1996 TOYOTA LAND CRUISER Ect

MA04V−01
P22573
−
MAINTENANCE CHASSIS
MA−7
47
Author: Date:
1996 LAND CRUISER (RM451U)
CHASSIS
INSPECTION
1. INSPECT STEERING LINKAGE
(a) Check the steering linkage for looseness or damage.
Check that the tie rod ends do not have excessive
play.
Check that the boot clamps are not loose.
(b) Inspect the dust cover for damage.
2. INSPECT SRS AIRBAG (Driver airbag: See page RS−9 )
(Front passenger airbag: See page RS−23 )
3. INSPECT STEERING GEAR HOUSING OIL
Check the steering gear housing for oil leakage.
If leakage is found, check for cause and repair.
4. INSPECT OIL LEVEL IN AUTOMATIC TRANSMISSION
(See page DI−131 )
5. INSPECT OIL LEVEL IN TRANSFER AND DIFFEREN- TIAL
(a) Transfer: Remove the filler plug and feel inside the hole with your
finger. Check that the oil comes to within 5 mm (0.20 in.)
of the bottom edge of the hole.
If the level is low, add oil until it begins to run out of the filler hole.
Oil drade: API GL −4 or GL−5
Viscosity: 75W−90
(b) Differential: Remove the filler plug and feel inside the hole with your
finger. Check that the oil comes to within 5 mm (0.20 in.)
of the bottom edge of the hole.
If the level is low, add oil until it begins to run out of the filler hole.
Oil drade: Hypoid gear oil API GL −5
Viscosity:
Above −18°C (0° F) SAE 90
Below −18°C (0° F) SAE 80W−90 or 80W
6. REPLACE AUTOMATIC TRANSMISSION FLUID (See page DI−3)
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010

MA04W−01
−
MAINTENANCE BODY
MA−9
49
Author: Date:
1996 LAND CRUISER (RM451U)
BODY
INSPECTION
1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
(a) Tighten the front seat−to−body mounting bolts. Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
(b) Under Severe Conditions: In addition to the above maintenance items, check for
loose or missing nuts and bolts on the steering system,
drive train, suspension system, fuel tank mounts, engine
mounts, etc.
2. FINAL INSPECTION
(a) Check the operation of the body parts:
Hood:
Auxiliary catch operates properly
Hood locks securely when closed
Front and rear doors:
Door locks operate properly
Doors close properly
Back door:
Door lock operates properly
Seats:
Seat adjusts easily and locks securely in any posi-
tion
Front seat back locks securely in any position
Folding −down rear seat backs look securely
(b) Road test
Check the engine and chassis for abnormal noises.
Check that the vehicle does not wander or pull to
one side.
Check that the brakes work properly and do not
drag.
(c) Be sure to deliver a clean car. Especially check the steering wheel, shift lever knob, all
switch knobs, door handles and seats.
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010

PP−4
−
PREPARATION ENGINE MECHANICAL
53
Author: Date:
1996 LAND CRUISER (RM451U)
(09951−05010)Hanger 150
(09952−05010)Slide Arm
(09953−05010)Center Bolt 100
(09953−05020)Center Bolt 150
(09954−05020)Claw No.2
09950−60010Replacer Set
(09951−00280)Replacer 28Connecting rod bushing
(09951−00350)Replacer 35Crankshaft timing gear
(09951−00480)Replacer 48Spark plug tube gasket
09950−70010Handle Set
(09951−07100)Handle 100
(09951−07150)Handle 150
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010

PP301-01
-
PREPARATION ENGINE MECHANICAL
PP-5
1996 LAND CRUISER (RM451U)
RECOMMENDED TOOLS
09082-00040TOYOTA Electrical Tester.
09200-00010Engine Adjust Kit .
09258-00030Hose Plug Set .Plug for the vacuum hose, fuel hose
etc.
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010

PP302-01
PP-6
-
PREPARATION ENGINE MECHANICAL
1996 LAND CRUISER (RM451U)
EQUIPMENT
Caliper gauge
CO/HC meter
Compression gauge
Connecting rod aligner
Cylinder gauge
Dial indicator
Dye penetrant
Engine tune-up tester
Heater
Magnetic finger
Micrometer
OBD II scan toolEngine speed
Piston ring compressor
Piston ring expander
Plastigage
Precision straight edge
Soft brush
Spring testerValve spring
Steel squareValve spring
Thermometer
Torque wrench
Valve seat cutter
Vernier calipers
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010

PP305−02
PP−8
−
PREPARATION EMISSION CONTROL
57
Author: Date:
1996 LAND CRUISER (RM451U)
EMISSION CONTROL
RECOMMENDED TOOLS
09082−00040TOYOTA Electrical Tester.
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010

PP3KU−01
−
PREPARATION SFI
PP−11
60
Author: Date:
1996 LAND CRUISER (RM451U)
SFI
SST (Special Service Tools)
09268−41047Injection Measuring Tool Set
(09268−41091)NO.7 Union
(90405−09015)No.1 Union
09268−45012EFI Fuel Pressure Gauge
09631−22020Power Steering Hose Nut
14 x 17 mm Wrench SetFuel line flare nut
09816−30010Oil Pressure Switch SocketKnock sensor
09842−30070Wiring ”F” EFI Inspection
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010

PP309−01
PP−12
−
PREPARATION SFI
1996 LAND CRUISER (RM451U)
RECOMMENDED TOOLS
09082−00040TOYOTA Electrical Tester.
09200−00010Engine Adjust Kit .
09258−00030Hose Plug Set .Plug for vacuum hose, fuel hose, etc.
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010