and trip odometer.
The trip odometer can be reset to “0”
with the reset knob. Use the trip
odometer to estimate how far you
can ride on a tank of fuel. This infor-
mation will enable you to plan fuel
stops in the future.
1. Speedometer
2. Odometer
3. Trip odometer
4. Reset knob
INSTRUMENT AND CONTROL FUNCTIONS
1
2
3
4
5
6
7
8
9
01 2 3456
7
8
9
10
11
12
~1 000r/min
CH1
2NOTE:
(for German model equipped with
speed limiter only)
This motorcycle is equipped with a
speed limiter which prevents it from
exceeding a top speed of
80 km/h.
1. Tachometer
2. Red zone
EAU00102Tachometer
This model is equipped with a
tachometer so the rider can monitor
the engine speed and keep it within
the ideal power range.
EC000003
cC
Do not operate in the red zone.
Red zone: 10,000 r/min and above
5AE-9-E3 (ENG) 4/11/0 11:06 AM Page 17

3-5
01
140 120 100
3456 CH
1
2
1. Engine temperature gauge
2. Red zone
EAU00114
Engine temperature gauge
This gauge indicates the coolant tem-
perature when the main switch is on.
The engine operating temperature
will vary with changes in weather and
engine load. If the needle points to
the red zone or higher, stop your
motorcycle and let the engine cool.
(See page 6-10 for details.)
EC000002
cC
When the engine is overheated, do
not continue riding.
INSTRUMENT AND CONTROL FUNCTIONS
1
2
3
4
5
6
7
8
9
1
2
3
4
EAU00118Handlebar switches
EAU00134Lights switch
Turning the light switch to “
'”,
turns on the auxiliary light, meter
lights and taillight. Turning the light
switch to “:”, turns the headlight on
also.
EAU00121Dimmer switch
Turn the switch to “&” for the high
beam and to “%” for the low beam.
EAU00127Turn signal switch
To signal a right-hand turn, push the
switch to “6”. To signal a left-hand
turn, push the switch to “4”. Once
the switch is released it will return to
the center position. To cancel the sig-
nal, push the switch in after it has
returned to the center position.
EAU00129Horn switch “* *
”
Press the switch to sound the horn.
1. Lights switch
2. Dimmer switch
3. Turn signal switch
4. Horn switch “*”
5AE-9-E3 (ENG) 4/11/0 11:06 AM Page 18

3-6
INSTRUMENT AND CONTROL FUNCTIONS
1
2
3
4
5
6
7
8
9
1
2&
&%
%
Left RightBulb to be used
Destination
3
'
3
2
'
2
3
2
Halogen
bulb
Halogen
bulbFrance Sweden Portugal Spain
Greece Belgium Germany
Switzerland Finland Austria
England
Ireland 3 : High beam light on , 2: Low beam light on
': Auxiliary light on
12V
60/55W12V
60/55W
12V
35/35W12V
35/35W
EAU00136
Headlight beam variation
NOTE:
Right and left directions are those assumed from the position of a person facing the front of the motorcycle.
5AE-9-E3 (ENG) 4/11/0 11:06 AM Page 19

3-7
INSTRUMENT AND CONTROL FUNCTIONS
1
2
3
4
5
6
7
8
921
EAU00138Engine stop switch
The engine stop switch is a safety
device for use in an emergency such
as when the motorcycle overturns or
if trouble occurs in the throttle sys-
tem. Turn the switch to “#” to start
the engine.
In case of emergency, turn the switch
to “$” to stop the engine.
1. Engine stop switch
2. Start switch “,”
EAU00143Start switch “, ,
”
The starter motor cranks the engine
when pushing the start switch.
EC000005
cC
See starting instructions prior to
starting the engine.
5AE-9-E3 (ENG) 4/11/0 11:06 AM Page 20

3-8
1
EAU00152Clutch lever
The clutch lever is located on the left
handlebar, and the ignition circuit cut-
off system is incorporated in the
clutch lever holder. Pull the clutch
lever to the handlebar to disengage
the clutch, and release the lever to
engage the clutch. The lever should
be pulled rapidly and released slowly
for smooth clutch operation. (Refer to
the engine starting procedures for a
description of the ignition circuit cut-
off system.)
EAU00158Front brake lever
The front brake lever is located on
the right handlebar. Pull it toward the
handlebar to apply the front brake.
1. Front brake lever
INSTRUMENT AND CONTROL FUNCTIONS
1
2
3
4
5
6
7
8
9
1
1. Clutch lever
6
5
4
3
2
1 N1
EAU00157Shift pedal
This motorcycle is equipped with a
constant-mesh 6-speed transmission.
The shift pedal is located on the left
side of the engine and is used in
combination with the clutch when
shifting.
1. Shift pedal
N. Neutral
5AE-9-E3 (ENG) 4/11/0 11:06 AM Page 21

3-9
INSTRUMENT AND CONTROL FUNCTIONS
1
2
3
4
5
6
7
8
91
1. Rear brake pedal
EAU00162Rear brake pedal
The rear brake pedal is on the right
side of the motorcycle. Press down
on the brake pedal to apply the rear
brake.
NOTE:
This tank cap cannot be closed
unless the key is in the lock. The key
cannot be removed if the cap is not
locked properly.
EW000023
w
Be sure the cap is properly
installed and locked in place
before riding the motorcycle.
2
1
EAU02935
Fuel tank cap
To open
Open the lock cover. Insert the key
and turn it 1/4 turn clockwise. The
lock will be released and the cap can
be opened.
To close
Push the tank cap into position with
the key inserted. To remove the key,
turn it counterclockwise to the original
position. Then, close the lock cover.
1. Open
2. Unlock
5AE-9-E3 (ENG) 4/11/0 11:06 AM Page 22