1995 TOYOTA SUPRA torque

INTRODUCTIONGENERAL REPAIR INSTRUCTIONS -
IN-5
the specified seal lock adhesive to the bolt, nut or
threads.
(c) Precoated parts are indicated in the component il-
lustrations by the º
º symbol.
7. When necessary, use a sealer on gaskets to prevent
leaks.
8. Carefully observe all specifications for bolt tightening
torques. Always use a torque wrench.
9. Use of special service tools (SST) and special service ma-
terials (SSM) may be required, depending on the nature
of the repair. Be sure to use SST and SSM where speci-
fied and follow the proper work procedure. A list of SST
and SSM can be found at the preparation of AT section.
10. When replacing fuses, be sure the new fuse has the cor-
rect amperage rating. DO NOT exceed the rating or use
one with a lower rating.
11. To pull apart electrical connectors, pull on the connector
itself, not the wires.
12. Care must be taken when jacking up and supporting the
vehicle. Be sure to lift and support the vehicle at the prop-
er locations.
(a) If the vehicle is to be jacked up only at the front or
rear end, be sure to block the wheels at the opposite
end in order to ensure safety.
(b) After the vehicle is jacked up, be sure to support it on
stands. It is extremely dangerous to do any work on
a vehicle raised on a jack alone, even for a small job
that can be finished quickly.

INTRODUCTIONGLOSSARY OF SAE AND TOYOTA TERMS -
IN-8
IACIdle Air ControlIdle Speed Control (ISC)
IATIntake Air TemperatureIntake or Inlet Air Temperature
ICMIgnition Control Module-
IFIIndirect Fuel InjectionIndirect Injection
IFSInertia Fuel-Shutoff-
ISCIdle Speed Control-
KSKnock SensorKnock Sensor
MAFMass Air FlowAir Flow Meter
MAPManifold Absolute PressureManifold Pressure
Intake Vacuum
MCMixture Control
Electric Bleed Air Control Valve (EBCV)
Mixture Control Valve (MCV)
Electric Air Control Valve (EACV)
MDPManifold Differential Pressure-
MFIMultiport Fuel InjectionElectronic Fuel Injection (EFI)
MILMalfunction Indicator LampCheck Engine Light
MSTManifold Surface Temperature-
MVZManifold Vacuum Zone-
NVRAMNon-V olatile Random Access Memory-
O2SOxygen SensorOxygen Sensor, O2 Sensor (O2S)
OBDOn-Board DiagnosticOn-Board Diagnostic (OBD)
OCOxidation Catalytic ConverterOxidation Catalyst Converter (OC), CCo
OPOpen LoopOpen Loop
PAIRPulsed Secondary Air InjectionAir Suction (AS)
PCMPowertrain Control Module-
PNPPark/Neutral Position-
PROMProgrammable Read Only Memory-
PSPPower Steering Pressure-
PTOXPeriodic Trap OxidizerDiesel Particulate Filter (DPF)
Diesel Particulate Trap (DPT)
RAMRandom Access MemoryRandom Access Memory (RAM)
RMRelay Module-
ROMRead Only MemoryRead Only Memory (ROM)
RPMEngine SpeedEngine Speed
SCSuperchargerSupercharger
SCBSupercharger Bypass-
SFISequential Multiport Fuel InjectionElectronic Fuel Injection (EFI), Sequential Injection
SPLSmoke Puff Limiter-
SRIService Reminder Indicator-
SRTSystem Readiness Test-
STScan Tool-
TBThrottle BodyThrottle Body
TBIThrottle Body Fuel InjectionSingle Point Injection
Central Fuel Injection (Ci)
TCTurbochargerTurbocharger
TCCTorque Converter ClutchTorque Converter
TCMTransmission Control ModuleTransmission ECU (Electronic Control Unit)
TPThrottle PositionThrottle Position
TRTransmission Range-

A340E (2JZ-GTE) AUTOMATIC TRANSMISSIONPREPARATION -
AT-12
EQUIPMENT
Feeler gaugeCheck major clearance.
Vernier calipersCheck length of second coast
brake piston rod.
Dial indicator or dial indicator with magnetic baseCheck piston stroke and play of
the output shaft.
Dial indicatorCheck inside diameter of major
bushing.
Straight edgeCheck side clearance of oil pump.
Torque wrench
Cylinder gaugeCheck inside diameter of the
transmission case rear bushing.
Ohmmeter
Voltmeter
Ammeter(A)
LUBRICANT
ItemCapacityClassification
Dry fill
Drain and refill8.2 liters (8.7 US qts, 7.2 Imp. qts)
1.9 liters (2.0 US qts, 1.7 Imp. qts)ATF Type T-II or equivalent
SSM (SPECIAL SERVICE MATERIALS)
08826-00090Seal Packing 1281,
THREE BOND 1281 or equivalent
(FIPG)Oil pan
08833-00070Adhesive 1324,
THREE BOND 1324 or equivalentTorque converter clutch housing
Extension housing
PNP switch
AT0D8-03
AT0D9-02
AT0DA-05

A340E(Others) AUTOMATIC TRANSMISSIONPREPARATION -
AT-14
09350-36010TOYOTA Automatic Transmission
Tool Set
(09350-06090)Plate
09610-20012Pitman Arm PullerRemove oil pump.
RECOMMENDED TOOLS
09031-00030Pin Punch .
EQUIPMENT
Feeler gaugeCheck major clearance.
Vernier calipersCheck length of second coast
brake piston rod.
Dial indicator or dial indicator with magnetic baseCheck piston stroke and end play
of the output shaft.
Dial indicator with magnetic baseCheck inside diameter of major
bushing.
Straight edgeCheck side clearance of oil pump.
Torque wrench
Cylinder gaugeCheck inside diameter of the
transmission case rear bushing.
LUBRICANT
ItemCapacityClassification
Dry fill
Drain and refill7.2 liters (7.6 US qts, 6.3 Imp. qts)
1.6 liters (1.7 US qts, 1.4 lmp. qts)DEXRON® II
SSM (SPECIAL SERVICE MATERIALS)
08826-00090Seal Packing 1281,
THREE BOND 1281 or equivalent
(FIPG)Oil pan
AT054-03
AT055-03
AT056-09
AT057-05

INTRODUCTIONSTANDARD BOLT TORQUE SPECIFICATIONS -
IN-20
STANDARD BOLT TORQUE SPECIFICATIONS
IN008-02

INTRODUCTIONSTANDARD BOLT TORQUE SPECIFICATIONS -
IN-21

A340E (2JZ-GTE) AUTOMATIC TRANSMISSIONSERVICE SPECIFICATIONS -
AT-26
TORQUE SPECIFICATIONS
Part tightenedN´mkgf´cmft´lbf
Engine x Transmissin6465047
Rear support member x Body2526019
Transmission housing x Transmisson case 14 mm
17 mm34
57345
58025
42
Extension housing x Transmission case3434525
Packing lock pawl bracket77565 in.´lbf
O/D support x Transmission case2526019
Oil pump x Transmission case2121516
Oil pump body x Stator shaft101007
Valve body x Transmission case101007
Upper valve body x Lower valve body6.56556 in.´lbf
Detent spring101007
Oil strainer101007
Oil pan77565 in.´lbf
No. 1 Vehicle speed sensor1616012
No. 2 Vehicle speed sensor5.45548 in.´lbf
Solenoid wiring stopper plate5.45548 in.´lbf
O/D direct clutch vehicle speed sensor5.45548 in.´lbf
Transmission output flange123125090
Throttle cable x Transmission case5.45548 in.´lbf
Union2930022
Cooler pipe union nut3435025
Park/Neutral position switch Bolt
Nut13
6.9130
709
61 in.´lbf
Control shaft lever1616012
AT0F1-05

A340E(Others) AUTOMATIC TRANSMISSIONSERVICE SPECIFICATIONS -
AT-32
TORQUE SPECIFICATION
Part tightenedN´mkgf´cmft´lbf
Stator shaft x Oil pump body101007
Upper valve body x Lower valve body6.46556 in.´lbf
Detent spring x Valve body101007
Parking lock pawl bracket7.47565 in.´lbf
Overdrive support x Transmission case2526019
Oil pump x Transmission case2222016
Valve body x Transmission case101007
Oil strainer x Valve body101007
Solenoid x Valve body101007
Oil pan x Transmission case7.47565 in.´lbf
Extension housing x Transmission case3637027
Transmission housing 10 mm bolt
12 mm bolt34
57345
58025
42
Union2930022
Vehicle speed sensor1616012
Park/Neutral position switch6.97061 in.´lbf
Park/Neutral position switch adjusting bolt131309
Control shaft lever1616012
AT06Q-0E