Page 1080 of 2543
COOLING SYSTEM
PREPARATION
SST (SPECIAL SERVICE TOOLS)
09230±01010 Radiator Service Tool Set
09231±14010 Punch2JZ±GE only (Aluminum type)
RECOMMENDED TOOLS
09040±00010 Hexagon Wrench Set
    09082±00050 TOYOTA Electrical Tester Set
09258±00030 Hose Plug Set
EQUIPMENT
 
 
Radiator cap tester 
 
 
 
Heater 
 
Thermostat
ECT switch (2JZ±GTE)
 
Thermometer 
Thermostat
ECT switch (2JZ±GTE)
 
 Torque wrench
 
 
COOLANT
ItemCapacityClassification 
 
 
 
 
 
 Engine coolant (w/ Heater)
2JZ±GE M/T
A/T
2JZ±GTE M/T
A/T
 
7.3 liters (7.7 US qts, 6.4 lmp. qts)
8.3 liters (8.8 US qts, 7.3 lmp. qts)
9.5 liters (10.0 US qts, 8.4 lmp. qts)
9.4 liters (9.9 US qts, 8.3 lmp. qts)
 
 Ethylene±glycol base
± ENGINECOOLING SYSTEMEG±329 
     
        
        Page 1082 of 2543

COOLANT REPLACEMENT
1.  DRAIN ENGINE COOLANT
(a)  Remove the radiator cap.
CAUTION: To avoid the danger of being burned, do not remove
the radiator cap while the engine and radiator are still hot, as
fluid and steam can be blown out under pressure.
(b)  Loosen the 2 drain plugs (for the engine and radiator), and
drain the coolant.
(c)  Close the drain plugs.
Torque:
Engine  drain plug
29 NVm (300 kgfVcm, 22 ftVlbf)
2.  FILL ENGINE COOLANT
(a)  Slowly fill the system with coolant.
wUse a good brand of ethylene±glycol base coolant and
mix it according to the manufacturer's directions.
wUsing coolant which includes more than 50 %
ethylene±glycol (but not more than 70 %) is
recommended.
NOTICE:
wDo not use an alcohol type coolant.
wThe coolant should be mixed with demineralized water or
distilled  water.
Capacity (w/ Heater):
2JZ±GE
M/T
7.3 liters (7.7 US qts, 6.4 lmp. qts)
A/T
8.3 liters (8.8 US qts, 7.3 lmp. qts)
2JZ±GTE
M/T
9.5 liters (10.0 US qts, 8.4 lmp. qts)
A/T
9.4 liters (9.9 US qts, 8.3 lmp. qts)
(b)  Install the radiator cap.
(c)  Start the engine, and bleed the cooling system.
(d)  Refill the reservoir with coolant until it reaches the ºFULLº
line.
3.  CHECK ENGINE COOLANT FOR LEAKS
± ENGINECOOLING SYSTEMEG±331 
     
        
        Page 1138 of 2543
PREPARATION
SST (SPECIAL SERVICE TOOLS)
09240±00020Wire Gauge SetDistributor
RECOMMENDED TOOLS
09082±00050TOYOTA Electrical Tester Set
09200±00010Engine Adjust Kit 
EQUIPMENT
 Megger insulation resistance meter Spark plug
 Spark plug cleaner 
 Thermometer 
COOLANT
 Item Capacity Classification
 
 Engine coolant (W/Heater)          M/T
                                                     A/T 
 7.3 liters (7.7 US qts, 6.4 lmp. qts)
8.3 liters (8.8 US qts, 7.3 lmp. qts) 
 Ethylene±glycol base
± IGNITION SYSTEM2JZ±GEIG±3 
     
        
        Page 1238 of 2543

PREPARATION
RECOMMENDED TOOLS
09200±00010 Engine Adjust Kit.
EQUIPMENT
 Dial indicator Brake disc
 Micrometer Brake disc
 Mirror Brake hose
 Thermometer 
 Torque wrench 
 Vernier calipers Parking brake drum
COOLANT
 Item Capacity Classification 
 Engine coolant              2JZ±GE  M/T
   (w/ Heater)                                A/T7.3 liters (7.7 US qts, 6.4 lmp. qts)
8.3 liters (8.8 US qts, 7.3 lmp. qts)Ethylene±glycol base
 
 
()
                                   2JZ±GTE  M/T
                                                     A/T
(q q)
9.5 liters (10.0 US qts, 8.4 lmp. qts)
9.4 liters (9.9 US qts, 8.3 lmp. qts)
LUBRICANT
 Item Capacity Classification
 
 
Engine oil (Drain and refill)   (2JZ±GE)
   w/ Oil filter change
w/o Oil filter change
5.3 liters (5.6 US qts, 4.7 lmp. qts)
4 9 liters (5 2 US qts 4 3 lmpqts)
API grade SH, Energy±Conserving II
multigrade engine oil or ILSAC multi-
grade engine oil and recommended 
 
   w/o Oil filter change4.9 liters (5.2 US qts, 4.3 lmp. qts)grade engine oil and recommended
viscosity oil, with SAE 5W±30 being
preferred engine oil
 
 Engine oil (Drain and refill) (2JZ±GTE)
   w/ Oil filter change
5.0 liters (5.3 US qts, 4.4 lmp. qts)
API grade SH, Energy±Conserving II
mutigrade engine oil or ILSAC multi-
 
 
g
   w/o Oil filter change
(q q)
4.7 liters (5.0 US qts, 4.1 lmp. qts)
gg
grade engine oil and recommended
viscosity oil
 Manual transmission oil          2JZ±GE2.6 liters (2.7 US qts, 2.3 lmp. qts)API GL±5 SAE 75W±90
  2JZ±GTE
(q, q)
1.8 liters (1.9 US qts, 1.6 lmp. qts)Castle gear oil V160
 Automatic transmission          2JZ±GE1.6 liters (1.7 US qts, 1.4 lmp. qts)ATF DEXRON® II
 fluid (Drain and refill)            2JZ±GTE
(q, q)
1.9 liters (2.0 US qts, 1.7 lmp. qts)ATF TYPE T±II
 
 
Differential oil1.35 liters (1.43 US qts, 1.19 lmp. qts)API GL±5
Above±185 C (05 F)
SAE 90 
 
 
   SAE 90
Below±185 C (05 F)
   SAE 80W±90 or 80W
± MAINTENANCEPREPARATIONMA±5 
     
        
        Page 1241 of 2543

2JZ±GTE:
Oil grade:
API grade SH Energy±Conserving II multigrade engine
oil or ILSAC multigrade engine oil. Recommended
viscosity is given in the following chart.
Drain and refill capacity:
w/ Oil filter change
5.0 liters (5.3 US qts, 4.4 lmp. qts)
w/o Oil filter change
4.7 liters (5.0 US qts, 4.1 lmp. qts)
7.  REPLACE ENGINE COOLANT
(See coolant replacement in Cooling System)
Capacity (w/ Heater):
2JZ±GE
M/T
7.3 liters (7.7 US qts, 6.4 lmp. qts)
A/T
8.3 liters (8.8 US qts, 7.3 lmp. qts)
2JZ±GTE
M/T
9.5 liters (10.0 US qts, 8.4 lmp. qts)
A/T
9.4 liters (9.9 US qts, 8.3 lmp. qts)
HINT:
wUse a good brand of ethylene±glycol base coolant and
mix it according to the manufacturer's directions.
wUsing coolant which includes more than 50%
ethylene±glycol (but not more than 70%) is
recommended.
NOTICE:
wDo not use a alcohol type coolant.
wThe coolant should be mixed with demineralized water or
distilled  water.
8.  INSPECT CHARCOAL CANISTER
(a)  Remove the charcoal canister.
(b)  Visually inspect the canister case.
(c)  Check for crogged each port and stuck check valve.
wUsing low compressed air (4.71 kPa (48 gf/cm2, 0.68
psi)), blow into port C and check that air flows without
resistance from the other ports. MA±8
± MAINTENANCEMAINTENANCE OPERATIONS 
     
        
        Page 1478 of 2543
09843±18020 Diagnostic Check Wire
09990±01000Engine Control Computer Check
Harness ªAº
RECOMMENDED TOOLS
09082±00050 TOYOTA Electrical Tester Set
09200±00010Engine Adjust Kit
09258±00030 Hose Plug SetPlug for vacuum hose, fuel
hose etc.
EQUIPMENT
 Carburetor cleaner 
 
 Graduated cylinder 
 Injector
 Soft brush 
 Sound scope Injector
 Tachometer 
 Torque wrench 
 
 Vacuum gauge
 
 
COOLANT 
 Item
 
 Capacity
 
 Classification
 
 
Engine coolant (w/ Heater)       M/T
A/T 
 
7.3 liters (7.7 US qts, 6.4 lmp. qts)
8.3 liters (8.8 US qts, 7.3 lmp. qts) 
 
 Ethylene±glycol base
EG±188± ENGINESFI SYSTEMS (2JZ±GE) 
     
        
        Page 1549 of 2543
09990±01000Engine Control Computer Check
Harness ªAº
RECOMMENDED TOOLS
09082±00050 TOYOTA Electrical Tester Set
09200±00010Engine Adjust Kit
09258±00030 Hose Plug SetPlug for vacuum hose, fuel
hose etc.
EQUIPMENT
 
 Carburetor cleaner
 
 
 
 Graduated cylinder 
 Injector
 
 
Soft brush 
 
 
 
Sound scope 
 
Injector
 Tachometer 
 
 Torque wrench
 
 
 
 Vacuum gauge 
 
COOLANT
 Item Capacity Classification 
 Engine coolant (w/ Heater)         M/T
A/T 
 9.5 liters (10.0 US qts, 8.4 lmp. qts)
9.4 liters (9.9 US qts, 8.3 lmp. qts) 
 Ethylene±glycol base
± ENGINESFI SYSTEM (2JZ±GTE)EG±259 
     
        
        Page 2107 of 2543
TURBOCHARGER SYSTEM (2JZ±GTE)
PREPARATION
SST (SPECIAL SERVICE TOOLS)
09992±00241 Turbocharger Pressure Gauge
EQUIPMENT
 
 
Dial indicator 
 
Impeller wheel
 
 
Torque wrench 
 
COOLANT
 Item Capacity Classification
 
 Engine coolant (w/ Heater)                    M/T
A/T 
  9.5 liters (10.0 US qts. 8.4 lmp. qts)
 9.4 liters (9.9 US qts, 8.3 lmp. qts) 
 Ethylene±glycol base
EG±140± ENGINETURBOCHARGER SYSTEM (2JZ±GTE)