1993 CHEVROLET PLYMOUTH ACCLAIM belt

[x] Cancel search: belt

Page 1932 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual (10) Connect negative cable back on negative post 
of battery.  (11) Start engine and turn steering wheel several
times from stop to stop to bleed air from fluid in sys-
tem. Stop engine, check fluid

Page 1933 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual (12) Transfer Required parts to the new power 
steering pump assembly before installing in vehicle. 
INSTALL 
(1) Install the power steering pump assembly back 
in vehicle in reverse order of removal.

Page 1934 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual (15) Start engine and turn steering wheel several 
times from stop to stop to bleed air from fluid in sys-
tem. Stop engine, check fluid level, and inspect sys-
tem for leaks. See Checking Fluid Level

Page 1935 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual (12) Remove nut and bolt attaching the generator/ 
power steering pump bracket, support strut (Fig. 16). (13) Lower vehicle.
(14) Remove the 2 bolts holding the power steering 
fluid reservoir to the

Page 1936 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual INSTALL (1) Install power steering pump back in vehicle, 
laying it on the steering gear. Do not mount it to the
power steering pump bracket. (2) Install generator back on the lower generator
bracket

Page 1937 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual (18) Lower vehicle. 
(19) Install the serpentine drive belt. Refer to (Fig.
10) for correct serpentine belt routing. See Cooling,
Group 7 for detailed installation procedure. 
CAUTION: Do not use auto

Page 1938 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual INSTALL (1) Install the power steering pump back into the 
vehicle in the reverse order of removal, between cyl-
inder head and dash panel (Fig. 20). (2) Install the wiring harness connector back on
t

Page 1939 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual With Serpentine Belts; Run engine until warm (5 
min.) and note any belt chirp. If chirp exists, move
pulley outward approximately 0.5 mm (0.020 in.). If
noise increases, press on 1.0mm (0.040 in.).