1996 LINCOLN CONTINENTAL Customer Assistance Guide

Map lamp Dome lamp ON/OFF Switches
The map lamps on the inside roof of the car
To turn on the map lamps, push the switches in
front of each lamp.
On vehicles equipped with the moon roof
Option, the map lamps and switches are located
on the inside rearview mirror.
86Rear Courtesy/Reading Lamps
Your vehicle has two rear passenger
courtesy/reading lamps.
The courtesy lamp lights when any door is
opened or when the instrument panel
dimmer switch is turned to the courtesy
lamp position or if either front door outside
handle is lifted with the door locked.
With the ignition key in the ACC or ON
position, the reading lamp can be turned on
by using the rocker switch on the lamp
assembly.

Rear passenger courtesy/reading lamp
Cleaning the Interior Lamps
Your interior dome lamps and map lamps are
plastic and should be cleaned with a mild
detergent diluted in water. Rinse them with
clear water.ClockThe digital clock
1. To set the hour, press and hold
the hour button. When the desired
hour appears, release the button.
2.To set the minutes, press and hold
the minute button. When the desired
minute appears, release the button.
87

Cellular Phone (If equipped)
For information about the cellular phone in your
vehicle, refer to the Cellular Phone User's
Manual provided with your phone. For further
questions about your Lincoln cellular phone,
contact the Ford Cellular System at 1-800-367-
3013(U.S.). In Canada, please contact your
dealer.
NOTE: It is recommended that you fold your
cellular phone antenna down onto the back glass
before entering a car wash.
88

Steering Column ControlsThe controls on the steering column and wheel
are designed to give you easy access to the
controls while you are driving.
The Turn Signal Lever
You can use the turn signal lever on the left side
of the steering column to: operate the turn signals and cornering lamps turn the high beams on/off flash the lights turn the windshield wipers and washer on/offThe turn signal lever
Turn Signals
Move the lever up to signal a right turn. Move it
down to signal a left turn. The corresponding
indicator light in the instrument cluster will flash.
89

If the turn signal stays on after you turn, move
the lever back to the center (off) position. A
warning chime will sound after approximately
one-half mile (one kilometer) of driving if you do
not return the lever to off.
For lane changes, move the lever far enough to
signal but not to latch. The lever will return to
the off position when you release it.
NOTE: The flash rate of the turn signal will
speed up considerably if the Lighting Control
Module detects a left or right turn lamp bulb
(front or rear) is burned out.
High Beams
To turn on the high beams, turn the headlamp
control switch to the headlamp ON position (or
activate the autolamp feature) and push the turn
signal lever away from you until it latches. When
the high beams are ON, the high beam indicator
light on the instrument cluster comes on.
90To turn off the high beams, pull the lever toward
you until it latches. The high beam indicator
light turns off.
Flashing the Lights
To flash the headlamps, pull the lever toward
you for a moment and then release it. The
headlamps will flash whether the headlamp knob
is in the on or off position.
Windshield Wipers and Washer
To turn on the windshield wipers, the ignition
key must be turned to the ON or ACC position.
Rotate the knob towards "S" to activate the
wipers. The first seven detents are interval wipe
positions, the eighth detent is the LO position
and the ninth detent is the HI position.
To turn the wipers off, turn the knob to the OFF
position.

Variable Interval Wipers
In addition to two speed wipers, your vehicle has
wipers that you can set to operate at varying
intervals. For example, you can set the interval
so they wipe less often when it drizzles or more
often in heavier rain.The windshield wiper on the turn signal leverTo set the interval wipers, turn the -knob at the
end of the turn signal lever between "S" (slow) and
"F" (fast) until the desired interval between wipes
is achieved.
Windshield Washer
To clean the windshield, push in the end of the
wiper knob. For a constant spray, keep the knob
pushed in. After you release the knob, the wipers
operate for two to three cycles before turning off
(if the wipers were OFF) or returning to HI, LO,
or the interval setting selected.
If the washer does not work, check the washer
fluid level and fill it if it is low. See the Servicing
Your Continental chapter. If there is enough fluid,
consult your nearest Ford or Lincoln-Mercury
dealer.
91

Do not try to clean the windshield when the
washer fluid container is empty or activate the
washers at any time for more than 15 seconds
continuously. This could damage the washer
pump system./! WARNINGIn freezing weather, the washer solutionmay freeze on the windshield and obscureyour vision. Always warm up thewindshield with the defroster before youuse the washer fluid. If you cannot seethrough the windshield clearly, it canincrease the risk of being involved in acollision.For information about refilling the washer fluid or
replacing your windshield wiper blades, see
Windshield washer fluid and Wipers in the Index.
92Hazard Flasher
The hazard flasher serves as a warning to other
drivers to be careful when approaching or passing
your vehicle.
The flashers work whether your vehicle is running
or not. The flashers work for up to two hours
when the battery is fully charged and in good
condition without draining the battery excessively.
If the flashers run for longer than two hours or if
the battery is not fully charged, the battery can be
drained.

Steering wheel
The control switch for hazard flashers
Horn
To sound the horn, push the center pad area of
the steering wheel.Press here to sound the horn
The horn on the steering wheel
93