1996 LINCOLN CONTINENTAL Customer Assistance Guide

Page 137 of 320

LINCOLN CONTINENTAL 1996  Customer Assistance Guide Utility compartment armrest utility compartment beverage holderThe features on the full console
134Cupholder with full console
The cupholder provides a space for your cup.
Mini console cupholders
Six

Page 138 of 320

LINCOLN CONTINENTAL 1996  Customer Assistance Guide Trunk
Opening the Trunk Manually
Locate the trunk lock in the rear reflector to the
right of the license plate to insert the key.  Turn the
key to the right to open the trunk.The trunk lock cylinderUs

Page 139 of 320

LINCOLN CONTINENTAL 1996  Customer Assistance Guide open trunk lidThe remote control for the trunk
The trunk lid cannot be opened if your vehicle is
moving faster than three mph (five km/h).
Cargo Storage System
(If equipped)
Your vehicle may be equipp

Page 140 of 320

LINCOLN CONTINENTAL 1996  Customer Assistance Guide To operate:
Grasp and squeeze the release handle to move the
cargo storage system rearward.
Place groceries, packages, etc. in the cargo storage
system.
Grasp and squeeze the release handle to move th

Page 141 of 320

LINCOLN CONTINENTAL 1996  Customer Assistance Guide Positive Retention Drivers Side Floor
Mat
Installing the floor mat
Position the floor mat in foot well.  Place mat eyelet
over pointed end of retention post from the rear and
rotate forward to instal

Page 142 of 320

LINCOLN CONTINENTAL 1996  Customer Assistance Guide Removing the floor mat
Lift floor mat just forward of retention post and
rotate rearward to disengage from retention post.
The Electronic Compass
(If equipped)The electronic compassThe compass is moun

Page 143 of 320

LINCOLN CONTINENTAL 1996  Customer Assistance Guide readings after a few days, perform a compass
adjustment.
Compass-Calibration
I .For optimum calibration, switch off all non-
essential electrical accessories (rear window
defrost, heater/air condition

Page 144 of 320

LINCOLN CONTINENTAL 1996  Customer Assistance Guide 2.Insert an appropriate diameter rod (paper
clip) into the right switch access hole
underneath the compass module and gently
press the right button for 1-2 seconds until
"ZONE" and the current zone se