1996 TOYOTA TERCEL lock

AC1CX-02
- AIR CONDITIONINGCONDENSER
AC-49
1201 Author
: Date
:
1996 TERCEL (RM440U)
CONDENSER
ON-VEHICLE INSPECTION
1. INSPECT CONDENSER FINS FOR BLOCKAGE OR DAMAGE
If the fins are clogged, wash them with water and dry with compressed air.
NOTICE:
Be careful not to damage the fins.
If the fins are bent, straighten them with a screwdriver or pliers.
2. INSPECT CONDENSER AND FITTINGS FOR LEAKAGE
Repair as necessary.

AC2X0-02
AC-52
- AIR CONDITIONINGEVAPORATOR
1204 Author
: Date
:
1996 TERCEL (RM440U)
EVAPORATOR
INSPECTION
1. REMOVE EVAPORATOR (See page AC-27)
2. INSPECT FINS FOR BLOCKAGE
If the fins are clogged, clean them with compressed air.
NOTICE:
Never use water to clean the evaporator.
3. INSPECT FITTINGS FOR CRACKS OR SCRATCHES
Repair as necessary.
4. REINSTALL EVAPORATOR (See page AC-30)

AC2WX-02
- AIR CONDITIONINGHEATER RADIATOR
AC-53
1205 Author
: Date
:
1996 TERCEL (RM440U)
HEATER RADIATOR
INSPECTION
1. REMOVE HEATER RADIATOR (See page AC-32)
2. INSPECT FINS FOR BLOCKAGE
If the fins are clogged, clean them with compressed air.
3. REINSTALL HEATER RADIATOR (See page AC-32)

AC1D3-02
I06959
Pressure Switch AC-60
- AIR CONDITIONINGPRESSURE SWITCH
1996 TERCEL (RM440U)
REMOVAL
1. DISCHARGE REFRIGERANT FROM REFRIGERANT
SYSTEM
Charge system with refrigerant and inspect for leakage of refrig-
erant.
HINT:
At the time of installation, evacuate air from refrigeration sys-
tem.
Specified amount: 600 ± 50 g (21.16 ± 1.76 oz.)
2. REMOVE PRESSURE SWITCH FROM LIQUID TUBE
(a) Disconnect the connector.
(b) Remove the pressure switch from the liquid tube.
Torque: 10 N´m (100 kgf´cm, 7 ft´lbf)
HINT:

Lock the switch mount on the tube with an open end
wrench, being careful not to deform the tube, and remove
the switch.

At the time of installation, lubricate a new O-ring with
compressor oil and install them to the switch.

AC2XH-02
AC-72
- AIR CONDITIONINGHEATER CONTROL ASSEMBLY
1996 TERCEL (RM440U)
ADJUSTMENT
1. ADJUST AIR INLET DAMPER CONTROL CABLE
Set the air inlet damper on ºRECIRCº position, install the control
control cable and lock clamp.
2. ADJUST MODE DAMPER CONTROL CABLE
Set the air inlet damper on ºFACEº position, install the control
cable and lock the clamp.
3. ADJUST AIR MIX DAMPER CONTROL CABLE
Set the air mix damper on ºCOOLº position, install the control
cable and lock the clamp.